Smeg SA312XA-1 Specifications Sheet
two-zone 30cm ceramic cooktop
PLEASE NOTE
Smeg ceramic cooktops are highly-efficient cooking surfaces.
They are at their most efficient with flat-based cooking vessels.
We recommend stainless steel exterior-based vessels — that
is, the surface of the vessel making contact with the ceramic
surface be of stainless steel. High-quality cast-iron and castiron-based utensils might also be suitable for this ceramic
surface.
This flat stainless steel surface will help reserve the unblemished
look of the ceramic surface and avoid scratching and
permanent marking.
finish
size
cutout
installation
capacity
power connection
elements
safety
minute minder
cooking timer
warranty
all black ceramic, frameless bevelled
edging, touch control
510mmD x 290mmW x 45mmH
490mmD x 270mmW
built-in one-piece hob, topmount
2900 watts over two zones:
190mm diameter, 1700 watt
160mm diameter, 1200 watt
2900 watt total, 12.09 amp
hardwired or dedicated 15 amp
power cord and plug
series 8 ribbon
7 seconds full heat
• power ON LED
• residual heat LEDs for surface
temperatures above 60°C
0–99 minutes with audible signal
0–99 minutes STOP COOK with each
zone
two years parts and labour
INSTALLATION
At less than 30cm wide, the SA312XA-1 compact cooktop
is ideal for space-saving benchtop design. The height
displacement of 65mm allows space for installation below the
bench of drawers, an oven, or even a dishwasher.
RAPID HEAT
The series 8 ribbon elements are at full heat within seven
seconds — affording fast cooking and efficient electricity use.
Nine heat settings per zone cover all cooking intensities.
LOW MAINTENANCE
The easy wipe-over frameless surface is best maintained with
soapy water and the occasional ceramic cream conditioner.
SAFETY
As well as the power ON light, and the obvious glow of the
zones when at high heat, two ‘H’ LEDs respectively glow if
residual heat is above 60ºC.
ID100314
Code SA312XA-1
test cable
290
two-zone 30cm ceramic cooktop
hard-wired connection
or 15 amp power cord
and plug
512
40
5
Ø190
1700 watt
Ø160
1200 watt
PLAN
265
40
total wattage: 2900 watts = 12.09 amps
The cooktop must be hardwired, or connected
with a 15 amp-rated power cord and plug for a
dedicated 15 amp GPO
510
5
65
488
SIDE ELEVATION
terminal block for
hard-wired connection
OR 15 amp power cord
with 15 amp 3-pin plug for
dedicated 15 amp GPO
65
circuit
NB: test lead supplied and
connected
FRONT ELEVATION
NB: THESE DRAWINGS ARE NOT TO SCALE — THEY ARE TO ASSIST ONLY
WARNING: technical specifications and product sizes can be varied by the manufacturer, without notice.
Cutouts for appliances should only be by physical product measurements. The above information is
indicative only.
ID100314
Code SA312XA-1
Loading...