Sonic Alert SBT625SS User Manual

RHK900 (SBT625ss) for USA Updated: 16-12-2014

Sonic Boom Alarm Clock & Bed Shaker

with 5-Level Dimmer & USB Charging

Model SBT625ss

OPERATION INSTRUCTIONS

IMPORTANT – Please read these instructions carefully before use and retain for future reference.

See operating instructions on back.

- Use only the supplied adaptor to connect the unit.

Warning: To prevent fire or shock hazard do not expose this appliance to rain or moisture.
Before connecting to mains make sure that the requirements specified on the apparatus

corresponds to the available power supply i.e. AC100-240V~, 50/60 Hz.
– The ventilation should not be impeded by covering the ventilation openings with

items such as, newspaper, table cloth, curtains, etc;
– No naked flame sources, such as lighted candles should be placed on the apparatus.
– It shall not be exposed to dripping or splashing and that no objects filled with liquids,

such as vases, shall be placed on the apparatus.
– Do not place the product in closed bookcases or racks without proper ventilation.
– Where the mains plug is used as the disconnect device, the disconnect device shall

remain readily operable.

RHK900 (SBT625ss) for USA Updated: 16-12-2014

INSTRUCTIONS

Features show on diagram above:

1. PM indicator Time Set

2. Alarm 1 indicator

3. Snooze / Dimmer

4. Alarm Mode Switch (Off, Buzz, VIB)

5. Alarm Selector (AL1, AL2)

6. Tone Slider

7. Time

8. Fast

9. Slow

Test Mode:

1) Press and hold the Snooze (3) and Time buttons (7) for 3 seconds to enter the Test Mode. The

display will show "7ES7" to indicate it is in TEST Mode. To demostrate the unit function as
follows:
a) Slide the Alarm Mode Switch (4) at OFF position, there will be a „VEE“ sound.
b) Slide the Alarm Mode Switch (4) at BUZZ position, there will be a „BEEP“ sound.
c) Slide the Alarm Mode Switch (4) at VIB position, the vibrator will vibrate.
d) Slide the Alarm Mode Switch (4) at BUZZ & VIB position, there will be a „BEEP“ sound

and the vibrator will vibrate.

2) If within 1 minute no button is pressed, then it will exit the Test Mode and return back to the

Time Mode.

3) To exit the Test Mode immediately, press any button (except the Snooze & Time buttons,

which has no effect).

Setting the correct time –

1) Press and hold the Time Button (7) at the same time press the Fast Button (8) to advance the

clock display rapidly until the hour is correct.

2) Press and hold the Time Button (7) at the same time press the Slow Button (9) to advance the

clock display rapidly until the minute is correct.
A lighted dot (1) in the upper left of the clock display indicated the time is PM. For AM time
indication, the dot does not light up.

Setting the Alarm Time –

Setting Alarm 1

1) Slide the ALARM SELECTOR SWITCH (5) to AL1 position, the alarm indicator AL1 (2) will light

up.

2) Press and hold the ALARM SET (10) and the FAST Button (8) or the SLOW button (9) to advance

the clock display until you reach desired alarm setting.

10. AL. Set

11. AL. OFF

12. Volume

13. Alarm 2 Indicator

14. DC5V input

15. Back Up Battery Cover

16. USB Charging

17. Vibrator Input