SOMFY LT30 RTS User Manual

Roll Up WireFree RTS Round Head Visual Reference Guide
LT30 RT Round Head for roller and sheer type shade applications.
STEP 1
my
To initiate programming press and hold both the Up and Down buttons at the same time until the shade jogs.
STEP 3
Bring the shade to your desired lower limit. Press and hold both the MY
my
my
Stop and UP buttons until the shade begins to move up, then release. Stop the shade where the upper limit should be set, you can adjust by pressing the
UP or DOWN buttons.
STEP 5
Press and hold the MY
my
my
button until the shade jogs to confirm the limit setting.
NOTE: Steps 3 and 4 may be reversed depending on initial position of shade.
STEP 2
Check the direction of operation. Press and hold the DOWN button and confirm the shade moves in a down direction (shade will operate only when button is held).To change the direction press and hold the MY
my
(Stop) button until the shade jogs.
STEP 4
Bring the to your desired upper limit. Press and hold both the MY
shade
my
Stop and DOWN buttons until the shade begins to move down, then release. Stop the shade where the lower limit should be set, you can adjust by pressing the UP or DOWN buttons.
STEP 6
Press and hold the Program button on the back of the transmitter until the shade jogs. (Shade is now programmed and once operated will travel to its end limits.)
my
my
my
Programming Button
TO ADJUST LIMITS To change the lower limit: Move the to its current lower limit position and let it stop. Press
shade the UP and DOWN buttons simultaneously until the shade jogs, then release. Adjust to a new lower limit position. Press the MY button until the shade jogs, then release. Check new limit.
To change the upper limit: Move the to its current upper limit position and let it stop. Press
my
shade the UP and DOWN buttons simultaneously until the shade jogs, then release. Adjust to a new upper limit position. Press the MY button until the shade jogs, then release. Check new limit.
my
TO ADD A REMOTE/CHANNEL
First press the programming button on the back of the already programmed remote until the shade jogs. Then press the programming button on the new remote or channel that you would like to add until the shade jogs. Check it.
TO DELETE ALL PREVIOUS SETTINGS
Using a paperclip or pen, press and hold the Program Button, located on the motor head for 12 seconds. All transmitters and limits are now erased and will have to be reset.
my
Program Button
my
Please contact SOMFY for detailed installation instructions
somfysystems.com
Program Button
SOMFY SYSTEMS, INC. 6/07
Loading...