Sony NSZ-GT1 User Manual 3

Internet TV

Reference Guide

NSZ-GT1

WARNING

To reduce the risk of fire or electric shock,
do not expose this apparatus to rain or
moisture.

The AC power cord must be changed only
at a qualified service shop.

Batteries or batteries installed apparatus
shall not be exposed to excessive heat
such as sunshine, fire or the like.

CAUTION

The use of optical instruments with this
product will increase eye hazard. As the
laser beam used in this Internet TV Box is
harmful to eyes, do not attempt to
disassemble the cabinet. Refer servicing
to qualified personnel only.

This label is located on the laser protective
housing inside the enclosure.

This symbol is intend ed to alert
the user to the presence of
uninsulated “dangerous
voltage” within the product’s

sufficient magnitude to constitute a risk of
electric shock to persons.

enclosure that may be of

NOTE

This equipment ha s been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in
a particular installation. If this equipment
does cause harmful inte rference to radio or
television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:

– Reorient or relocate the receiving

antenna.

– Increase the separation between the

equipment and receiver.

– Connect the equipment into an outlet on

a circuit different from that to which the
receiver is connected.

– Consult the dealer or an experienced

radio/TV technician for help.

Precautions

• To prevent fire or shock hazard, do not
place objects filled with liquids, such as
vases, on the apparatus.

• The set is not disconnected from the AC
power source (mains) as long as it is
connected to the wall outlet, even if the
set itself has been turned off.

• Install this unit so that the AC power cord
can be unplugged from the wall socket
immediately in the event of trouble.

• The nameplate is located on the bottom
of the unit.

Installing

• Do not install this equipment in a
confined space, such as a bookshelf or
similar unit.

FCC WARNING

You are cautioned that any changes or
modifications not expressly approved in
this manual could void your authority to
operate this equipment.

This transmitter must not be co-located or
operated in conjunction with any other
antenna or transmitter.

The shielded Interface cable must be used
with the equipment in order to comply with
the limits for a digital device pursuant to
Subpart B of Part 15 of FCC Rules.

FCC Radiation Exposure
Statement:

This equipment complies with FCC
radiation exposure limits set forth for
uncontrolled equipment and meets the
FCC radio frequency (RF) Exposure
Guidelines in Supplement C to OET65. This
equipment should be installed and
operated with at least 20 cm and more
between the radiator and person's body
(excluding extremities: hands, wrists, feet
and ankles).

This device is restrict ed to indoor use when
operated in the 5.15 to 5.25 GHz frequency
range.

This product contains FCC ID: GT3FC009

Owner's Record

The model and serial numbers are located
at the bottom of the unit. Record the serial
number in the space provided below.
Refer to them whenever you call upon your
Sony dealer regarding this product.

Model No.______________

Serial No.______________

For Customers in the USA

If this product is not working properly,
please call 1-800-222-7669.

This symbol is intend ed to alert
the user to the presence of
important operating and
maintenance (servicing)

accompanying the appliance.

These graphical symbols are located on
the AC adapter.

instructions in the literature

2

Operation is subject to the following two
conditions;
(1) this device may not cause

interference, and

(2) this device must accept any

interference received,
including interference that may cause
undesired operation of the device.

Important Safety
Instructions

1) Read these instructions.

2) Keep these instructions.

3) Heed all warnings.

4) Follow all instructions.

5) Do not use this apparatus near
water.

6) Clean only with dry cloth.

7) Do not block any ventilation
openings. Install in accordance with
the manufacturer’s instructions.

8) Do not install near any heat sources
such as radiators, heat registers,
stoves, or ot her apparatus (incl uding
amplifiers) that produce heat.

9) Do not defeat the safety purpose of
the polarized or grounding-type
plug. A polarized plug has two
blades with one wider than the other.
A grounding type plug has two
blades and a third grounding prong.
The wide blade or the third prong are
provided for your safety. If the
provided plug does not fit into your
outlet, consult an electrician for
replacement of the obsolete outlet.

10)Protect the power cord from being
walked on or pinched particularly at
plugs, convenience receptacles,
and the point where they exit from
the apparatus.

11)Only use attachments/accessories
specified by the manufacturer.

12)Use only with the cart, stand, tripod,
bracket, or table specified by the
manufacturer, or sold with the
apparatus. When a cart is used, use
caution when moving the cart/
apparatus combination to avoid
injury from tip-over.

13)Unplug this apparatus during
lightning storms or when unused for
long periods of time.

14)Refer all servicing to qualified
service personnel. Servicing is
required when the apparatus has
been damaged in any way, such as
power-supply cord or plug is
damaged, liquid has been spilled or
objects have fallen into the
apparatus, the apparatus has been
exposed to rain or moisture, does
not operate normally, or has been
dropped.

Precautions

On placement

• Place the unit in a location with
adequate ventilation to prevent heat
build-up in the unit.

• Do not place the unit on a soft surface
such as a rug that might block the
ventilation holes.

• Do not place the unit and AC adapter
in a location near heat sources, or in a
place subject to direct sunlight,
excessive dust, or mechanical shock.

• Do not place the unit outdoors, in
vehicles, on ships, or on other vessels.

• If the unit is brought directly from a
cold to a warm location, or is placed in
a very damp room, moisture may
condense on the lenses inside the
unit. Should this occur, the unit may
not operate properly. In this case,
remove the disc and leave the unit
turned on for about half an hour until
the moisture evaporates.

• Do not install the unit in an inclined
position. It is designed to be operated
in a horizontal position only.

• Do not place metal objects in front or
on the left side of the unit. It may limit
reception of radio waves.

• Do not place the unit in a place where
medical equipment is in use. It may
cause a malfunction of medical
instruments.

• If you use a pacemaker or other
medical device, consult your
physician or the manufacturer of your
medical device before using the
wireless LAN function.

• Do not place heavy or unstable
objects on the unit.

• Do not insert any objects other than
discs inside the disc slot. Doing so
may cause damage to the unit or the
object.

• Take out any discs when you move the
unit. If you don’t, the disc may be
damaged.

• Disconnect the AC power cord and all
other cables from the unit when you
move the unit.

• During operation the AC adapter has
to be placed on a surface with LED
side up and label side down.

3