Smeg DOSCA36X-8 User Manual

DOSCA36X-8
double oven
operating and installation instructions
Contents
@
1. INSTRUCTIONS FOR USE ........................................................................... 4
2. SAFETY PRECAUTIONS .............................................................................. 6
3. ENVIRONMENTAL RESPONSIBILITY .......................................................... 8
4. GET TO KNOW YOUR OVEN........................................................................ 9
5. AVAILABLE ACCESSORIES ....................................................................... 10
6. FRONT PANEL ............................................................................................ 11
7. ELECTRONIC PROGRAMMER .................................................................. 14
8. USING THE OVEN ...................................................................................... 19
9. COOKING WITH THE OVEN....................................................................... 22
10. CLEANING AND MAINTENANCE ............................................................... 28
11. EXTRAORDINARY MAINTENANCE ........................................................... 30
12. INSTALLING THE APPLIANCE ................................................................... 34
INSTRUCTIONS FOR THE USER: these instructions contain user recommendations, a description of the controls and the correct procedures for cleaning and maintenance of the appliance.
INSTRUCTIONS FOR THE INSTALLER: these are intended for the authorized person who must install the appliance, set it functioning and carry out an inspection test.
Further product information is available from the website www.smeg.com
3
General instructions

1. INSTRUCTIONS FOR USE

This manual is an integral part of the appliance and must therefore be kept in its entirety and in an accessible place for the whole working life of the appliance. It is important to carefully read this manual and all the instructions contained herein before using the appliance. Installation must be carried out by competent persons in accordance with the regulations in force. This appliance is intended for household use and complies with te eec directives currently in force. The appliance has been built to carry out the following functions: cooking food; any other use is considered improper. The manufacturer cannot be held liable for use other than as indicated. This appliance has been manufactured to cook food, do not use the appliance to heat rooms.
Do not obstruct ventilation openings and heat dispersal slits.
Do not rest any weight or sit on the open door of the appliance.
The identification plate bearing the technical data, serial number and brand name is visibly applied on the appliance. Do not remove this plate for any reason.
Before the appliance is put into operation, all the protective films applied inside or outside must be removed.
4
Take care that no objects are stuck in the door of the oven.
The appliance becomes very hot during use. Suitable heat-proof gloves should be worn for all operations.
Do not use metallic sponges or sharp scrapers as they will damage the surface. Use normal non-abrasive products, including wooden or plastic utensils if necessary. Rinse thoroughly and dry using a soft cloth or chamois leather. Do not allow residues of sugary foods (such as jam) to set inside the oven. If they are allowed to set for too long, they could ruin the enamel covering the inside of the oven.
General instructions
Do not use plastic kitchenware or containers. The high temperatures inside the oven could melt the plastic, damaging the appliance.
Do not use sealed tins or containers in the appliance. Overpressure may occur inside the containers during cooking, creating a danger of explosion.
Do not leave the appliance unattended during cooking processes where fats or oils could be released. Fats and oils may catch fire.
Do not cover the bottom of the oven with aluminium or tinfoil sheets during cooking and do not place pans or trays on it to avoid damage to the enamelled surface.
If the surfaces are still very hot during cooking, do not pour water directly onto the trays. The steam could cause severe burns and damage to enamelled surfaces.
All cooking operations must be take place with the door closed.
5
General instructions

2. SAFETY PRECAUTIONS

Refer to the installation instructions for the safety regulations for electric or gas appliances and ventilation functions. In your interests and for your safety the law requires that the installation and servicing of all electrical appliances is carried out by qualified personnel in accordance with the regulations in force. Our approved installers guarantee a satisfactory job. Gas or electrical appliances must always be disconnected by suitably skilled people. Before connecting the appliance to the power grid, check the data on the plate against the data for the grid itself.
Before carrying out installation/maintenance work, make sure that the appliance is not connected to the power grid.
The plug to be connected to the power supply cable and its socket must be of the same type and conform to the regulations in force. The socket must be accessible after the appliance has been built in. Never disconnect the plug by pulling on the cable.
If the power supply cable is damaged, contact the technical support service immediately and they will replace it.
6
It is obligatory for all electrical equipment to be earthed according to the methods laid down by safety regulations.
Immediately after installation, carry out a brief inspection test, following the instructions below. Should the appliance not function, disconnect it from the electricity supply and call the nearest technical support centre. Never attempt to repair the appliance.
Do not use or leave flammable materials near the appliance or in the food warming compartment.
During use the appliance becomes very hot. take care not to touch the heating elements inside the oven.
This appliance must not be used by people (including children) of reduced physical and mental capacity, or lacking in experience in the use of electrical appliances, unless they are supervised or instructed by adults who are responsible for their safety.
General instructions
Do not let children go near the appliance when it is in operation or play with it at any time.
Do not insert pointed metal objects (cutlery or utensils) into the slits in the appliance.
If the appliance is installed on caravans or boats, it must not be used to heat rooms.
Do not use steam jets for cleaning the appliance. The steam could reach the electronics, damaging them and causing short­circuits.
Do not modify this appliance.
Do not spray any spray products near the electrical appliance while it is in operation. Do not use spray products while the product is still hot.
The manufacturer cannot be held liable for damage to persons or things caused by failure to observe the above instructions, by interference with any part of the appliance or by the use of non-original spare parts.
7
Instructions for disposal

