Shure MX410WRLP/N User Manual

MX405 and MX410 Miniature Gooseneck Microphones

Overview

Flexible in more ways than one, Microflex Miniature Gooseneck microphones deliver unsurpassed style and performance for conference rooms and similar
applications. Offering desktop or mounted bases, wired or wireless options, and even interchangeable cartridges, it’s easy to get the perfect fit for your
conferencing installation. Fully compatible with SLX® wireless systems, including the SLX4L wireless receiver with logic output for applications requiring
logic functionality.

Specifications (subject to change)

Type

Frequency Response

Polar Pattern (at 1 kHz)

Output Impedance

Output Configuration

Sensitivity (at 1 kHz , open circuit voltage)

Maximum SPL (1 kHz at 1% THD, 1 kW load)

Equivalent Output Noise (A-weighted)

Signal-to-Noise Ratio
(referenced at 94 dB SPL at 1 kHz)

Dynamic Range (1 kΩ load at 1 kHz)

Common Mode Rejection (10 Hz to 100 kHz)

Preamplifier Output Clipping Level (1% THD)

Polarity

Weight

Logic Connections

Mute Switch Attenuation

Cable

Environmental Conditions

Power Requirements

Condenser (electret bias)

50–17000 Hz

MX405/C, MX410/C: Cardioid
MX405/S, MX410/S: Supercardioid

EIA Rated at 150 Ω (170 Ω actual)

Active Balanced

Cardioid: –35 dBV/Pa (18 mV)
Supercardioid: –34 dBV/Pa (21 mV)
1 Pascal=94 dB SPL

Cardioid: 121 dB
Supercardioid: 120 dB

Cardioid: 28 dB SPL
Supercardioid: 27 dB SPL

Cardioid: 66 dB
Supercardioid: 68 dB

93 dB

45 dB minimum

-8 dBV (0.4 V)

3-Pin XLR: Positive sound pressure on diaphragm produces positive voltage on pin 2
relative to pin 3 of output XLR connector.
5-Pin XLR: Positive sound pressure on diaphragm produces positive voltage on pin 4
relative to pin 2 of output XLR connector.

MX405: 0.054 kg (0.119 lbs)
MX410: 0.068 kg (0.150 lbs)
MX400DP: 0.516 kg (1.138 lbs)
MX400SMP (w/ Kit): 0.125 kg (0.275 lbs)

LED IN: Active low (≤1.0V), TTL compatible. Absolute maximum voltage: -0.7V to 50V.
LOGIC OUT: Active low (≤1.0V), sinks up to 20mA, TTL compatible. Absolute maximum
voltage: -0.7V to 50V (up to 50V through 3kΩ).

-50 dB minimum

MX400DP: 6.1 m (20 ft) attached cable with shielded audio pair terminated at a 3-pin
male XLR and three unterminated conductors for logic control

Operating Temperature: -18–57 °C (0–135 °F)
Storage Temperature: -29–74 °C (-20–165 °F)
Relative Humidity: 0–95%

48–52 Vdc phantom, 8.0 mA

*for detailed dimensions please
reference MX405/410 user
guide

MX410 and MX405
Miniature Goosenecks

Available Models

The polar pattern of the cartridge is indicated by the model number suffix: C = Cardioid, S = Supercardioid, N = No Cartridge

MX405/C, MX405/S

MX405R/N

MX410/C, MX410/S

MX410R/N

MX405LP/C, MX405LP/S

MX405RLP/N

MX410LP/C, MX410LP/S

MX410RLP/N

www.shure.com

5 inch (127 mm) Gooseneck, bi-color status indicator ring, includes surface mount preamp

5 inch (127 mm) Gooseneck, light ring, includes surface mount preamp

10 inch (254 mm) Gooseneck, bi-color status indicator ring, includes surface mount preamp

10 inch (254 mm) Gooseneck, no cartridge, light ring, includes surface mount preamp

5 inch (127 mm) Gooseneck, bi-color status indicator ring, less preamp

5 inch (127 mm) Gooseneck, no cartridge, light ring, less preamp

10 inch (254 mm) Gooseneck, cardioid, bi-color status indicator ring, less preamp

10 inch (254 mm) Gooseneck, no cartridge, light ring, less preamp

MX400SMP
Surface Mount Preamp

MX400DP
Wired Desktop Base (also available as MX890
Wireless Desktop Base)

MX405 and MX410 Miniature Gooseneck Microphones

Optional Accessories and Replacement Parts

MX400SMP

MX400DP

MX890

Surface Mount Preamp

Wired Desktop Base. Includes
10 ft. (6.1 M) attached cable

Wireless Desktop Base. Compat­ible with SLX wireless systems

Furnished Accessories

Models with included Preamp All Models

MX400SMP

65A2166

65A2190

95A1118

65A2166

Surface Mount Preamp

Rubber Isolation Rings

Wing Nut

5 Pin XLR-F

Cap

Black Cardioid Cartridge for All

R185B

Microflex Models

Black Supercardioid Cartridge for

R184B

All Microflex Models

Black Omnidirectional Cartridge for

R183B

All Microflex Models

RK513WS

Snap-Fit Foam Windscreen

A412MWS

95A2487

RK412WS

Metal Locking Windscreen

Tapered Windscreen

Microflex Windscreen (4pk)

A99WS

Big Foam Windscreen

Architectural Specifications

MX405/C - The microphone shall be an electret condenser 5” gooseneck microphone (12,7 cm) with cardioid polar pattern, black finish, and
logic controlled bi-colored status indicator. The microphone shall be mounted in the included MX400SMP preamp. The microphone shall be
resistant to RF interference from portable mobile and handheld devices. The frequency response shall be 50 Hz to 17 kHz and the sensitivity
shall be 18 mV/Pa.

