Silex Technology SDMAN2 Users Manual

User Manual

Since this module is not sold to general end users directly, there is no user manual of
module.

For the details about this module, please refer to the specification sheet of module.

This module should be installed in the host device according to the interface specification
(installation procedure).

For OEM

Antenna Type Model

Antenna Gain

External printed PCB antenna

1

:Unictron
On board chip antenna

2

:Unictron
Sleeve antenna

3

: SANSEI
Embedded Antenna

4

: Ethertronics

2.4GHz

H2B1PC1A1C 1.8dBi 3.9dBi For WLAN and Bluetooth

H2U84W1H1S 1.4dBi 2.3dBi For WLAN and Bluetooth

ANTDC-081A0 2.0dBi 2.1dBi For WLAN

1000418 2.5dBi 3.5dBi For WLAN

5GHz

Note

The following information must be indicated on the host device of this module;

[for FCC]

Contains Transmitter Module FCC ID: N6C-SDMAN2

or

Contains FCC ID: N6C-SDMAN2

[for IC]

Contains Transmitter Module IC: 4908A-SDMAN2

or

Contains IC: 4908A-SDMAN2

[for FCC and IC]

This device complies with Part 15 of FCC Rules and Industry Canada’s
licence-exempt RSSs. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Le présent appareil est conforme à la partie 15 des règles de la FCC et aux normes
des CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'appareil doit accepter tout brouillage subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.

*If it is difficult to describe this statement on the host product due to the size, please describe in
the User's manual.