Sonic Boom Alarm Clock
Model SB 1000
Instruction Manual
Congratulations on the purchase of your Sonic Boom Alarm Clock! This unique clock allows you to:
•Wake up to any combination of loud pulsating audio alarm, flashing lights, and shaking bed (bed vibrator sold separately).
•Adjust the alarm volume and tone to achieve the most effective audio alert.
•Easily view the large, bright green LED display with adjustable display angle.
•Save your time and alarm setting in the event of a power interruption through the use of a battery backup (9V battery not included).
•Use the clock with Sonic Alert’s complete line of signaling products, such as telephone, doorbell, and baby cry signalers.
Note: Since your clock has a 24-hour memory, you must make sure that the time set is AM or PM. A round light in the upper left of the clock display will indicate PM time. For AM time, the light does not appear.
1.Press and hold the TIME (time set) button. Then press the HOUR button until the correct hour is shown.
2.Press and hold the TIME button again. Then press the MIN (minute) button until the correct minutes are shown.
Note: Since your clock has a 24-hour memory, you must make sure that the time set is AM or PM. A round light in the upper left of the clock display will indicate PM time. For AM time, the light does not appear.
1.Press and hold the ALARM (alarm set) button. Then press the HOUR button until the desired alarm hour is shown.
2.Press and hold the ALARM button again. Then press the MIN (minute) button until the desired alarm minutes are shown.
The Sonic Boom clock can wake you with any combination of flashing lamp, pulsating audio alarm, and shaking bed. To turn on the alarm, you must set the OUTLETS switch to the LAMP, VIB (vibrator), or BOTH positions. This sets the alarm to go off at the alarm time which you have preset. To tell you that the alarm is set, the clock’s Alarm Set light will turn on.
Note: If you set the OUTLETS switch to OFF, the audio alarm will not sound.
Use the chart below to set the alarms you want to wake up to:
•Volume ON
•Tone Adjusted
•OUTLETS switch set to LAMP, VIB, or BOTH
Flashing Light (with Audio On or Off)
•Light connected and turned ON
•OUTLETS switch set to LAMP
•Volume ON or OFF, depending upon your preference
Vibrator (with Audio On or Off)
•Vibrator connected
•Vibrator switch set to either STEADY or PULSE
•OUTLETS switch set to VIB (vibrator)
•Volume ON or OFF, depending upon your preference
Flashing Light and Vibrator (with Audio On or Off)
•Vibrator and Lamp Connected
•OUTLETS switch set to BOTH
•Volume ON or OFF, depending upon your preference
You use the VOLUME control knob to turn the audio alarm on or off and to adjust the volume. To increase volume, rotate the knob toward you. To turn the audio alarm off, rotate the knob away from you until you feel it click.
You use the TONE control knob to adjust the pitch of the audio alarm. For a lower pitch alarm, rotate the knob toward you. For a higher pitch, rotate it away from you.