Sherwood TX-5505iD Operating Instructions Manual
TX-5505iD
AM/FM/DAB/i-RADIO TUNER
OPERATING INSTRUCTIONS
5505(G) cover_cover.qxp 2010-10-08 오후 12:07 페이지 1
ENGLISH
2
ENGLISH
Introduction
: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
T
his symbol is intended to alert the user to the presence of
uninsulated "dangerous voltage" within the product's
enclosure that may be of sufficient magnitude to constitute
a risk of electric shock to persons.
T
his symbol is intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR
BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO
Q
UALIFIED SERVICE PERSONNEL.
CAUTION
WARNING
Units shipped to Australia are designed for operation on 230 V AC only.
To ensure safe operation, the three-pin plug supplied must be inserted only into a standard threepin power point which is effectively earthed through the normal household wiring. Extension cords
used with the equipment must be three-core and be correctly wired to provide connection to earth.
Improper extension cords are a major cause of fatalities. The fact that the equipment
operates satisfactorily does not imply that the power point is earthed and that the installation
is completely safe. For your safety, if in any doubt about the effective earthing of the power
point, consult a qualified electrician.
PAN-EUROPEAN UNIFIED VOLTAGE
All units are suitable for use on supplies 220-240 V AC.
FOR YOUR SAFETY
EUROPE
AUSTRALIA
220 V
-
240 V
READ THIS BEFORE OPERATING YOUR UNIT
CAUTION
•
Leave a space around the unit for sufficient ventilation.
•
Avoid installation in extremely hot or cold locations, or in an area
that is exposed to direct sunlight or heating equipment.
•
Keep the unit free from moisture, water, and dust.
•
Do not let foreign objects in the unit.
•
The ventilation should not be impeded by covering the ventilation
openings with items, such as newspapers, table-cloths, curtains,
etc.
•
No naked flame sources, such as lighted candles, should be
placed on the unit.
•
Please be care the environmental aspects of battery disposal.
•
The unit shall not be exposed to dripping or splashing for use.
•
No objects filled with liquids, such as vases, shall be placed on
the unit.
• Do not let insecticides, benzene, and thinner come in contact
with the set
.
•
Never disassemble or modify the unit in any way.
■Notes on the AC power cord and the wall outlet.
•
The unit is not disconnected from the AC power source(mains)
as long as it is connected to the wall outlet, even if the unit has
been turned off.
•
To completely disconnect this product from the mains,
disconnect the plug from the wall socket outlet.
•
When setting up this product, make sure that the AC outlet you
are using is easily accessible.
•
Disconnect the plug from the wall outlet when not using the unit
for long periods of time.
Information for Users on Collection and Disposal of
Old Equipment and used Batteries
These symbols on the products, packaging, and/or
accompanying documents mean that used electrical and
electronic products and batteries should not be mixed
with general household waste. For proper treatment,
recovery and recycling of old products and used
batteries, please take them to applicable collection
points, in accordance with your national legislation.
By disposing of these products and batteries correctly,
you will help to save valuable resources and prevent any
potential negative effects on human health and the
environment which could otherwise arise from
inappropriate waste handling.
For more information about collection and recycling of
old products and batteries, please contact your local
municipality, your waste disposal service or the point of
sale where you purchased the items.
[Information on Disposal in other Countries outside the
European Union]
These symbols are only valid in the European Union. If
you wish to discard these items, please contact your
local authorities or dealer and ask for the correct method
of disposal.
Note for the battery symbol (bottom two symbol
examples):
The sign Pb below the symbol for batteries indicates that
this batteries contains lead.
TX-5505iD(G)_ENG_101110_TX-5505iD(G)_ENG 2010-11-10 오전 9:30 페이지 2
3
ENGLISH
CONTENTS
Introduction
• READ THIS BEFORE OPERATING YOUR UNIT | 2
Rear Panel Connections | 4
Front Panel & Remote Controls | 7
• REMOTE CONTROL OPERATION RANGE | 9
• LOADING BATTERIES | 9
Operations
• LISTENING TO RADIO BROADCASTS | 10
• LISTENING TO RDS BROADCASTS (FM ONLY) | 14
• LISTENING TO INTERNET RADIO BROADCASTS, DAB/DAB+ BROADCASTS | 16
• ADJUSTING THE BRIGHTNESS OF THE FLUORESCENT DISPLAY | 24
Troubleshooting Guide | 25
Specifications | 26
TX-5505iD(G)_ENG_101110_TX-5505iD(G)_ENG 2010-11-10 오전 9:30 페이지 3
ENGLISH
4
A
NALOG
R
L
ASSEMBLED IN CHINA
DESIGNED IN USA
A
M/FM/DAB/ i-RADIO TUNER
230V 50Hz
1
1W
TX-5505iD
P
OWER SOURCE
P
OWER CONSUMPTION
A
VIS : RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR.
