Sony CDX-M630, CDX-M730 User Manual

TOP

3-242-100-31 (1)

FM/MW/LW Compact Disc Player

Installation/Connections

安裝線路連接

AUDIO OUT

FRONT

SUB OUT (MONO)

AUDIO OUT

REAR

BUS AUDIO IN

BUS CONTROL IN

CDX-M730 CDX-M630

2 3

TOP

6 7

× 4

Source selector*

音源選擇器*

XA-C30

Cautions

•This unit is designed for negative earth 12 V DC operation only.

•Do not get the wires under a screw, or caught in moving parts (e.g., seat railing).

•Before making connections, turn the car ignition off to avoid short circuits.

•Connect the yellow and red power input leads only after all other leads have been connected.

•Run all earth wires to a common earth

point.

•Be sure to insulate any loose unconnected wires with electrical tape for safety.

BUS AUDIO IN

BUS CONTROL IN

* not supplied

非附送

Connection example (2)

Notes (2-A)

• Be sure to connect the earth cord before connecting the amplifier.

• If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated.

Tip (2-B-

For connecting two or more CD/MD changers, the source selector XA-C30 (optional) is necessary.

)

× 2

Equipment used in illustrations (not supplied)

插圖中的裝置（非附送）

Front speaker

前揚聲器

Rear speaker

後揚聲器

Power amplifier

功率放大器

CD/MD changer

CD/MD 換碟機

Active subwoofer

有源超低音揚聲器

Rotary commander RM-X4S

旋轉式控制器 RM-X4S

Notes on the power supply cord (yellow)

•When connecting this unit in combination with other stereo components, the connected car circuit’s rating must be higher than the sum of each component’s fuse.

•When no car circuits are rated high enough, connect the unit directly to the battery.

Parts Iist (1)

The numbers in the list are keyed to those in the instructions.

For the use of release key 8, see the supplied operating instructions.

Caution

Handle the bracket 1 carefully to avoid injuring your fingers.

Connection diagram (3)

1 To a metal surface of the car

First connect the black earth lead, then connect the yellow and red power input leads.

2 To the power aerial control lead or power

supply lead of aerial booster amplifier

Notes

• It is not necessary to connect this lead if there is no power aerial or aerial booster, or with a manually-operated telescopic aerial.

• When your car has a built-in FM/MW/LW aerial in the rear/side glass, see “Notes on the control and power supply leads.”

3 To AMP REMOTE IN of an optional power

amplifier

This connection is only for amplifiers. Connecting any other system may damage the unit.

4 To the interface cable of a car telephone 5 To a car’s illumination signal

Be sure to connect the black ground lead to it first.

6 To the +12 V power terminal which is energized

in the accessory position of the ignition key switch

Notes

• If there is no accessory position, connect to the +12 V power (battery) terminal which is energised at all times. Be sure to connect the black earth lead to it first.

• When your car has a built-in FM/MW/LW aerial in the rear/side glass, see “Notes on the control and power supply leads.”

7 To the +12 V power terminal which is energised

at all times

Be sure to connect the black earth lead to it first.

Left

左

Right

右

Left

左

from car aerial

來自汽車天線

SUB OUT (MONO)

AMP REM

Max. supply current 0.3 A

最大供電量 0.3 A

BUS AUDIO IN

/AUX IN

White

白色

White/black striped

白黑條紋

Grey

灰色

Grey/black striped

灰黑條紋

Green

緣色

Green/black striped

緣黑條紋

AUDIO OUT

BUS

FRONT

REAR

AUDIO

AUDIO OUT

REAR

Blue/white striped

藍白條紋

AUDIO OUT

FRONT

Fuse (10 A)

保險絲（10 A）

REMOTE IN

BUS

CONTROL IN

Black

黑色

Blue

藍色

Light blue

淡藍色

Orange/white striped

橙白條紋

Red

紅色

Source selector (not supplied)

音源選擇器（非附送）

XA-C30

ANT REM

Max. supply current 0.1 A

最大源電流 0.1 A

ILLUMINATION

ATT

Supplied with the CD/MD changer

附帶於 CD/MD 換碟機

*1 RCA pin cord (not supplied)

RCA 針型插頭電線（非附送）

*2 Auxiliary optional equipment such

as portable DVD player (not supplied)

輔助選購裝置，如便攜式 DVD 播放機（非附送）

*3 supplied with the auxialiry

equipment

附帶於輔助裝置

*4 CDX-M630 only

Be sure to match the colour-coded code for audio to the appropriate jacks from the unit. If you connect an optional CD/MD unit, you cannot use AUX IN terminal.

僅限於CDX-M630 確保音頻色碼編碼與裝置上的正確插孔相一致。如果連接選購裝置CD/MD裝置，則不能

使用AUX IN端子。

Supplied with XA-C30

附帶於 XA-C30

CDX-M630 only

僅限於CDX-M630

*7Insert with the cord upwards

電線向上插入

Right

右

Notes on the control and power supply leads

• The power aerial control lead (blue) supplies +12 V DC when you turn on the tuner or when you activate the AF (Alternative Frequency), TA (Traffic Announcement) function.

