Sony DDA 1001 User Manual

	Only	Bluetooth™ Handsfree
	Only	HBH-200
	Ericsson Internal Use	HBH-200
	Ericsson Internal Use
	For internal use only
	forDraftSony
	Version: PA7

Buttons

Performance range

Optimal performance

Limited performance

HBH-200 Bluetooth™ Handsfree

User’s Guide

FCC statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Sony Ericsson HBH-200

First edition (July 2003)

This manual is published by Sony Ericsson Mobile Communications AB, without any warranty. Improvements and changes to this manual necessitated by typographical errors, inaccuracies of current information, or improvements to programs and/or equipment, may be made by Sony Ericsson Mobile Communications AB at any time and without notice. Such changes will, however, be incorporated into new editions of this manual.

©Sony Ericsson Mobile Communications AB, 2003

Publication number: LZT 108 6336 R1A

Some of the services in this manual are not supported by all networks. This also applies to the GSM International Emergency Number 112. Contact your network operator or service provider if you are in doubt whether you can use a particular service or not.

The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Sony Ericsson is under license.

Introduction

HBH-200 Handsfree

The HBH-200 Handsfree can be connected to any device with Bluetooth wireless technology that supports the handsfree or headset profiles. This user’s guide focuses on usage with a Sony Ericsson mobile phone.

HBH-200 Handsfree

Attach and wear Attach and wear Attach and wear Attach and wear

Icons

Battery status

Bluetooth on

Bluetooth connection

Silent

Ongoing call (flashing when connecting)

Missed or rejected call

Answered call

Dialled number

Symbols

Press and hold

Go to standby and On/Off

Simultaneous press

Getting started

Charge the battery Charge the battery Charge the battery Charge the battery

Chargers

CLA-11

CST-13

Calling

The name of the latest added phone will appear in the display when you turn the handsfree on.

Add the handsfree to the phone

Off

You can always press to turn the handsfree off, even if you are using the menus, call list or other functions.

Prepare the phone

When you add the handsfree to the list of devices in the phone (also called pairing), the handsfree will recognize the phone automatically when it is turned on.

Prepare your phone according to the phone’s user documentation on adding a Bluetooth device. The handsfree passkey is 0000.

You only need to add the handsfree to the phone once. If you want to use the handsfree with a new device you need to add it to that device.

Prepare the phone

When you add the handsfree to the list of devices in the phone (also called pairing), the handsfree will recognize the phone automatically when it is turned on.

Prepare your phone according to the phone’s user documentation on adding a Bluetooth device. The handsfree passkey is 0000.

You only need to add the handsfree to the phone once. If you want to use the handsfree with a new device you need to add it to that device.

Call list

The HBH-200 supports the call list in the phone, and icons indicate dialled, answered or missed calls in the display. For more information, refer to the phone’s user documentation. The call list function works with a number of phones, please see page 33 for details.

Prepare the phone

When you add the handsfree to the list of devices in the phone (also called pairing), the handsfree will recognize the phone automatically when it is turned on.

Prepare your phone according to the phone’s user documentation on adding a Bluetooth device. The handsfree passkey is 0000.

You only need to add the handsfree to the phone once. If you want to use the handsfree with a new device you need to add it to that device.

Prepare the phone

When you add the handsfree to the list of devices in the phone (also called pairing), the handsfree will recognize the phone automatically when it is turned on.

Prepare your phone according to the phone’s user documentation on adding a Bluetooth device. The handsfree passkey is 0000.

You only need to add the handsfree to the phone once. If you want to use the handsfree with a new device you need to add it to that device.

Access the call list

Handsfree successfully added

The handsfree is now added to the phone and is ready to use.

www.SonyEricsson.com

Sony Ericsson Mobile Communications AB

SE-221 88 Lund, Sweden

LZT 1086336

Printed in Hungary

Make a call using the call list

Reject an incoming call

Press to reset the missed call icon. If the call list is supported, you will then enter the call list.

