Smooth Fitness 5.15E User Manual
USER’S MANUAL
5.15E MOTORIZED TREADMILL
Model number: 5.15E
USER WEIGHT LIMITATION: 125kgs (275lbs).
TOLL FREE CUSTOMER SERVICE NUMBER: 0800-09 72 100
SERIAL NUMBER (found on frame):
www.smoothfitness.co.uk
2
PRECAUTIONS
WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons, read the following important precautions and
information before operating the treadmill. It is the responsibility of the owner to ensure that all users of this treadmill are
adequately informed of all warnings and precautions.
• Use the treadmill only as described in this manual.
• Place on a level surface, with 6 feet (2 m) of clearance behind it. Do not place the treadmill on any surface that
blocks air openings. To protect the floor or carpet from damage, place a mat under the treadmill.
• When choosing a location for the treadmill make sure that the location and position permit access to a plug.
• Keep the treadmill indoors, away from moisture and dust. Do not put the treadmill in a garage or covered patio, or
near water.
• Do not operate the treadmill where aerosol products are used or where oxygen is being administered.
• Keep children under the age of 12 and pets away from the treadmill at all times.
• The treadmill should not be used by persons weighing more than 125 kgs (275lbs)
• Never allow more than one person on the treadmill at a time. Wear appropriate exercise clothing when using the
treadmill. Do not wear loose clothing that could become caught in the treadmill. Athletic support clothes are
recommended for both men and women. Always wear athletic shoes. Never use the treadmill with bare feet,
wearing only stockings, or in sandals.
• When connecting the power cord, plug the power cord into a grounded circuit. No other appliance should be on the
same circuit.
• Always straddle the belt and allow it to start moving before stepping onto the belt.
• Always examine your treadmill before using to ensure all parts are in working order.
• Allow the belt to fully stop before dismounting.
• Never insert any object or body parts into any opening.
• Follow the safety information in regards to plugging in your treadmill.
• Keep the power cord away from the incline wheels and do not run the power cord underneath your treadmill. Do not
operate the treadmill with a damaged or frayed power cord.
• Always unplug the treadmill before cleaning and/or servicing. Service to your treadmill should only be performed by
an authorized service representative, unless authorized and/or instructed by the manufacturer. Failure to follow
these instructions will void the treadmill warranty.
• Never leave the treadmill unattended while it is running.
• The equipment is for Class B (Home Use).
www.smoothfitness.co.uk
3
POWER REQUIREMENTS
Power Requirements:
IMPROPER CONNECTION OF THE EQUIPMENT GROUNDING CONNECTOR CAN RESULT IN A RISK OF AN
ELECTRIC SHOCK. CHECK WITH A QUALIFIED ELECTRICIAN OR SERVICE MAN IF YOU ARE IN DOUBT AS TO
WHETHER THE PRODUCT IS PROPERLY GROUNDED. DO NOT MODIFY THE PLUG PROVIDED WITH THE
PRODUCT, IF IT WILL NOT FIT THE OUTLET; HAVE A PROPER OUTLET INSTALLED BY A QUALIFIED ELECTRICIAN.
This treadmill can be seriously damaged by sudden voltage changes in your home’s electrical power. Voltage spikes, surges
and noise interference can result from weather conditions or from other appliances being turned on or off. To reduce the
possibility of treadmill damage, always use a surge protector (not included) with your treadmill. Surge protectors can be
purchased at most hardware stores.
This treadmill is provided with two different grounding plugs for Central Europe and United Kingdom. Please choose the right
one and plug in your treadmill.
Please make sure that your local voltage is appropriate for the power requirements of this treadmill before you plug it in.
This product is for use with a voltage of 230V+
GFCI outlets and GFCI Circuit Breakers are NOT recommended for use on this product. GFCI outlets and GFCI Circuit
Breakers may cause this equipment to improperly function
Do not use a voltage transformer with this product.
Do not use an extension cord with this product when you are not sure if the product is still properly grounded.
The following pictures show the two delivered plugs:
5%.
www.smoothfitness.co.uk
4
PREASSEMBLY
Open the boxes:
You are now ready to open the boxes of your new equipment. Make sure to inventory all of the parts that are included in the
boxes. Check the Hardware Comparison Chart for a full count of the number of parts included for this product to be
assembled properly. If you are missing any parts or have any assembly questions call 0800-0972100.