• When your car has built-in FM/MW/LW aerial in the rear/side glass, connect the power aerial control lead (blue) or the accessory power input lead (red) to the power terminal of the existing aerial booster. For details, consult your dealer.

• A power aerial without relay box cannot be used with this unit.

Memory hold connection

When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition key is turned off.

Notes on speaker connection

• Before connecting the speakers, turn the unit off.

• Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities to avoid its damage.

• Do not connect the speaker terminals to the car chassis, or connect the terminals of the right speakers with those of the left speaker.

• Do not connect the earth lead of this unit to the negative (–) terminal of the speaker.

• Do not attempt to connect the speakers in parallel.

• Connect only passive speakers. Connecting active speakers (with built-in amplifiers) to the speaker terminals may damage the unit.

• To avoid a malfunction, do not use the built-in speaker wires installed in your car if the unit shares a common negative (–) lead for the right and left speakers.

• Do not connect the unit’s speaker cords to each other.

Purple

紫色

Purple/black striped

紫黑條紋

注意

• 本機只能使用負極接地 12 V 直流電源。

• 不要使導線夾在螺栓下，或繞掛在移動部件上

（如：座椅扶手上）。

• 進行連接之前，請先關閉汽車的點火器，以避免短路。

• 黃色和紅色電源輸入導線必須在所有其它導線都連接完畢以後才連接。

• 將所有地線都連接到同一接地點。

• 為了安全，請確認把沒有連接的導線用電器膠帶

包紮進行絕緣。

電源導線須知（黃色）

• 將本機與其它立體聲裝置相連接時，所連接的汽車電路容量必須大於每個裝置保險絲容量的總和。

• 當汽車電路容量不夠大時，請將本機直接與電池相連接。

零件一覽表（1）

圖示數字與說明書中的數字是一致的。

有關脫扣鑰匙 8 的使用，請參見隨機附送的使用說明書。

注意

移動裝卸支架 1 時，請特別注意別傷到手指。

TOP

Yellow

黃色

線路連接圖例（2）

註

（2-A）

•

務必在接放大器之前連接地線

•

如果您連接了選購的功率放大器而不使用內裝的放大器，將無嘟聲功能

要領

（2-B- ）

若要連接 2 台或更多 CD/MD 換碟機時，必須使用音源選擇器 XA-C30（選購件）。

。

線路連接圖（3）

1 至汽車的金屬表面

首先連接黑色接地導線，然後再連接黃色和紅色電源輸入導線。

2 至電動天線控制導線或天線升壓放大器的電源導線

註

•

如無電動天線，天線增壓器，或只有手動操作的套管式天線，便不須連接此導線。

•

您的汽車的後側玻璃窗中如果內裝有 FM/MW/LW 天線，即請參看“控制和電源線須知”。

3 至選購的功率放大器的 AMP REMOTE IN（放大器遙控

輸入）

本連接僅用於放大器。連接任何其它系統可能會損壞本機。

4 至汽車電話的接口電纜 5 至汽車照明訊號

務請首先將黑色接地導線與其連接。

6 至在點火鑰匙的輔助位置上通電的 +12 V 電源端子

註

•

若沒有輔助位置，則請連接至常時通電的 +12 V 電源（電池）端子。務請首先將黑色接地導線與其連接。

•

您的汽車的後側玻璃窗中如果內裝有 FM/MW/LW 天線，即請參看“控制和電源線須知”。

7 至隨時都通電的 +12 V 電源端子

務請首先將黑色接地導線與其連接。

控制和電源線須知

•

當您打開調諧器或啟動 AF（變換頻率）或 TA（交通公告）功能時，電動天線控制導線（藍色）提供 +12 V 直流電。

•

若您的汽車後側玻璃窗上有內置 FM/MW/LW 天線，須將電動天線控制導線（藍色）或輔助電源輸入導線（紅色）連接到現有天線放大器上的電源端子上。詳細內容請向銷售商諮詢。

•

本機不能使用不具備繼電箱的電動天線。

保持記憶的線路連接法

當連接好黃色電源輸入導線時，即使汽車發動機關閉，記憶電路仍然通電。

連接揚聲器時的注意事項

•

連接揚聲器電線以前，請先切斷本機電源。

•

使用阻抗為 4-8Ω 且具有充分功率處理容量的揚聲器，以免損壞揚聲器。

•

不要將揚聲器端子連接到汽車底盤上或將右揚聲器端子與左揚聲器端子相連接。

•

切勿將本機的接地導線連接至揚聲器的負(-)接線柱。

•

揚聲器不可以並聯連接。

•

請僅連接無源揚聲器。若將有源揚聲器（帶內置放大器）連接到揚聲器端子上會損壞本機。

•

若本裝置使用左、右揚聲器的共用(-)極導線，為了避免故障，切勿使用已安裝在汽車內的內置揚聲器導線。

•

請勿將本裝置揚聲器導線相互連接。

+ 2 hidden pages