VERVE
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE
USING THIS APPLIANCE
WARNING: The manufacturer cannot accept responsibility for damage caused when the appliance is not used according to the
instructions, or for uses other than those for which it was intended.
To reduce the risk of fire, electric shock or injury:
•Do not leave appliance when plugged in.
Unplug from outlet when not in use and before servicing.
•WARNING: ELECTRIC SHOCK COULD OCCUR IF USED OUTDOORS OR ON WET SURFACES.
•Do not allow to be used as a toy. Close attention is necessary when used by or near children.
•Use only as described in this manual.
Use only manufacturer’s recommended attachments.
•Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to your
Authorized Retailer for service.
•Do not pull or carry by cord, use cord as a handle, close a door on the cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
•Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
•Hold plug when rewinding the power cord to prevent the cord from whipping.
•Do not handle plug or appliance with wet hands.
•Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair and anything that may reduce air flow.
•Keep hair, loose clothing, fingers and all parts of body away from openings and moving parts.
•Do not pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes.
•Do not use without vacuum bag in place.
•Turn off all controls before unplugging.
•Use extra care when cleaning on stairs.
•Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present.
•Do not attempt to service the unit while appliance is plugged in.
•Do not use vacuum to pick up water or any wet materials.
SAVE THESE INSTRUCTIONS.
Contents
Safety Precautions |
4 |
Replacing Vacuum Bag and Filters |
5 |
Description and Operation |
6-8 |
Using the Full Size Power Nozzle |
9-12 |
Troubleshooting Guide |
13 |
Owner’s Information |
14 |
Warranty |
15 |
Safety Precautions
This vacuum cleaner should be used for normal, dry household dust and dirt. The manufacturer cannot be held responsible for any damage caused by use or operation of the vacuum contrary to these instructions. If the vacuum is wrongly operated for a purpose other than that for which it is intended, no liability can be accepted for any possible damage.
•Do not vacuum areas which contain moisture or water, flammable matter, needles, pins, razor blades, matches, cigarettes, etc., since they may damage the vacuum or vacuum bag.
•When rewinding the power cord, hold the plug before pressing the cord rewind button to prevent the cord from whipping.
•Make sure a vacuum bag and filters are always in place.
•This product is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). This plug fits into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact an electrician to replace the obsolete outlet. Do not defeat the safety purpose of the polarized plug.
4
Replacing Vacuum Bag and Filters
Replacing the vacuum bag |
Change the vacuum bag when the full bag indicator |
|
|
||
|
light is flashing RED or suction power is weak. The |
|
|
bag compartment will not close without a bag in the |
|
|
unit or if the bag is not properly installed. |
|
|
1. Open the bag compartment. |
|
|
2. |
Pull the tab on the cardboard bag collar, closing |
|
|
the bag while removing it from the bag holder. |
|
3. |
Remove and discard the used bag. NOTE: |
|
|
The Performance HEPA™ bag cannot be reused. |
|
4. |
Slide a new bag into the bag holder until it |
|
|
clicks into place. |
When to change filters
At minimum, it’s recommended to replace the HEPA and charcoal filter after using twelve vacuum bags.
If someone in your household is sensitive to airborne allergens, it is recommended to change the filter set after every six vacuum bags.
Replacing the secondary filter
1. Open the bag compartment and locate the filter behind the vacuum bag. For better access to the secondary filter, remove the bag.
2. Pull the filter holder out toward you.
3. Remove the used filter and replace it with a new filter.
4.Slide the filter holder back in place and replace the bag.
Replacing the HEPA filter
1. Push in and lift off the filter cover on the top of the vacuum.
2. Lift out the used HEPA filter and replace with a new filter.
NOTE: The HEPA filter cannot be washed and reused.
5
Loading...