Gather your tools:
Before starting the assembly of your unit, make sure that you have gathered all the necessary tools you may require to
assemble the unit properly. Having all of the necessary equipment at hand will save time and make the assembly quick and
hassle-free.
Clear your work area:
Make sure that you have cleared away a large enough space to properly assemble the unit. Make sure the space is free
from anything that may cause injury during assembly. After the unit is fully assembled, make sure there is a comfortable
amount of free area around the unit for unobstructed operation.
Invite a friend:
Some of the assembly steps may require heavy lifting. It is recommended that you obtain the assistance of another person
when assembling this product.
User Weight Limitation:
Please note that there is a weight limitation for this product. If you weigh more than 125kgs (275lbs). It is not
recommended that you use this product. Serious injury may occur if the user’s weight exceeds the limit shown
here. This product is not intended to support users whose weight exceeds this limit.
www.smoothfitness.co.uk
5
HARDWARE COMPARISON CHART
Hardware chart:
For your convenience, we have identified the hardware used in the assembly of this product. This chart is provided to help
you identify those items that may be unfamiliar to you.
NO. DESCRIPTION QTY.
Reading Rack
27
M5 x 14mm Bolt
29
1
2
73 8mm Washer 4
27
76 M10 x 26mm Bolt 2
77 M8 x 18mm Bolt 4
80 Plastic Cover 2
81 M6 x 15mm Bolt 1
87 M3.5 x 16mm Screw 2
89 10mm Washer 2
M4 x 15mm Reading Rack
99
Screw 3
Console Support Locating
Screw
101
1
Handlebar Front End Cap
Right-1
95
1
Handlebar Front End Cap
97
Right-2 1
A Safety Key 1
B Power Cord 1
C Screwdriver 1
D 5 mm Allen Wrench 1
E 8 mm Allen Wrench 1
F T type Screwdriver 1
97
A
D
B
E
95
C
F
MILLIMETERS
)
g
www.smoothfitness.co.uk
6
PARTS LIST
No. Description Qty. Order No. No. Description Qty. Order No.
1 Running Belt 1 5.15P-01 30
Screw
2 Motor Hood 1 5.15P-02 31 Rear Wheel 2 5.15P-31
Handlebar End Cap (Right &
Motor Hood Side Cover
3 Deck Rear End Cap-Right 1 5.15P-03 32
Left
4 Deck Rear End Cap-Left 1 5.15P-04 33 (Pre-Assembled) 5.15P-33
5 Side Rail-Right 1 5.15P-05 34 Safety Key 1 5.15P-34
Motor Hood Side Cover-
6 Side Rail-Left 1 5.15P-06 35
Ri
ht
7 Front Roller 1 5.15P-07 36 Motor Hood Side Cover-Left 1 5.15P-36
8 Front Roller Shaft 1 5.15P-08 37 Side Rail Guide Screw 12 5.15P-37
9 Rear Roller 1 5.15P-09 38 Side Rail Guide 6 5.15P-38
10 Rear Roller Shaft 1 5.15P-10 39 Deck Rubber Cushion Bolt 8 5.15P-39
11 Running Deck 1 5.15P-11 40 Deck Rubber Cushion 8 5.15P-40
4 5.15P-30
2 5.15P-32
1 5.15P-35
12 Base Frame 1 5.15P-12 41 Motor Adjustment Bolt 1 5.15P-41
13 Handle Upright-Right 1 5.15P-13 42 8 x 23mm Washer 2 5.15P-42
14 Handle Upright-Left 1 5.15P-14 43 Motor Bumper Bushing 1 5.15P-43
15 Main Frame 1 5.15P-15 44 M10 x 116mm Bolt 1 5.15P-44
16 Elevation Support 1 5.15P-16 45 Nut 1 5.15P-45
17 Motor Control Board 1 5.15P-17 46 M8 x 12mm Socket Bolt 2 5.15P-46
18 Driving DC Motor 1 5.15P-18 47 8 x 16mm Washer 2 5.15P-47
19 Motor Drive Belt 1 5.15P-19 48 10 x 23mm Washer 1 5.15P-48
20 Motor Holder 1 5.15P-20 49 Nut 1 5.15P-49
21 Elevation Motor 1 5.15P-21 50 Shock 1 5.15P-50
22 Motor Bottom Tray 1 5.15P-22 51 Roller 2 5.15P-51
23 Handlebar-Right 1 5.15P-23 52 Plastic Clamp-Top 2 5.15P-52
24 Handlebar-Left 1 5.15P-24 53 Plastic Clamp-Bottom 2 5.15P-53
25 Hand Pulse Sensors 2 5.15P-25 54 Support 2 5.15P-54
26 Console 1 5.15P-26 55 (Pre-Assembled) 5.15P-55
27 Reading Rack 1 5.15P-27 56 U Bracket 1 5.15P-56
28 Console Support 1 5.15P-28 57 Bumper 1 5.15P-57
29 M5 x 14mm Bolt 2 5.15P-29 58 M16 x 54mm Bolt 1 5.15P-58
e
g
e
g
Scre
www.smoothfitness.co.uk
7
PARTS LIST
No. Description Qty. Order No. No. Description Qty. Order No.