3. ENVIRONMENTAL RESPONSIBILITY

3.1 Your environmental responsibility
Our product’s packing is made of non-polluting materials, which are therefore compatible with the environment and recyclable. Please help by disposing of the packaging correctly. You can obtain the addresses of collection, recycling and disposal centres from your retailer or from the competent local organisations.
Do not discard the packaging or any part of it, or leave it unattended. It can constitute a suffocation hazard for children, especially the plastic bags.
Your old appliance also needs to be disposed of correctly. Important: hand over your appliance to the local agency authorised for the collection of electrical appliances no longer in use. Correct disposal enables intelligent recovery of valuable materials. Before disposing of your appliance it is important to remove doors and leave
shelves in the same position as for use, to ensure that children cannot accidentally become trapped inside during play. It is also necessary to cut the connecting cable to the power grid, removing it along with the plug.
8
Instructions for the user
11121
8
9
10
4
3
2
7
6
5
1
2
3
4
5
3
6
4
6
7
8

4. GET TO KNOW YOUR OVEN

Control panel
Roof liner (mobile)
Bulb
Oven seal
Roof liner (fixed)
Pan and rack runners
Oven fan
Self-cleaning panels
9
Instructions for the user

5. AVAILABLE ACCESSORIES

NOTE: Some models are not provided with all accessories.
Rack: for holding cooking containers.
Tray r a ck: to be placed over the top of the oven
tray; for cooking foods which may drip.
Oven tray: for collecting fat from foods placed on the rack above.
10
Accessories available on request: Original supplied and optional accessories may be ordered from any Authorised Support Centre. Use original SMEG accessories only.
For the functions of the available accessories and their use, see chapter "8. USING THE OVEN".
Instructions for the user
11
12
1
8
9
10
4
3
2
7
6
5
1
3
4
2 6
8 8

6. FRONT PANEL

All the controls and indicator lights can be seen on the front panel. The symbol under each knob indicates the oven which it controls. The tables below describe the symbols used.
SMALL OVEN THERMOSTAT KNOB
The cooking temperature is selected by turning the knob clockwise to the desired setting, between 50°C and 270°C.
SMALL OVEN FUNCTION KNOB
Turn the knob clockwise or anti-clockwise to select a function for the small oven from the following options:
GRILL FUNCTION + TOP RESISTANCE
SMALL GRILL FUNCTION
+ BOTTOM RESISTANCE
TOP RESISTANCE + BOTTOM RESISTANCE
LARGE GRILL FUNCTION
In the small oven the function with the least energy consumption is
11
Instructions for the user
LARGE OVEN THERMOSTAT KNOB
The cooking temperature is selected by turning the knob clockwise to the desired setting, between 50°C and 250°C.
LARGE OVEN FUNCTION KNOB
Turn the knob clockwise or anti-clockwise to select a function for the large oven from the following options:
THAWING FUNCTION
LARGE GRILL FUNCTION
SMALL GRILL FUNCTION CIRCULAR FUNCTION
In the large oven the function with the least energy consumption is
SMALL GRILL FUNCTION + VENTILATION
LARGE GRILL FUNCTION + VENTILATION
12
Instructions for the user
ELECTRONIC PROGRAMMER - ANALOGUE CLOCK
The programming clock can be used to display the current time or to set a timer or cooking programme.
TIMER BUTTON VALUE DECREASE BUTTON
TIMED COOKING AND SCHEDULED COOKING BUTTON
CLOCK ADJUSTMENT AND RESET
VALUE INCREASE BUTTON
THERMOSTAT INDICATOR LIGHT (orange)
During the oven heating phase the thermostat light remains on. Once the oven has reached the set temperature the light turns off.
13
Loading...
+ 25 hidden pages