WARNING : SHOCK HAZARD-DO NOT OPEN.
C
OAX OPT
D
AB 75
W
LAN
DIGITAL
ANTENNA
FM 75
ANTENNA
G
ND
A
M
LOOP
SN.
12 3 4 5 6
Rear Panel Connections
• Do not plug the AC input cord into the AC outlet when making connections.
• Be sure to connect the white plugs to the L(Left) jacks and the red plugs to the R (Right) jacks when making
connections.
• Refer to the connecting diagram in the operating instructions of your amplifier.
1. CONNECTING AM AND FM ANTENNAS
• Change the position of the FM indoor antenna until you get
the best reception of your favourite FM stations.
• Place the AM loop antenna as far as possible from the receiver, TV set, speaker cords and the AC
input cord and set it to a direction for the best reception.
• If the reception is poor with the AM loop antenna, an AM outdoor antenna can be used in place of
the AM loop antenna.
• A 75Ω outdoor FM antenna may be used to further
improve the reception. Disconnect the i nd oo r
antenna before replacing it with the outdoor one.
FM 75
ANTENNA
GND
AM
LOOP
FM 75
ANTENNA
GND
AM
LOOP
FM 75
ANTENNA
GND
AM
LOOP
TX-5505iD(G)_ENG_101110_TX-5505iD(G)_ENG 2010-11-10 오전 9:30 페이지 4
ENGLISH
5
• To connect this unit to a broadband home network wirelessly to listen to internet radio broadcast, connect the
WLAN antenna to the WLAN terminal.
• This unit is equipped with an IEEE802.11n(2.4 GHz band only) wireless module, which also supports the
802.11 b/g standards.
■Notes :
• After making a broadband internet connection, you should set the communication settings.
(For details, see “When selecting “Set Network”” on page 23.)
• When using a broadband internet connection, a contract with an internet service provider is required.
For more information, contact your nearest internet service provider.
• Refer to the operating instructions of the equipment because the connected equipment and connection method
may differ depending on your internet environment.
2. CONNECTING WLAN ANTENNA
3. CONNECTING DAB ANTENNA
Wireless router or
Access point
WLAN
• Connect the DAB indoor antenna to the DAB ANTENNA terminal.
• Use the “Signal Strength” display to set position at which reception sensitivity is optimum.
(For details, see “Displaying DAB/DAB+ information” on page 22.)
• If good reception cannot be achieved with the supplied DAB indoor antenna, use an DAB outdoor antenna.
Connect an F male type connector to the coaxial cable and connect the antenna to the DAB ANTENNA
terminal.
■Note :
• A magnet is located on the bottom surface of the DAB indoor antenna. Keep it away from monitors, etc.
DAB 75
ANTENNA
Mount the antenna’s screw to the stand.
* An access point is a device that allows you to connect to your home network wirelessly.
DAB indoor antenna
DAB indoor antenna
TX-5505iD(G)_ENG_101110_TX-5505iD(G)_ENG 2010-11-10 오전 9:30 페이지 5
ENGLISH
6
• Connect the ANALOG L and R jacks to the TUNER IN jacks of your amplifier.
4. CONNECTING ANALOG AUDIO OUTS
ANALOG
R
L
Amplifier
TUNER
IN
• If you want to enjoy listening to the digital audio output of DAB and internet radio, connect the OPTICAL or the
COAXIAL DIGITAL OUT to the corresponding DIGITAL IN of your amplifier. (You don’t neet to do both.)
5. CONNECTING DIGITAL AUDIO OUTS
• Plug the cord into a wall AC outlet.
6. AC INPUT CORD
COAX OPT
DIGITAL
Amplifier
OPTICAL IN
COAXIAL IN
or
TX-5505iD(G)_ENG_101110_TX-5505iD(G)_ENG 2010-11-10 오전 9:30 페이지 6
ENGLISH
7
Front Panel & Remote Controls
S
TANDBY
T
UNING / PRE SET
D
IMMER T/P MODE
MENU
B
AND AUTO PRESET
BACK
O
N/STANDBY
AM/ FM/DAB /i-RADIO TUNER
T
X-5505iD
SECONDARYSTEREO TUNED RDS
12 345 768910 14 16 11
1-a
15
14
22
12
16
13
9
21
20
19
18
1-b
17
Front panel controls
Remote controls
TX-5505iD(G)_ENG_101110_TX-5505iD(G)_ENG 2010-11-10 오전 9:30 페이지 7
ENGLISH
8
13. PRESET UP/DOWN (+/-) buttons
Press these buttons to tune in the preset stations
without selecting the preset mode.
