Seametrics PE202 Installation Guide

Check Components

PE202 Quick

Install Guide

PE202-0XX

Electromagnetic

Low Flow Meter

101216

Mounting Bracket

Optional

¼”, ¾”, ½” or ¾”

PP or PVDF MNPT

Adapter Kit

Positioning

The PE202 may be mounted vertically or horizontally.

Choose a position that will ensure a full pipe.

FLOW

101153

X4 Bracket Screws

½” PVDF

FNPT Adapter Kit

Shielded Output Cable

Mounting Plate

It is highly recommended to use the mounting bracket

provided. The mounting bracket uses two #8 screws

(not included) on a 1.5 inch bolt pattern.

101422

8-Pin, 6 Meter

FLOW

Page 1 of 2

Pipe Mounting

Adapter Kit (Optional)

The PE202 may be supported by its piping connections if the

piping is rigid with no exion at the ttings.

Cable Connection

Power and signal connections are provided through the 8-pin

male bulkhead connector on the meter housing.

The standard NPT ttings can be used with or without adapters.

Thoroughly clean the pipe threads and nose and apply Teflon

tape (not included) to male threads. Hold adapter with wrench

while tightening the pipe to prevent damage to the meter.

*Grounding Metal Pipe

For best metering accuracy, jumper the inlet and outlet pipes

together and connect to ground for best results.

*If piping is non-metallic, it is recommended that additional

metal ttings be attached at both ends and connected

together with a 12AWG or larger equalization jumper.

To complete your installation, please see ‘CONNECTIONS’ in your

PE202 instruction manual for power supply connection information.

For the most recent PE202 instruction manual please visit: http://www.seametrics.com/downloads

Page 2 of 2

LT-14231-011315

01/13/2015