Sonic Alert SBW100 Operation Instructions Manual

English

Features

1) PM Indicator

2) Alarm 1 Indicator

3) Alarm 2 Indicator

4) Alarm Mode Switch (AL1, AL2, AL1+AL2)

5) Alarm Off / LAMP on/off

6) Time Set

7) Alarm Set

8) Snooze / Dimmer

9) Fast

10) Slow / Sleep

11) Alarm Function Switch

Model SBW100

Sonic Boom

OPERATION INSTRUCTIONS
IMPORTANT - Please read these instructions carefully before use and retain for future reference.

- Use only the supplied or recommended Sonic Alert adaptor to connect the unit.
WARNING: To prevent fire or shock hazard do not expose this appliance to rain or moisture.

- The ventilation should not be impeded by covering the ventilation openings with items

such as, newspaper, table cloth, curtains, etc.;

- No naked flame sources, such as lighted candles should be placed on the apparatus.

- It shall not be exposed to dripping or splashing and that no objects filled with liquids,

shall remain readily operable.
GENERAL DATA:
UL listed Power Adaptor: AC100-240V~, 50/60Hz
Adaptor Output: DC5V , 2.2 A

such as vases, shall be placed on the apparatus.

- Do not place the product in closed bookcases or racks without proper ventilation.

- Where the mains/ power plug is used as the disconnect device, the disconnect device

12) Alarm Sound Selector

13) Vibrator Output

14) Tone Wheel

15) USB for Charging

16) AUX Input

17) DC Input

18) Volume Wheel

19) Record / Play

Test Mode:

1) Press and hold the Snooze (8) and Time (6) buttons for 3 seconds to enter the Test Mode. The
display will show "7ES7" to indicate it is in TEST Mode.

2) If within 1 minute no button is pressed, then it will exit the Test Mode and return back to the
Time Mode.

3) While in Test Mode, sliding the Alarm Function Switch (11) will demonstrate the different
functions of the clock; Buzz, VIB or Buzz & Vib.

4) After finish with the Test Mode, press any button (except the Snooze & Time buttons, which has
no effect) it will exit the Test Mode immediately.

Setting the Correct Time -

1) Press and hold the TIME Button (6) and at the same time press the FAST Button (9)

or the SLOW button (10) to advance clock display until you have desired time.

2) The lighted dot (1) located in upper left corner of the clock display indicates the time is

PM. For AM time, this dot will not light up.

Setting the Alarm Time -

Setting Alarm 1

1) Slide the ALARM MODE SWITCH (4) to AL1 position, the alarm indicator AL1 (2) will
light up.

2) Press and hold the ALARM SET (7) button and at the same time press the FAST

Button (9) or the SLOW button (10) to advance clock display until the desired
alarm setting is reached.

3) Make sure alarm time is correctly set for AM or PM.

Setting Alarm 2

4) Once alarm AL1 has been set, slide ALARM MODE SWITCH (4) to AL2 position, the

alarm indicator AL2 (3) will light up.

5) Press and hold the ALARM SET (7) button and at the same time press the FAST

Button (9) or the SLOW button (10) to advance clock display until you reach desired

alarm setting.