When adding the Internet radio station to the list of
your favourite stations, use the PRESET UP(+) button.
When deleting the Internet radio station on the list, use
the PRESET DOWN(-) button.
14. BAND button
Press this button to select the desired band.
• Each time this button on the front panel is pressed,
the band and the FM mode change as follows :
→ FM STereo →FM MONO → AM → digital broadcast
• Each time this button on the remote control is
pressed, the band changes as follows :
→ FM → AM → digital broadcast
15. STEREO/MONO button
When listening to FM broadcasts, press this button to
select the STereo mode or the MONO mode
depending on the strength of broadcst signal.
16. AUTO PRESET(/BACK) button
Press this button to automatically search for FM
stations and to store them in the memory.
When this button on the front panel is pressed on a
system setting menu, the previous menu will be
returned to.
17. AUTO TUNING button
Press this button to search for a station of sufficient
strength automatically.
18. NUMERIC(0~9) buttons
Press these buttons to specify the preset number of the
station directly to be recalled or stored in the memory.
19. MEMORY button
Press this button to store the desired stations manually
in the memory.
20. MENU/RDS button
When listening to FM broadcasts, press this button to
enter the RDS menu.
When listening to the Internet radio broadcasts or
DAB/DAB+ broadcasts, press this button to enter the
main menu.
21. CURSOR ▲/▼/◀/▶and ENTER buttons
Press the CURSOR ▲/▼/◀/▶ buttons to select items,
etc. then press the ENTER button to confirm your
selection.
22. DISPLAY button
Press this button to display information on the station
that are broadcasting.
1. POWER ON/STANDBY button
Each time the POWER ON/STANDBY button is
pressed, this unit is turned on to enter the operating
mode or off to enter the standby mode.
a. In the standby mode, press the POWER ON button to
enter the operating mode.
b. In the operating mode, press the STANDBY button to
enter the standby mode.
2. STANDBY indicator
When this unit is turned off, this indicator lights up.
3. STEREO indicator
When FM broadcasts are reproduced in stereo sound,
this indicator lights up.
4. TUNED indicator
When a station of sufficient strength is tuned in, this
indicator lights up.
5. RDS indicator
When RDS broadcasts are received, this indicator lights
up.
6. SECONDARY indicator
When a secondary service is available, this indicator
lights up.
7. Remote sensor
This receives the signals from the remote control unit.
8. Fluorescent display
This displays operation status, frequency, RDS
information, etc.
9. DIMMER button
Each time this button is pressed, the brightness of the
fluorescent display changes as follows :
→ ON → dimmer → OFF
10. TUNING/PRESET MODE/MENU button
Press this button to select the tunning mode(“P” goes
off) or the preset mode (“P” lights up).
When listening to the Internet radio broadcasts or
DAB/DAB+ broadcasts, press this button to enter the
main menu.
11. TUNING/PRESET knob
Rotate this knob to tune in the stations depending on
whether the tuning mode or the preset mode is
selected.
12. TUNING UP/DOWN (+/-) buttons
Press these buttons to tune in the stations without
selecting the tuning mode.
TX-5505iD(G)_ENG_101110_TX-5505iD(G)_ENG 2010-11-10 오전 9:30 페이지 8
ENGLISH
9
REMOTE CONTROL OPERATION RANGE
STANDBY
T
UNING / PRESET
D
IMMER T/P MODE
M
ENU
B
AND AUTO PRESET
B
ACK
O
N/STANDBY
AM/FM/ DAB/i-R ADIO TUNER
T
X-5505iD
SECONDARYSTEREO TUNED RDS
LOADING BATTERIES
1. Remove the cover. 2. Load two batteries(“AAA” size, 1.5V) matching
the polarity.
• Use the remote control unit within a range of about
7 meters (23 feet) and angles of up to 30 degrees
aiming at the remote sensor.
• Remove the batteries when they are not used for
a long time.
• Do not use the rechargeable batteries (Ni-Cd
type).
TX-5505iD(G)_ENG_101110_TX-5505iD(G)_ENG 2010-11-10 오전 9:30 페이지 9
Loading...