SHOWTEC INDOOR DMX LED BAR 8 User Manual

DMX Indoor LED BAR manual

Our DMX indoor LED BAR (8 sections) offers many possibilities to achieve the effects which you want. The rolling
and chasing effects are very good. It is designed for the stages, disco, night clubs etc, even the building halls. Please
read the manual before operation.

A. SPECIFICATION:

1. Weight: 2.6kgs

2. Size: 1070x65x88mm

3. Power input: AC90-240V/50-60HZ

4. Wattage: 36W

5. LEDS: 320(128 red,96 green, 96 blue) 10mm LEDs

6. Beam angle: 40 degree

7. 3 pin female XLR socket and 3 pin male XLR socket

8. 3 pin XLR Power in and power out
9, Linkable via 3-pin XLR cable

10. Built-in microphone
11, Black aluminium material (white housing optional)

12. Working place: indoor, temperature: -20 °C~+ 45° C, humidity: 0%-90%.
13． LED display for easier operation.

14. Built-in programs, Auto running, DMX mode, M/S, sound-active mode, static color

15. 6 selectable DMX modes: 2, 3, 4, 7, 14, 26 DMX channels mode.
The picture for the rear panel:

B.OPERATION:

After power on, Press “MODE”button to activate the main menu: Built-in programs mode, Auto running mode,
DMX mode, Slave mode, sound-activited mode.

“SETUP” is to set the relative specification for current mode.
“UP” is to add the value of current specification.
“DOWN” is to decrease the value of current specification.

Built-in programs-- running one of 22built-in programs
Auto run—running built-in programs one after another in continuous loop.
DMX mode--controlled by DMX controller
Slave mode—the projectors in this mode will be synchronously run with the projectors in master mode
Sound active mode-- running by sound - activated
Static color mode: you can set 255*255*255 static colors.

1. built-in programs mode

Press mode until it shows Prxx, you can select 22 different built-in Programs. press“SETUP”and “UP”
“DOWN” buttons to select the programs (from Pr01 to Pr22) and select the desired program values.

When it shows Pr01, press “SETUP” to choose the seven static color.

When it is Pr02 to Pr22, press “SETUP” and “UP” “DOWN” buttons, you can set the values for