Sonic Alert SBB500SS-V3 User Manual
Model SBB500SS-v3
Sonic Boom Alarm Clock & Bed Shaker
OPERATION INSTRUCTIONS
IMPORTANT – Please read these instructions carefully before use and retain for future
reference. See operati ng instr uc ti ons on bac k .
– Use only the supplied or recomended Sonic Alert adaptor to connect the
unit.
Warning: To prevent fire or shock hazard do not expose this appliance to rain or
moisture. Before connecting to mains/ power make sure that the
requirements specified on the apparatus corresponds to the available power
supply in that country i.e. AC100-240V ~ , 56/ 60 Hz.
– The ventilation should not be impeded by covering the ventilation
openings with items such as, newspaper, table cloth, curtains, etc;
– No naked flame sources, such as lighted candles should be pl aced on the
apparatus.
– It shall not be exposed to dripping or splashing and that no objects filled
with liquids, such as vases, shall be placed on the apparatus.
– Do not place the product in closed bookcases or racks without proper
ventilation.
– Where the mains/ power plug is used as the disconnect device, the
disconnect device shall remain readily operable.
MODEL SBB500ss-v3
Features
1)
2) Alarm 1 Indicator
6)
7)
8)
9)
10) Fast Min./ Hour
11)
Indicator
OPERATION INSTRUCTIONS
Test Mode:
Setting the Correct Time –
Setting the Alarm Time–
3) PM Indicator
4) Snooze button /
Snooze Time
Adjustment/
Dimmer Control
5) Volume Wheel
Alarm Set / Alarm
Duration
Adjustment
Time Set Button
Alarm Off Button
Alarm Function
Switch
Button / 12 or
24 Hour
Selector
Slow Min./
Hour Button
12) Battery
Compart
ment
13) Alarm Mode
Switch
14) DC Adaptor
Input
15) Tone Control
Wheel
16) Vibrator Output
17) Flashing Light
Display
18) Alarm 2
1) Press and hold the Snooze and Time buttons for 3 seconds to enter the Test
Mode. The display will show "7ES7" to indicate it is in TEST Mode.
2) If within 1 minute no button is pressed, then it will exit the Test Mode and return
back to the Time Mode.
3) Press any button within 1 minute (except the Snooze & Time buttons, which has no
effect), it will exit the Test Mode immediately.
4) While in Test Mode, sliding the Function Switch will demonstrate the different
functions of the clock:
a) Function Switch at OFF, it will have a continuous "Vee" sound to indicate it is in
the Test Mode.
b) Function Switch at BUZZ, it will demonstrate the buzzer sound.
c) Function Switch at VIB, it will demonstrate the vibrator.
d) Function Switch at VIB & BUZZ, it will demonstrate the buzzer sound & the
vibrator.
5) After finish with the Test Mode, press any button (except the Snooze & Time
buttons, which has no effect) it will exit the Test Mode immediately.
1) Press and hold the “TIME“ Button (6) and at the same time press the
“FAST“ Button (9) or the “SLOW“ button (10) to advance clock display unil you
have desired time.
2) The lighted dot (2) located in upper left corner of the clock display indicates the
time is PM. For AM time, this dot will not light up.
Setting Alarm 1
1) Slide the “ALARM MODE SWITCH“ (12) to AL1 position, the alarm indicator
“AL1“ (1) will light up.
2) Press and hold the “ALARM SET“ (5) button and at the same time press the
“FAST“ Button (9) or the “SLOW“ button (10) to advance clock display until you
reach desired alarm setting.
3) Make sure alarm time is correctly set for AM or PM (1).
Loading...