Sinbo DZ-280/A, DZ-280/2SD, DZ-280/2SE Instruction Manual

Distributed By:

Doug Care Equipment, Inc.
PO Box 1058 Springville CA 93265
559 539-3076 FAX: [phone]
email: [e-mail]

 SAFETY FIRST

by making sure the power switch is in

detergent to clean the unit surface.

SAFETY

1.

Clean the machine using a mild detergent

 TROUBLESHOOTING

CAREFULLY READ ALL INSTURCTIONS BEFORE OPERATING
AND SAVE FOR FUTURE USE. YOUR SAFETY IS
IMPORTANT! FAILURE TO COMPLY WITH PROCEDURES
AND SAFEGUARDS MAY RESULT IN SERIOUS INJURY OR
PROPERTY DAMAGE.

• Always disconnect sealer from

power source before servicing,
changing accessories or cleaning the
unit

• Do not use the vacuum sealer if the

power cord, plug or any other parts
are damaged. If the power cord or
the vacuum sealer is damaged, call one
of our distributors. Do not attempt
to replace the cord. Check that all
parts are operating properly and
perform the intended functions

• Reduce risk of unintentional starting

the “OFF” position before attaching
to the power source

• To protect against electric shock do

not immerse the sealer in water or
any other liquid

• Do not place the sealer near the edge

of bench of table during operation.
Ensure the surface is level, clean and
free of water, residue, etc

• Do not leave the sealer unattended

when in use. Disconnect the vacuum
sealer from the power source before
leaving the work area

• The sealer is not intended for use by

children

• Do not overheat the machine. If

sealer overheats, machine will stop
working. Allow machine to cool
before turning on again

• Do not use vacuum sealer outdoors

• Protect your fingers when closing the

sealer lid

• Do not attempt to operate the sealer

by any other method other than those
described in the instructions

• Keep the sealer clean. Use a mild

Never rinse the sealer under the tap

• Do not seal any liquids unless you are

using the DZ-280/2SE model

• Always attach the filter canister when

sealing liquids (DZ-280/2SE only)

• Do not reuse bags after using with raw

meat or poultry

• Do not reuse vacuum bags with raw

meat, fish, or poultry or after heating
the bags (microwaved or simmered)

PROBLEM ACTION

SINBO does not turn
on

SINBO is not pulling a
vacuum

A proper seal is not
taking place

PRECAUTIONS

1. Check and ensure sealer is connected to the power outlet

2. Check power outlet

3. Check the heating element wire

4. Check to see if the machine has overheated. If so, allow
machine to cool before restarting

1. Ensure the lid is locked in place

2. Check that the bag is not overfilled or too empty

3. Check that the nozzle is not blocked by the bag

4. Clean and check the nozzle

5. Check for any leaks in the bag

6. For DZ-280/2SE, ensure the canister lid is tight and secure

1. Ensure the bag is flat

2. Check that the sealer is locked and a “click” is heard

3. Check that the seal bar pressed down fully

4. Check that the seal time is correct for your bag – increase or
decrease settings as needed

5. Make sure pressure on the seal bar is constant and equal
across the seal bar

6. Check the heating element and PTFE adhesive. Change if
needed

2. Do not overheat. When machine overheats, turn off
machine and allow machine to cool before using again

3. Do not place liquids or powdery substances

4. As machine warms up, seal time should get shorter. Check
the seal time and adjust accordingly

 SPECIFICATIONS

DZ-280/A DZ-280/2SD DZ-280/2SE

Seals Liquids No No Yes

Power Supply 110V or 220V 110V/60Hz 110V/60Hz

Vacuum Capacity 0.035 Mpa 0.045 Mpa 0.06 Mpa

Length of Seal 11”

Seal Width 2 line seal – 2mm 1 line – 4mm 1 line – 4mm

Seal Time Adjustable

Dimensions 14” x 5” x 3”

Weight 7lbs