Sony CFD-ZW705, CFD-ZW750, CFD-ZW700, CFD-ZW770 User Manual
3-865-708-11(2)
CD Radio
Cassette-Corder
Operating Instructions
CFD-ZW700
CFD-ZW705
CFD-ZW750
CFD-ZW770
1999 by Sony Corporation
Warning
To prevent fire or shock hazard, do
not expose the player to rain or
moisture.
This symbol is intended to alert
the user to the presence of
uninsulated “dangerous voltage”
within the product's enclosure
that may be of sufficient
magnitude to constitute a risk of
electric shock to persons.
This symbol is intended to alert
the user to the presence of
important operating and
maintenance (servicing)
instructions in the literature
accompanying the appliance.
CAUTION
The use of optical instruments with this
product will increase eye hazard.
Warning
Do not install the appliance in a confined
space, such as a bookcase or built-in cabinet.
For customers in Canada
To prevent electric shock, match wide blade
of plug to wide slot, fully insert.
Information
For customers in the United States
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the
interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the
equipment and receiver.
—Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced
radio/TV technician for help.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
Owner's Record
The model number is located at the rear of
the CD radio cassette-corder and the serial
number is located in the battery
compartment.
Record these numbers in the spaces provided
below. Refer to these numbers whenever you
call upon your Sony dealer regarding this
product.
Model No. _______________________
Serial No. ________________________
About This Manual
The instructions in this manual are for
the CFD-ZW700, CFD-ZW705, CFDZW750 and CFD-ZW770. Before you
start reading, check your model number.
The CFD-ZW770 is the model used for
illustration purposes.
Introduction2
Table of contents
Basic Operations
4 Playing a CD
6 Listening to the radio
8 Playing a tape
10 Recording on a tape
The CD Player
12 Using the display
13 Locating a specific point in a
track
14 Playing tracks repeatedly
(Repeat Play)
15 Playing tracks in random order
(Shuffle Play)
16 Creating your own program
(Program Play)
18 Enjoying sound effects (LOOP/
FLASH)
The Radio
19 Presetting radio stations
20 Playing preset radio stations
Basic Operations
Setting Up
25 Hooking up the system
28 Selecting the audio emphasis
(Sound Mode/MEGA BASS/5
BAND GRAPHIC EQUALIZER)
Additional Information
30 Precautions
32 Troubleshooting
34 Maintenance
35 Specifications
Back cover
Index
The Timer
21 Setting the clock
22 Waking up to music
24 Falling asleep to music
3Introduction
Basic Operations
Playing a CD
1,2
For hookup instructions, see pages 25 – 27.
1 Push 6 PUSH OPEN/CLOSE
down to open the CD
compartment and place the CD
on the CD compartment.
With the label side up
3
2 Close the lid of the CD
compartment.
3 Press ^.
The player turns on (direct
power-on) and plays all the tracks
once.
Basic Operations4
Display
Track number Playing time
Use these buttons for additional operations
Tip
Next time you want to
listen to a CD, just press
^. The player turns on
automatically and starts
playing the CD.
POWER 6 PUSH OPEN/CLOSE
To Press
adjust the volume VOLUME +, –
stop playback p
pause playback ^ ( P on the remote,
go to the next track +
go back to the previous track =
remove the CD 6 PUSH OPEN/CLOSE
turn on/off the player POWER
^p
VOLUME +, –
=, +
(VOL +, – on the remote,
CFD-ZW750/ZW770 only)
CFD-ZW750/ZW770 only)
Press the button again to
resume play after pause.
Basic Operations
Basic Operations
5
Listening to the radio
21
For hookup instructions, see pages 25 – 27.
1 Press RADIO BAND until the
band you want appears in the
display (direct power-on).
2 Hold down TUNE•TIME SET +
or – (TUNE + or – on the remote,
CFD-ZW750/ZW770 only) until
the frequency digits begin to
change in the display.
The player automatically scans
the radio frequencies and stops
when it finds a clear station.
If you cannot tune in to a station,
press the button repeatedly to
change the frequency step by
step.
Display
Indicates an FM stereo
broadcast
Basic Operations6
Use these buttons for additional operations
Tips
• If the FM broadcast is
noisy, press MODE until
“Mono” appears in the
display and radio will
play in monaural.
• Next time you want to
listen to the radio, just
press RADIO BAND.
The player turns on
automatically and starts
playing the previous
station.
POWER
To Press
adjust the volume VOLUME +, –
turn on/off the radio POWER
VOLUME +, –
MODE
(VOL +, – on the remote,
CFD-ZW750/ZW770 only)
To improve broadcast reception
Reorient the antenna for FM. Reorient the player itself
for AM.
Basic Operations
for FM
for AM
Basic Operations
7
Playing a tape
12 12
For hookup instructions, see pages 25 – 27.
1 Press p6 to open the tape
compartment and insert a
recorded tape. Use TYPE I
(normal) tape only. Close the
compartment.
With the side you want
to play facing you
2 Press (.
The player turns on ( direct
power-on) and starts playing.
Basic Operations8
Display
Use these buttons for additional operations
Note
During playback, do not
press buttons on the
other deck. Otherwise
the playback speed may
change.
Tip
Next time you want to
listen to a tape, just
press (. The player
turns on automatically
and starts playing the
tape.
POWER
To Press
adjust the volume VOLUME +, –
stop playback p6
fast-forward or rewind the tape ) or 0
pause playback P
eject the cassette p6
turn on/off the player POWER
VOLUME +, –
0, )
p6
P
0, )
p6
P
(VOL +, – on the remote,
CFD-ZW750/ZW770 only)
Press the button again to
resume play after pause.
Basic Operations
Basic Operations
9
Recording on a tape
312
For hookup instructions, see pages 25 – 27.
1 Press p6 to open the tape
compartment on deck B and
insert a blank tape. Use TYPE I
(normal) tape only.
With the side you want to
record on facing you
2 Select the program source you
want to record.
To record from the CD player:
insert a CD (see page 4) and press
CD.
To record from the radio:
tune in the station you want (see
page 6).
To record from the tape (dubbing):
insert a recorded tape into deck A
and press TAPE until “dUb”
appears in the display.
Basic Operations10
Display
Deck B
3 Start recording.
To record from the CD player and
the radio, press r on deck B ((
is depressed automatically).
Basic Operations
Deck A
Tips
• Adjusting the volume or
the audio emphasis (see
pages 28 and 29) will
not affect the recording
level.
• If the AM program
makes a whistling
sound after you have
pressed r in step 3, set
the ISS (Interference
Suppress Switch) at the
rear of the player to the
position that most
decreases the noise.
• For the best results, use
the AC power as a
power source.
To record from the tape, press r
on deck B ((is depressed
automatically). Then press ( on
deck A. (For high speed dubbing,
press HIGH-SPEED DUBBING
instead of ( on deck A).
Use these buttons for additional operations
POWER
p6
P
To Press
stop recording p6 on deck B
pause recording P on deck B
Press the button again to
resume recording.
turn on/off the player POWER
To erase a recording, proceed as follows:
1 Insert a tape whose recording you want to erase intodeck
B.
2 Press TAPE untill “TAPE” appears in the display.
3 Press r.
Basic Operations
11
Loading...