Sony DMX-NV1 User Manual

DMX-NV1

Attachment Guide

For TV Models: KDL-40WL140/KDL-46WL140/KDL-52WL140

Required Items for Assembly

Your Sony TV with XMB™ (1) / BRAVIA® Internet Video Link (DMX-NV1) (1)/ Cable Cover (1)/ Mounting
Bracket (1)/ Plastic Fastener (2)/ Mounting Knob (2)/ Phillips Screwdriver (for removal only; not supplied)

To Begin

On the back of the TV, locate the attachment holes situated on the right side, above the rear input panel.

These instructions are shown without cables attached. We recommend that you familiarize yourself with the attachment
process, then review the BRAVIA Internet Video Link’s Quick Setup Guide (supplied) for information on connecting
the cables.

1 Align the holes on the bracket (supplied) to the holes

on the back of your TV.

Plastic Fasteners

2 Insert the 2 Plastic Fasteners (supplied) into the holes,

then press in the head of the fasteners using your
finger until they click.

~

Do not push in the head of the fastener until you have
inserted the fastener into the bracket and the hole on the
TV. Do not use a screwdriver to tighten the screws.

© Sony Corporation 2008

4-116-032-11(1)

Printed in U.S.A.

3 Insert the Mounting Knobs into the threaded holes

1

NETWORK

INPUT

RESET

VIDEO

L

(MONO)

AUDIO

R

VIDEO IN

IN

2

2

and lightly twist by hand. Do not fully tighten the
Mounting Knobs.

4 Place the bottom Mounting Knob into the hole on the

bracket, leaving the top Mounting Knob sitting above
the top hole.

Cables thread out on this side

5 Push down the receiver so both Mounting Knobs

are locked into the grooves, then fully tighten the
Mounting Knobs by hand.

LED Lights

To Remove the Mounting Bracket

Follow the steps in reverse order. Use a Phillips
Screwdriver to remove the Plastic Fasteners.

~

Make sure that the cables are organized with the Cable
Cover so that the cables hang out on the same side as the
Mounting Knobs.