Make a master reset

Make a call using the phone’s keypad Make a call using the phone’s keypad Make a call using the phone’s keypad Make a call using the phone’s keypad

Settings

Adjust the earpiece volume

Transfer sound from phone to headset Transfer sound from phone to headset Transfer sound from phone to headset Transfer sound from phone to headset

Voice commands

Voice commands, such as dial, redial, answer and reject, can be very useful when you are using the handsfree. For more information on voice commands, refer to the phone’s user documentation.

Make a call using voice dialling					Answer a call
Make a call using voice dialling					Answer a call
Make a call using voice dialling					Answer a call
Make a call using voice dialling					Answer a call

When voice dialling is activated, you can voice dial as you normally would with your phone.

When voice dialling is activated, you can voice dial as you	Tip: You can always use	to answer and end a call.
When voice dialling is activated, you can voice dial as you
normally would with your phone.	Tip: You can always use	to answer and end a call.

Mute the microphone

Adjust the ring volume

Select ring signal

Mute the microphone

Adjust the ring volume

Select ring signal

Mute the microphone

Adjust the ring volume

Select ring signal

Mute the microphone

Adjust the ring volume

Select ring signal

End a call

Tip: You can always use	to answer and end a call.
Tip: You can always use	to answer and end a call.

Add HBH-200 to a new phone

Troubleshooting

Not in range

The handsfree and the phone might not be within range of each other. See page 7.

Not in range

The handsfree and the phone might not be within range of each other. See page 7.

Not in range

The handsfree and the phone might not be within range of each other. See page 7.

Not in range

The handsfree and the phone might not be within range of each other. See page 7.

No connection to phone

Make sure that the handsfree is charged and within range of the phone. The settings in the phone may not be

correct. Check or redo the settings in the phone for adding a Bluetooth device.

No connection to phone

Make sure that the handsfree is charged and within range of the phone. The settings in the phone may not be

correct. Check or redo the settings in the phone for adding a Bluetooth device.

No connection to phone

Make sure that the handsfree is charged and within range of the phone. The settings in the phone may not be

correct. Check or redo the settings in the phone for adding a Bluetooth device.

No connection to phone

Make sure that the handsfree is charged and within range of the phone. The settings in the phone may not be

correct. Check or redo the settings in the phone for adding a Bluetooth device.

Technical data

•Bluetooth specification 1.1

•Handsfree profile

•Headset profile (no caller identification.)

•Talk time up to: 3 hours

•Standy time up to: 85 hours

•Range up to: 10 metres

•Call list function: T610, T616, T618, T68i, T68, T39, R520

Technical data

•Bluetooth specification 1.1

•Handsfree profile

•Headset profile (no caller identification.)

•Talk time up to: 3 hours

•Standy time up to: 85 hours

•Range up to: 10 metres

•Call list function: T610, T616, T618, T68i, T68, T39, R520

Technical data

•Bluetooth specification 1.1

•Handsfree profile

•Headset profile (no caller identification.)

•Talk time up to: 3 hours

•Standy time up to: 85 hours

•Range up to: 10 metres

•Call list function: T610, T616, T618, T68i, T68, T39, R520

Technical data

•Bluetooth specification 1.1

•Handsfree profile

•Headset profile (no caller identification.)

•Talk time up to: 3 hours

•Standy time up to: 85 hours

•Range up to: 10 metres

•Call list function: T610, T616, T618, T68i, T68, T39, R520

Declaration of conformity

We, Sony Ericsson Mobile Communications AB of

Nya Vattentornet

221 88 Lund, Sweden

declare under our sole responsibility that our product

Sony Ericsson type DDA-0001001

to which this declaration relates is in conformity with the appropriate standards EN 300 328, EN 301 489-17,

EN 301 489-7 and EN 60950 following the provisions of Radio Equipment and Telecommunication Equipment directive 1995/5/EC with requirements covering EMC directive 89/336/EEC and Low Voltage directive 73/23/ EEC.

Lund, July 2003

0682

Ulf Persson, Head of Product Business Unit Accessories

For internal use only

Version: PA7