SBB500SS
SBB500SS Sonic Bomb Loud Dual Alarm Clock
Instruction Manual
Special Features of Your Sonic Boom Alarm Clock
Congratulations on the purchase of your Sonic Boom Alarm Clock! This unique clock
allows you to:
• Wake up to any combination of loud pulsating audio alarm, flashing lights, and
shaking bed (bed vibrator sold separately).
• Adjust the alarm volume and tone to achieve the most effective audio alert.
• Easily view the large, bright green LED display with adjustable display angle.
• Save your time and alarm setting in the event of a power interruption through the
use of a battery backup (9V battery not included).
• Use the clock with Sonic Alert’s complete line of signaling products, such as
telephone, doorbell, and baby cry signalers.
Setting the Time of Day
Note: Since your clock has a 24-hour memory, you must make sure that the time set is
AM or PM. A round light in the upper left of the clock display will indicate PM time.
For AM time, the light does not appear.
1. Press and hold the TIME (time set) button. Then press the HOUR button until the
correct hour is shown.
2. Press and hold the TIME button again. Then press the MIN (minute) button until
the correct minutes are shown.
Setting an Alarm Time
Note: Since your clock has a 24-hour memory, you must make sure that the time set is
AM or PM. A round light in the upper left of the clock display will indicate PM time.
For AM time, the light does not appear.
1. Press and hold the ALARM (alarm set) button. Then press the HOUR button
until the desired alarm hour is shown.
2. Press and hold the ALARM button again. Then press the MIN (minute) button
until the desired alarm minutes are shown.
Turning the Alarm On and Choosing Waking Options
The Sonic Boom clock can wake you with any combination of flashing lamp, pulsating
audio alarm, and shaking bed. To turn on the alarm, you must set the OUTLETS switch
to the LAMP, VIB (vibrator), or BOTH positions. This sets the alarm to go off at the
alarm time which you have preset. To tell you that the alarm is set, the clock’s Alarm
Set light will turn on.
Note: If you set the OUTLETS switch to OFF, the audio alarm will not sound.
Use the chart below to set the alarms you want to wake up to:
Audio Alarm only
• Volume ON
• Tone Adjusted
• OUTLETS switch set to LAMP, VIB, or BOTH
Flashing Light (with Audio On or Off)
• Light connected and turned ON
• OUTLETS switch set to LAMP
• Volume ON or OFF, depending upon your preference
Vibrator (with Audio On or Off)
• Vibrator connected
• Vibrator switch set to either STEADY or PULSE
• OUTLETS switch set to VIB (vibrator)
• Volume ON or OFF, depending upon your preference
Flashing Light and Vibrator (with Audio On or Off)
• Vibrator and Lamp Connected
• OUTLETS switch set to BOTH
• Volume ON or OFF, depending upon your preference
Loading...