Smeg WD-PRINTEINK DATASHEET

19 510 0982 00 Fogl.IT-EN WD-PRINTEINK

Smeg S.p.A. - Instruments Division - [e-mail]

Smeg WD-PRINTEINK

EXTERNAL PRINTER – INSTRUCTION SHEET FOR THE CONNECTION

Ink Thermal Transfer Printer

This document provides instructions for connecting the printer to Smeg devices and the configuration instructions.
Refer to the printer manufacturer's manual for any other detailed information.
The printer is used by the Smeg devices to provide the report of the washing cycle in progress.

COMPATIBILITY OF THE ACCESSORY - DEVICES

The accessory can be mounted on the following devices:

GW LINE – GLASSWARE WASHER LABORATORY SECTOR

GW6010

GAMMA WD – INSTRUMENT WASHER HOSPITAL SECTOR

WD6010

N.B.

1. The printer can only be installed on devices that are not equipped with integrated thermal printer Smeg "WD­PRINTS6010" or "WD-PRINTP6010".

2. The Smeg devices must have updated firmware installed (Firmware Master ver. 4.9.0 - 21.6.2016 - or later).

CONNECTION OF THE PRINTER TO THE WASHING MACHINE

Description

Image

The printer must be connected to the
RS-232 port on your machine using the
supplied cable.

The printer has a dedicated power supply,
which must be connected to the power
supply, as marked on the component.

Detail View: location of the RS-232 port on
the TOP of the machine.

19 510 0982 00 Fogl.IT-EN WD-PRINTEINK

Smeg S.p.A. - Instruments Division - [e-mail]

CONFIGURAZIONE DELLA MACCHINA

Description

Image

Step 1: Turn on the machine and access to the Setup

menu.

Select "Cycles archive", then enter the "Superuser"
password.

Step 2: you gain access to the printer configuration
screen, sch. 1462 "Cycles archive".

Using the commands:

a) Enable printing: flag on "Print enable";

b) select "Ink" (for the WD-PRINTEINK printer, ink
thermal transfer).

c) Select "Normal" to print in standard mode, "Reverse"
to print the report strings “upside-down”.

d) Confirm, pressing the key on the right side of the
screen.

Step 3: Installation completed. During the washing cycle: the device will print a record of the events of the cycle in progress.

For the correct operation of the device, always verify that:

1. The printer is turned on before starting a cycle;

2. The consumables required for operation are not depleted (paper and ink);

3. Consumables materials comply with the requirements of the device manufacturer.

Smeg S.p.A.

Instruments Division

Via Leonardo da Vinci, 4 – 42016 Guastalla (RE) Italy

Tel. [phone] – Fax [phone]

E-Mail: [e-mail] - [e-mail]

www.smeg-instruments.com