Smeg WD3060, WD5090 INSTRUCTION SHEET

Fogl.IT-EN WD3060-WD5090

Smeg S.p.A. - Instruments Division - [e-mail]

SMEG WD3060 - WD5090

- WASHER DISINFECTOR -

1 INSTRUCTION SHEET

THIS DOCUMENT

Brief instruction sheet for basic procedures.

For all details relating to correct, safe use of the appliances concerned, the updated table of programs, interpretation of a

larm

messages and installation instructions, please refer to the full version of the operator’s manual and program table.

SELECTING AND STARTING A WASHING PROGRAM

First step

Power up the device by turning the master switch from “0” to “I”.
For models with side cabinet, the switch is access

ible by opening the cabinet door.

The latest program selected appears on the display after the manufacturer’s logo.

Press “

ESC” to change the preselected program.

Press “

UP” (or “DOWN”) to choose the program required.

Press “

ENTER” to select the program required.

Press “

START” to start the selected program.

RESET CYCLE

“RESET” button: starts the RESET cycle to return the device to its initial status.
The reset cycle should be used when alarms appear on the display.

STOPPING THE PROGRAM

Press “STOP” to halt a program. The door cannot be opened. Two possibilities:

-

If the “START” button is pressed within 60 seconds: the cycle is restarted.

- If the “RESET” button is pressed: the reset cycle is performed.

OPENING THE DOOR

Press “

ENTER” to activate opening of the door. Do not force the door open by hand; a safety device is fitted.

ALARMS

The display and the buzzer alert the user to any alarms. When an alarm occurs, the device will attempt to deal with
the problem itself. When an alarm occurs, the user may: start a RESET cycle. If an alarm persists, contact the after

­sales service.
There is no need to start a RESET cycle in the event of an alert

such as “No salt” or “Lack of detergent”; respond as

necessary to enable the device to function correctly.

2 HOSPITAL PROGRAMS

1 Prewash

11 Surgical instruments 93°C – 10’ [ + Drying ]

2 Demi prewash

12 Thermal disinfection 93°C - 3’ [ + Drying ]

3 Plastics 70°C 5’ (P3) [ + Drying ]

13 Thermal disinfection 93°C – 10’ [ + Drying ]

4 Short 60°C - 5’ (P3) [ + Drying ]

14 Intensive thermal disinfection 93°C – 10’ [ + Drying ]

5 Clogs 80°C - 7’ (P3) [ + Drying ]

15 Intensive plastics 70°C - 5’ (P3, P5) [ + Drying ]

6 Feeding bottles 93°C - 5’ [ + Drying ]

16 Intensive clogs 80°C - 5’ (P3, P5) [ + Drying ]

7 Surgical instruments 80°C – 10’ [ + Drying ]

17 Lenses 80°C – 10’ (P5) [ + Drying ]

8 Short surgical instruments 90°C - 1’ [ + Drying ]

18 Surgical instruments 80°C – 10’ (P5) [ + Drying ]

9 Surgical instruments 90°C - 5’ [ + Drying ]

19 Surgical instruments 93°C – 10’ (P5) [ + Drying ]

10 Surgical instruments 93°C - 5’ [ + Drying ]

20 Intensive prewash (P5) [+ Drying]

[+ Drying]: end-of-cycle drying phase, on models with Drying System only.