To prevent fire or shock hazard, do
not expose the unit to rain or
moisture.
To avoid electrical shock, do not
open the cabinet. Refer servicing to
qualified personnel only.
Do not install the appliance in a
confined space, such as a bookcase or
built-in cabinet.
Caution
The use of optical instruments with this
product will increase eye hazard.
Listening for many hours at maximum
volume may damage your hearing.
CAUTION — INVISIBLE LASER
RADIATION WHEN OPEN
AVOID EXPOSURE TO BEAM
Information
IN NO EVENT SHALL SELLER BE
LIABLE FOR ANY DIRECT,
INCIDENTAL OR
CONSEQUENTIAL DAMAGES OF
ANY NATURE, OR LOSSES OR
EXPENSES RESULTING FROM
ANY DEFECTIVE PRODUCT OR
THE USE OF ANY PRODUCT.
For customers in the USA
Owner’s Record
The serial number is located at the rear of
the disc compartment lid and the model
number is located at the top and bottom.
Record the serial number in the space
provided below. Refer to them whenever
you call upon your Sony dealer regarding
this product.
Model No.
Serial No.
2-GB
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the
interference by one or more of the
following measures:
— Reorient or relocate the receiving
antenna.
— Increase the separation between the
equipment and receiver.
— Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced
radio/TV technician for help.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
You are cautioned that any changes or
modifications not expressly approved in
this manual could void your authority to
operate this equipment.
For customers in Canada
To prevent electric shock, do not use this
polarized AC plug with an extension cord,
receptacle or other outlet unless the
blades can be fully inserted to prevent
blade exposure.
The CE mark on the unit is
valid only for products
marketed in the European
Union.
Certain countries may regulate disposal of
battery used to power this product.
Please consult with your local authority.
WALKMAN and are trademarks
of Sony Corporation.
GB
3-GB
Table of contents
Looking at the controls ....................................6
Getting started ................................................. 8
Recording an MD right away! .........................10
Playing an MD right away! .............................. 13
Various ways of recording .............................. 15
Two ways of connecting to a sound source ..........................................15
Recording with analog input (line cable required) ...............................16
Recording for long times ......................................................................16
To start/stop recording in sync with the source player
What is an MD? ................................................................................... 38
5-GB
Looking at the controls
See pages in ( ) for more details.
The recorder
A
H
B
C
D
E
F
G
A N button (11) (13) (17) (24)
B VOL +/– buttons (13) (28)
C x button (11) (13) (25) (28)
D X button (11) (13) (19) (26) (28)
E HOLD switch (at the rear) (9) (23)
F >MENU. buttons (16) (21)
H OPEN switch (9)
I Display window (18) (21)
J END SEARCH button (11) (28)
K T MARK button (26)
REC (record) button (11) (17)
L i (headphones) jack (9) (24)
M Battery compartment (at the rear) (8)
N LINE IN (OPTICAL) jack (10) (16)
O DC IN 3V jack (10) (30)
6-GB
The display window
AB
C
D
LP2.4
JI
A MONO (monaural) indication
B LP mode indication (17)
C Disc indication
Shows that the disc is rotating for
recording, playing or editing an MD
D Mega bass indication (22).
E REC indication
Lights up while recording. When
flashing, the recorder is in record
standby mode.
F SYNC (synchro-recording) indication
(18)
G Level meter (19)
Shows the volume of the MD being
played or recorded.
H REC REMAIN/REMAIN (remaining
time/tracks) indication (20) (23)
Lights up along with the remaining
time of the track, the remaining time
of the MD, or the remaining number
of tracks.
I Battery indication (9)
Shows approximate battery condition.
J Time display
K Disc name/track name indication
Lights up when labeling a disc or a
track.
FG
E
H
Digital MEGA BASS
LMK
L Character information display (20)
(23)
Displays the disc and track names,
error messages, track numbers, etc.
M Play mode indication (21)
Shows the play mode of the MD.
7-GB
Getting started
1
Using on a house current.
Connect the supplied AC power
adaptor
(when an AC power adaptor is not
supplied).
Battery life
LR6 (SG) alkaline dry battery
Recording
Playback364248
1)
2)
3)
4)
Insert an alkaline dry battery.
E
e
Slide to open the battery
compartment lid.
*
or the optional AC-E30HG
∗ Supplied with the European,
Chinese and Argentine models
only.
1)
4)
The battery life may be shorter due to operating conditions, the temperature of the location, and
varieties of batteries.
Measured value by the standard of JEITA (Japan Electronics and Information Technology Industries
Association).
When using a Sony LR6 (SG) “STAMINA” alkaline dry battery (produced in Japan).
