4730
1. Remove the back cover and the fastening
plates of the steam outlets by unscrewing
the screws indicated.
Do not remove the ventilation
outlet “A” and the protective cover
of the electrical connections “B”.
EN
3. Disconnect the contacts “C”, remove the
tie-wrap from the hose “D” and remove
the solenoid valve.
2. Remove the lower support cover and the
solenoid valve by removing the screws
indicated.
4. Assemble the pump “E” provided, with
the mounting bracket “F”, making sure
that you close the tab “G” by pressing it
with your hands. Then remove the caps
on the ends of the solenoid valve (“H1”
and “H2”).
4730
EN
5. Insert the grommet seal into the plate
provided.
6. Screw the plate, with grommet seal
installed in the previous step, onto the
lower support cover.
7. Connect the hose of the appliance “K” to
the end “H2” of the pump and connect
the tube supplied with the kit “L” to the
end “H1” (see step 4). Then secure them
using the tie-wraps provided.
8. Connect the sockets “M” of the cable
provided, to the terminals of the pump.
9. Connect the double cable connector
“N” provided, to the cables “C” of the
appliance that were disconnected in
step 3.
4730
11. Fasten the bracket to the lower strip of
the cover using the two self-tapping
screws (see the figure below).
10. Feed the tube “L” provided (see step 7)
though the grommet seal that is fastened
onto the lower cover.
Once finished, follow the instructions in
steps 1 and 2 in reverse to replace the
lower and back covers of the appliance.
When replacing the covers, make
sure that the electric cables do not
become trapped and/or pinched.
4730
12. Insert the tube into the hole in the cap of
the tank “P” and then place the filter “Q”
provided, onto the end of the tube.
13. Fill the tank with water and place the
tube inside it. Close it with the cap “P”.
Before carrying out a steam cooking
function:
After having installed the tank kit, it is best to
fill the water circuit of the appliance.
This should only be done when
using the new filling system for the
first time and then each time the
tank is filled.
1. Select a steam cooking function (without
food).
2. After preheating, turn the steam control
knob and keep it turned.
3. Release the knob when water starts to
enter the cooking cavity.
4. At this point, it is full and you can now turn
off the appliance.
EN
Loading...