SIG SAUER STL-081 User Manual

STS-081 MINI RED DOT SIGHT

OWNER’S MANUAL

STS-081 MINI RED DOT SIGHT

The STS-081 Mini Red Dot Sight is a versatile and lightweight sighting solution for handguns, riﬂes and shotguns. A parallax free 1X red dot with 4 MOA reticle, coated glass lenses and anodized aluminum construction ensures optimal performance in the most extreme conditions. Removable honeycomb ﬁlter reduces glare and prevents lens reﬂection during bright sunlight applications.

CONTENTS

1. STS-081 Mini Red Dot Sight 2. Owner’s Manual 3. 3V CR2032 Lithium Battery 4. Allen key 5. Rubber lens & reticle cover

FEATURES

•12-position rotary on/off switch

• Windage & elevation adjustments

• Anti-reﬂex & multilayer band pass optical coating

• M1913/Weaver rail mount

STS-081 MINI RED DOT SIGHT

System

Magniﬁcation

Eye Relief

Parallax

Reticle size

Optical coating

Battery type

Battery life, typical

Switch settings

Material housing

Surface ﬁnish

Adjustment

Adjustment range

Mounting

Temp range

Water resistance

Length/width

Weight

Passive red dot collimator

Unlimited

free - no centering required

4 MOA (minute of angle)

Anti-reﬂex & multilayer band pass

(1) 3V CR2032 lithium

8000 hours position 1

1 off / 11 on varying intensities

Extruded aluminum

Anodized

13mm@100m /

+/- 1.4m @ 100 meters windage & elevation

M1913 / Weaver

-5 degrees F to + 130 degrees F

0.5m for 20 minutes

2.7” x 1.7” (68mm x 42mm) Length 3.0” (76mm) with ﬁlter installed

4.5oz / 126g (4.7oz / 132g with ﬁlter installed)

/2”@100yds

STS-081

REAR

ELEVATION ADJUSTMENT TURRET

1X MAGNIFICATION 4 MOA RETICLE PASSIVE RED DOT

WINDAGE ADJUSTMENT TURRET

ANODIZED ALUMINUM CASE

M1913 / WEAVER MOUNT

FRONT

ANTI-REFLEX & MULTILAYER BAND PASS COATING

REMOVABLE HONEYCOMB FILTER

ROTARY ON/OFF WITH 11 DAYLIGHT SETTINGS

3V CR2032 LITHIUM BATTERY 8000 HOURS TYPICAL LIFE

INSTRUCTIONS

Install battery:

• Unscrew battery cover, using coin, then thumb/forenger

• Position battery + facing out

• Reattach battery cover, tighten completely to o-ring

Mounting on ﬁrearm: To mount on M1913/Weaver accessory rail:

• Loosen locking bolt using provided allen key.

• Mount on rail, and secure by tightening locking bolt.

Getting Started:

• STS-081 is ON in switch settings 1 – 11, with varying intensities.

• Adjust red dot windage and elevation by removing turret covers and using

coin or screwdriver - counterclockwise: move impact left/up - clockwise: move impact right/down. 1 click = 13mm@100m / once set.

BATTERY HAZARD WARNING

Battery manufacturers warn against mixing new and used batteries or different brand batteries together as this may increase the risk of leakage, ﬁre or explosion. Do not, puncture, short-circuit, disassemble or heat batteries above 212°F (100°C). Do not recharge the batteries unless they are speciﬁcally designed as rechargeable batteries and then only in accordance with manufacturer’s directions.

Lithium Batteries: Industry wide there have been reported incidents of off-brand Lithium batteries exploding or catching ﬁre creating serious consequences. Sig Sauer, Inc. includes batteries from Duracell® and other well-known battery manufacturers with its products, and strongly urges you to only purchase replacement batteries from Duracell®, or other well-known battery manufacturers like Panasonic® and Rayovac®. These batteries are designed for use in high performance, high-drain devices, and their designs incorporate fault and heat protection for added safety. Use of inferior batteries may cause an explosion or ﬁre, creating risk of damage to your device that will void the SIG Sauer Inc. warranty, cause damage to other property, and potentially serious injury or death.

/2”@100 yds. Secure covers

STATEMENT OF LIABILITY

This device is classiﬁed as a FIREARMS ACCESSORY and is sold by us with the speciﬁc understanding that we are not responsible in any manner whatsoever for its safe handling or resale under local laws and regulations. SIG SAUER lnc. shall not be responsible in any manner whatsoever for malfunctioning of the ﬁrearm, for physical injury or for property damage resulting in whole or in part from (I) criminal or negligent discharge, (2) improper or careless handling, (3) unauthorized modiﬁcations, (4) defective, improper, hand-loaded, or reloaded ammunition, (5) corrosion, (6) neglect, or (7) other inﬂuences beyond our direct and immediate control. This limitation applies regardless of whether liability is asserted on the basis of contract, negligence or strict liability (including any failure to warn). Under no circumstances shall SIG SAUER Inc. be liable for incidental or consequential damages, such as loss of use of property, commercial loss and loss of earnings or proﬁts.

SIG SAUER® LIMITED ONE YEAR WARRANTY

SIG SAUER® warrants that the enclosed accessory was originally manufactured free of defects in material, workmanship and mechanical function, and agrees to correct these defects by repair, adjustment or replacement, at the option of SIG SAUER, with items of the same or comparable quality; provided, however, that the accessory is returned freight prepaid to SIG SAUER at 18 Industrial Drive, Exeter, NH 03833 by the original purchaser within one year of the date of purchase.

This limited warranty is null and void if the accessory has been misused, damaged (by accident or otherwise), or if unauthorized repair or any alteration, including of a cosmetic nature, has been performed on the accessory. This limited warranty does not apply to normal wear and tear of any parts.

Subject to the foregoing, this limited warranty confers the right to have the covered accessory or its parts repaired, adjusted or replaced exclusively by the original purchaser, which right is not transferable to any other person. NO IMPLIED WARRANTIES OF ANY KIND, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE MADE HEREIN, and this warranty does not apply to any accessory items attached or appurtenant to this accessory. In no event shall SIG SAUER be liable for incidental or consequential damages arising from or in connection with this limited warranty.

CONTACT

18 Industrial Drive, Exeter, NH 03833 (603) 772-2302 • www.sigsauer.com

P/N 8500479 Rev. 4/11