To prevent interrupted recording due to drained battery, use new battey for recording operations.
Insert an LR6 (size AA)
alkaline dry battery minus
end first.
3)
NormalLP2LP4
7.51013.5
Close the lid.
To D C IN 3V
(Unit: Approx. hours) (JEITA2))
8-GB
When to replace the battery
When the dry battery is weak, flashing r or “LoBATT” appears in the display. Replace
the dry battery.
Note that the battery level indicated by the battery indication is only approximate and
varies with the recorder condition.
Note
Stop the recorder before replacing battery.
2
3
Connect the headphones/
earphones and unlock the control.
HOLD
headphones/earphones
(supplied)
Connect firmly
To i
Insert an MD.
Insert an recordable MD when recording.
1 Slide OPEN to open the lid.2 Insert an MD with the label side facing
front, and press the lid down to close.
9-GB
Recording an MD right away!
Connect to a digital source using an optical cable (supplied with the
European, Chinese and Argentine models only) to make digital
recordings. Digital recording is possible even from digital equipment
with different sampling rates, such as a DAT deck or a BS tuner, using
the built-in sampling rate converter. To record from an analog source,
see “Recording with analog input (line cable required)” (page 16). To
record from an MD, see “Note on digital recording” (page 31).
1
to a wall
outlet
Make connections.
(Insert the cables
firmly and completely into the appropriate jacks.)
CD player, MD
player, digital
amplifier, etc.
AC power adaptor
1)
Supplied with the European, Chinese and Argentine models only.
2)
Supplied with the European and Argentine models only.
3)
Supplied with the Chinese model only.
1)
Optical cable
to DC IN 3V
to DIGITAL OUT (OPTICAL)
Optical plug
2)
to LINE IN (OPTICAL)
Portable CD
player, etc.
Optical mini-plug
Optical cable
3)
10-GB
2
Record an MD.
x
N
REC
1 Press N while pressing REC.
Recording starts.
2 Play the source you want to record.
To stop recording, press x.
After you press x and “Edit” stops
flashing in the display, the recorder will
automatically turn off after:
— about 10 seconds when using a
battery.
— about 5 minutes when using the
supplied AC power adaptor or the
optional AC-E30HG (when an AC
power adaptor is not supplied).
Notes
• “Saving” or “Edit” flashes while data of the recording (the track’s start and end points, etc.) is being
recorded. Do not move or jog the recorder or disconnect the power source while the indication is
flashing in the display.
• The lid does not open until “Edit” disappears in the display.
ToPress
Record from the end of the
previous recording
Record partway through the
previous recording
1)
1)
END SEARCH and press N while pressing REC.
N, > or . to find the start point of
recording and press x to stop. Then press N
while pressing REC.
PauseX
2)
Press X again to resume recording.
Remove the MDx and open the lid.
3)
(The lid does not open while
“Edit” flashing in the display.)
1)
By setting “R-Posi” to “Fr End”, recording operations will always start from the end of the
previousely recorded material (page 18).
2)
A track mark is added at the point where you press X again to resume recording while pausing; thus
the remainder of the track will be counted as a new track.
3)
If you open the lid while “R-Posi” is set to “FrHere,” recording will begin with the first track the next
time you record (page 18).
11-GB
If the recording does not start
• Make sure the recorder is not locked
(page 23).
• Make sure the MD is not record-protected
(page 31).
• Premastered MDs cannot be recorded over.
For models supplied with the AC plug
adaptor
If the AC power adaptor (supplied with the
European, Chinese and Argentine models only)
does not fit the wall outlet, use the AC plug
adaptor.
Notes
• If the power supply is disrupted (i.e. the
battery is removed or becomes exhausted or
the AC power adaptor is disconnected) during
a recording or editing operation, or while
“Edit” appears in the display, then it will not
be possible to open the lid until power is
restored.
• You can make a digital recording only from an
optical type output.
• When recording from a portable CD player,
set the CD player to pause, and then do the
recording procedure on the recorder.
• Note the following when recording from a
portable CD player:
—Some portable CD players may not be
capable of digital out unless powered by the
AC power.
—Connect the AC power adaptor to the
portable CD player and use it on AC power
as the power source.
—Disable any anti-skip function (such as
ESP*) on the portable CD player.
∗ Electronic Shock Protection
z
• LINE IN (OPTICAL) jack is for both digital
and analog input. The recorder automatically
recognizes the type of line cable and switches
to digital or analog input.
• The level of the recorded sound is adjusted
automatically.
• You can monitor the sound during recording.
Connect the supplied headphones/earphones
to i and adjust the volume by pressing VOL
+/–. This does not affect the recording level.
12-GB
Loading...
+ 28 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.