WHEN USING YOUR SHARK® STEAM MOP,
BASIC SAFETY PRECAUTIONS SHOULD
ALWAYS BE FOLLOWED, INCLUDING THE
FOLLOWING:
READ ALL INSTRUCTIONS BEFORE USING
YOUR SHARK
LITE.
DANGER OF SCALDING.
Please use caution when using the steam mop. The
steam emitted from the steam mop is very hot.
IM P ORTANT:
This appliance is not intended for use by persons
with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance by a
person responsible for their safety.
Children shall not use or play with this
appliance. Close supervision is necessary
to keep appliance out of reach of children
during use and cooling.
®
MULTI-FUNCTION STEAM MOP
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR INJURY:
1. Use the system only for its intended use.
2. DO NOT use outdoors.
3. DO NOT leave the appliance unattended when
plugged in. Always unplug the power cord
from the electrical outlet when not in use and
beforeservicing.
4. DO NOT allow the appliance to be used by
children. Close attention is necessary when used
near children, pets or plants.
5. Use only as described in this manual.
6 . Use only manufacturer’s recommended
accessories.
7. DO NOT use with damaged cord or plug.
8. DO NOT USE if the appliance is not working, has
been dropped, dropped into water, damaged or
left outdoors.
9. NO SERVICEABLE PARTS. Incorrect reassembly or repair can cause a risk of electrical
shock or injury to persons when the appliance is
used. Contact Customer Service.
10. To protect against a risk of electric shock, DO
NOT immerse the steam mop into water or any
other liquids.
11. DO NOT handle plug or steam mop with wet
hands or operate appliance without shoes.
12. DO NOT pull or carry by power cord, use power
cord as handle, close a door on the power
cord, or pull the power cord around sharp
edges or corners. Keep power cord away from
heatedsurfaces.
13. DO NOT unplug by pulling on power cord. To
unplug, grasp the plug not the power cord. Do not
use extension cords or outlets with inadequate
current carrying capacity.
21 800 798-739 8
14. DO NOT put any objects into openings. Do not use
with any opening that is blocked.
15. DO NOT put hands or feet under the steam mop.
Unit gets very hot.
16. Use ONLY on flat, horizontal surfaces. Do not use
on walls, counters or windows.
17. DO NOT use on leather, wax polished furniture or
floors, synthetic fabrics, velvet or other delicate,
steam sensitive materials.
18. Liquid or steam must not be directed towards
equipment containing electrical components, such
as the interior of ovens.
19. DO NOT add cleaning solutions, scented
perfumes, oils or any other chemicals to the water
used in this appliance as this may damage the
unit or make it unsafe for use. If you live in a hard
water area, we recommend using distilled water in
your steam mop.
20. When in use, NEVER turn the appliance over or
on its side. NEVER DIRECT STEAM TOWARDS
PEOPLE, ANIMALS OR PLANTS.
21. NEVER LEAVE THE STEAM MOP IN ONE SPOT
ON ANY SURFACE FOR ANY PERIOD OF TIME
WHEN THE CLEANING POCKET IS ATTACHED
AS THIS WILL DAMAGE YOUR FLOORS.
22. Carefully remove the cleaning pad immediately
after you have unplugged and allowed the steam
mop to cool.
23. When cleaning the steam mop, unplug the power
cord from the electrical outlet and clean with a dry
or damp cloth. Do not pour water or use alcohol,
benzene or paint thinner on the unit.
24. Extreme caution should be exercised when using
this appliance to clean stairs.
25. Never use steam mop functions without the
cleaning pads attached.
26. Keep your work area well lit.
27. Store steam mop indoors in a cool, dry place.
28. To avoid circuit overload, do not operate another
appliance on the same socket (circuit) as the
steam cleaner.
29. If an extension cord is absolutely necessary, an
extension cord rated a minimum of 15 ampere,
2
2.08mm
(14 AWG) cord should be used. Cords
rated for less amperage may overheat. Care
should be taken to arrange cord so that it cannot
be pulled or tripped over.
30. DO NOT leave unattended when the system is
connected to a power supply or electrical outlet.
Turn off all controls before unplugging the unit.
31. DO NOT store unit with damp or wet cleaning
pad attached. Never leave the steam mop in one
spot on any surface for any period of time with
a damp or wet cleaning pad attached as this will
damage your floors.
32. Always unplug and allow the steam mop to cool
before removing the mop head or accessory nozzle.
33. Make sure that the water tank cap is secured
tightly when using the appliance.