MX405/S - The microphone shall be an electret condenser 5” gooseneck microphone (12,7 cm) with supercardioid polar pattern, black finish,
and logic controlled bi-colored status indicator. The microphone shall be mounted in the included MX400SMP preamp. The microphone
shall be resistant to RF interference from portable mobile and handheld devices. The frequency response shall be 50 Hz to 17 kHz and the
sensitivity shall be 21 mV/Pa.

MX410R/N - The microphone shall be an electret condenser 10” gooseneck microphone (25,4 cm) with no included cartridge, black finish,
and logic controlled, upper red light ring status indicator. The microphone shall be mounted in the included MX400SMP preamp. The
microphone shall be resistant to RF interference from portable mobile and handheld devices.

MX410/C - The microphone shall be an electret condenser 10” gooseneck microphone (25,4cm) with cardioid polar pattern, black finish, and
logic controlled bi-colored status indicator. The microphone shall be mounted in the included MX400SMP preamp. The microphone shall be
resistant to RF interference from portable mobile and handheld devices. The frequency response shall be 50 Hz to 17 kHz and the sensitivity
shall be 18 mV/Pa.

MX410/S - The microphone shall be an electret condenser 10” gooseneck microphone (25,4cm) with supercardioid polar pattern, black fin­ish, and logic controlled bi-colored status indicator. The microphone shall be mounted in the included MX400SMP preamp. The microphone
shall be resistant to RF interference from portable mobile and handheld devices. The frequency response shall be 50 Hz to 17 kHz and the
sensitivity shall be 21mV/Pa.

MX410R/N - The microphone shall be an electret condenser 10” gooseneck microphone (25,4 cm) with no included cartridge, black finish,
and logic controlled, upper red light ring status indicator. The microphone shall be mounted in the included MX400SMP preamp. The
microphone shall be resistant to RF interference from portable mobile and handheld devices.

MX405LP/C - The microphone shall be an electret condenser 5” gooseneck microphone (12,7 cm) with cardioid polar pattern, black finish,
and logic controlled bi-colored status indicator. The microphone shall be compatible with the MX400SMP or MX890. The microphone shall
be resistant to RF interference from portable mobile and handheld devices. The frequency response shall be 50 Hz to 17 kHz and the
sensitivity shall be 18 mV/Pa.

MX405LP/S - The microphone shall be an electret condenser 5” gooseneck microphone (12,7 cm) with supercardioid polar pattern, black
finish, and logic controlled bi-colored status indicator. The microphone shall be compatible with the MX400SMP or MX890. The microphone
shall be resistant to RF interference from portable mobile and handheld devices. The frequency response shall be 50 Hz to 17 kHz and the
sensitivity shall be 21 mV/Pa.

MX410RLP/N - The microphone shall be an electret condenser 10” gooseneck microphone (25,4 cm) with no included cartridge, black
finish, and logic controlled, upper red light ring status indicator. The microphone shall be compatible with the MX400SMP or MX890. The
microphone shall be resistant to RF interference from portable mobile and handheld devices.

MX410LP/C - The microphone shall be an electret condenser 10” gooseneck microphone (25,4cm) with cardioid polar pattern, black finish,
and logic controlled bi-colored status indicator. The microphone shall be compatible with the MX400SMP or MX890. The microphone
shall be resistant to RF interference from portable mobile and handheld devices. The frequency response shall be 50 Hz to 17 kHz and the
sensitivity shall be 18 mV/Pa.

MX410LP/S - The microphone shall be an electret condenser 10” gooseneck microphone (25,4cm) with supercardioid polar pattern, black
finish, and logic controlled bi-colored status indicator. The microphone shall be compatible with the MX400SMP or MX890. The microphone
shall be resistant to RF interference from portable mobile and handheld devices. The frequency response shall be 50 Hz to 17 kHz and the
sensitivity shall be 21 mV/Pa.

MX410RLP/N - The microphone shall be an electret condenser 10” gooseneck microphone (25,4 cm) with no included cartridge, black
finish, and logic controlled, upper red light ring status indicator. The microphone shall be compatible with the MX400SMP or MX890. The
microphone shall be resistant to RF interference from portable mobile and handheld devices.

www.shure.com

©2007 Shure Incorporated

United States:

Shure Incorporated
5800 West Touhy Avenue
Niles, IL 60714-4608 USA
Phone: [phone]
Fax: [phone]
Email: [e-mail]

Europe, Middle East, Africa:

Shure Europe GmbH
Wannenäckerstr. 28,
74078 Heilbronn, Germany
Phone: [phone]
Fax: [phone]
Email: [e-mail]

Asia, Pacific:

Shure Asia Limited
3/F, Citicorp Centre
18 Whitfield Road
Causeway Bay, Hong Kong
Phone: [phone]
Fax: [phone]
Email: [e-mail]

+20

+10

0

dB

ñ10

-20

20 2000010001000050 100

+20

+10

0

dB

ñ10

-20

20 2000010001000050 100

Cardioid

9876543298765432

Hz

Supercardioid

9876543298765432

Hz

Canada, Latin America, Caribbean:

Shure Incorporated
5800 West Touhy Avenue
Niles, IL 60714-4608 USA
Phone: [phone]
Fax: [phone]
Email: [e-mail]