59 20 x 40mm Washer 1 5.15P-59 89 10mm Washer 2 5.15P-89
60 M16 Nut 1 5.15P-60 90 6mm Washer 2 5.15P-90
61 M10 x 67mm Bolt 1 5.15P-61 91 (Pre-Assembled) 5.15P-91
62 M10 Nut 5 5.15P-62 92 16mm Washer 2 5.15P-92
63 Bumper 1 5.15P-63 93 M8 Nut 3 5.15P-93
64 Deck Rear End Cap Screw 4 5.15P-64 94
ft-2
L
Handlebar Front End Cap
Handlebar Front End Cap
65 Metal Plate 2 5.15P-65 95
Ri
ht-1
Handlebar Front End Cap
66 Rear Roller Washer 2 5.15P-66 96
ft-1
L
Handlebar Front End Cap
67 Rear Roller Bolt 2 5.15P-67 97
Ri
ht-2
68 Power Switch Board 1 5.15P-68 98 M8 x 36mm Bolt 2 5.15P-98
69 Foot Up Lock 1 5.15P-69 99 M4 x 15mm Screw 3 5.15P-99
1 5.15P-94
1 5.15P-95
1 5.15P-96
1 5.15P-97
70 Caster Holder 2 5.15P-70 100 Console Bar End Cap 2 5.15P-100
Console Support Locating
71 Base Frame End Cap 2 5.15P-71 101
w
1 5.15P-101
72 Base Frame Rubber Cushion 2 5.15P-72
73 8mm Washer 10 5.15P-73
74 (Pre-Assembled) 5.15P-74
75 M10 x 58mm Bolt 4 5.15P-75
76 M10 x 26mm Bolt 2 5.15P-76
77 M8 x 18mm Bolt 6 5.15P-77
78 (Pre-Assembled) 5.15P-78
79 M4 x 12mm Screw 8 5.15P-79
80 Plastic Cover 2 5.15P-80
81 M6 x 15mm Bolt 2 5.15P-81
82 M10 x 20mm Bolt 4 5.15P-82
83 M10 x 26mm Bolt 2 5.15P-83
84 M8 x 45mm Bolt 2 5.15P-84
85 M16 x 73mm Bolt 2 5.15P-85
86 (Pre-Assembled) 5.15P-86
87 M3.5 x 16mm Screw 4 5.15P-87
88 Console Screw 2 5.15P-88
www.smoothfitness.co.uk
8
PARTS DIAGRAM
A MAJORITY OF THE PARTS SHOWN HERE HAVE BEEN PREASSEMBLED AT THE FACTORY.
www.smoothfitness.co.uk
9
PARTS DIAGRAM
A MAJORITY OF THE PARTS SHOWN HERE HAVE BEEN PREASSEMBLED AT THE FACTORY.
www.smoothfitness.co.uk
10
ASSEMBLY
STEP 1:
Remove your treadmill from the carton and place it on the floor in an open area as shown in FIG1.
Raise the Left Upright (14) and secure with Bolts (77 and 76) and Washers (73 and 89). Repeat this step for the Right
Upright (13). DO NOT FULLY TIGHTEN AT THIS POINT.
Loading...