WARNING: Your steam mop is designed
to clean hard floor surfaces that will withstand high
heat. Do not use on unsealed wood or unglazed
ceramic floors. On surfaces that have been treated
with wax or some no wax floors, the sheen may
be removed by the heat and steam action. It is
always recommended to test an isolated area of
the surface to be cleaned before proceeding. We
also recommend that you check the use and care
instructions from the floor manufacturer.
SAVE THESE
INSTRUCTIONS
This appliance complies with the WEEE-Directive 2002/96/EC on the disposal of electrical and electronic
equipment (WEEE).
This appliance complies with the European directives for electromagnetic compatibility (EMC) 2004/108/EC and its
revisions, as well as Low Voltage Directive (LVD) 2006/95/EC and its revisions.
This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from uncontrolled
waste disposal, recycle it responsibly to promote the sustainable reuse of material sources. To return
your used device, please use the return and collection systems or contact the retailer where this
product was purchased. They can take this product for environmental safe recycling.
This product has no on/off switch and operates when plugged into the main supply source. Disconnect the plug
from mains after use.
Although the product is not provided with standby mode or off mode, it still fulfills the requirements of 1275/2008/
EC - the directive for Eco-Design requirements since according to technical justification, it is considered as
inappropriate to provide standby and off modes when connecting to mains. To reduce energy consumption be sure
to unplug the unit after use.
THIS MANUAL COVERS MODEL NUMBER:
S7000***** 11
TECHNICAL SPECIFICATIONS
Voltage: 220-240V~, 50/60Hz
Power: 1250 Watts
Water Capacity: 350 ml
41 800 798-739 8
IPX4
Contents
Thank you for
purchasing the Shark®
Multi-Function Steam
Mop Lite.
Getting Started ....................................................................................... 2
Assembling Your Steam Mop ................................................................... 3
Using Your Steam Mop ............................................................................ 4
Using Your Carpet Glider .......................................................................... 5
Using Your Handheld Steamer .................................................................. 6
Using Your Removable Handheld Steamer with Accessory Hose ................. 7
Using Your Removable Handheld Steamer with Different Accessories .......... 8
Care of Your Steam Mop .......................................................................... 12
When assembling your steam mop there may be a little water in or around the water tank. This is because we test all
our steam mops 100% before you buy them, so you get a quality Shark
®
Multi-Function Steam Mop Lite.
a
jk
b
mnl
po
c
qr
d
e
s
f
ut
g
h
v
a Mop Handle
b Cord Clip
(XBTECLP03 or 3010FO2906)
c Water Tank Cap
d Handheld Steamer
e Power Button
f Release Button
g Rectangle Mop Head (3072SO700 0)
h Cleaning Pad for Rectangle Head (P 159W )
i Carpet Glider ( XCG7000)
21 800 798-739 8
i
j Concentrator Nozzle
(3011FO2901)
k Accessory Hose (3010FO2901)
l Grout Scrubber Brush (108 1SO)
m Window Squeegee ( 1078 SO)
n Detail Brush (3039SO3901)
o Flat Scrubber Tool (10 77SO)
p Flat Scrubber All-Purpose Bonnet ( P123W )
q Cylinder Wand (1080SO)
r All-Purpose Pocket for Cylinder Wand ( P124W )
s Duster Pocket for Cylinder Wand (P 107W)
t Wedge Cleaning Tool (1079 SO)
u Wedge All-Purpose Pocket ( P128W )
v Filling Flask (1039SO)
w Tote Bag (not shown)
Assembling Your Steam Mop
fig. 1fig. 2
IMPO R TA NT: Always make sure the mop is
UNPLUGGED from the wall when not in use. Never
fill the mop, attach the mop head, change or remove
the cleaning pocket when the mop is plugged into the
wall. To prolong the life of your Shark® Multi-Function
Steam Mop Lite we recommend using distilled water.
Make sure you only add water to the tank. Chemicals
or cleaning solution may damage the appliance and
could be unsafe for you and your family.
STEAM MOP ASSEMBLY
1 Insert the Mop Handle end with the “ “ facing the
front of the unit into the handheld steamer. Push the
mop handle in until you hear it click into place. (fig. 1)
2 Snap the mop head into the mop body by lining up
the groove on the back of the mop body with the
groove on the back of the mop head. Push until you
hear it latch into place. Press the release button to
remove or change the mop head. (fig. 2)
3 Place the cleaning pad on the floor with the logo
side facing up. Place the Shark
Steam Mop Lite on top of the pad to attach.
®
Multi-Function
Loading...
+ 15 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.