Scott CX 82 Instruction Manual

Instruction Manual

Dual Alarm Clock Radio with

Digital Display

CX 82

PACKAGE INCLUDES:

1. The unit 2. Instruction manual

LOCATION OF CONTROLS

234

5

6 7

8

91012

1. ALARM/SLEEP OFF button

2. ALARM button

3. TIME button

4. SNOOZE button

5. FAST button

6. SLOW button

7. SLEEP button

8. ALARM 1/1+2/2 switch

9. TUNING knob

10. LED display

11. VOLUME/OFF BUZZER knob

12. ON/OFF/AUTO switch

13. Clock back up battery cover

14. FM antenna wire and AC power cord

INSTALLING BATTERIES

Installing the clock back up battery
Clock back up

The clock and alarm time can be maintained during a power failure with a 9V “6F22” battery (not
supplied). During power failures, the clock time may gain or lose a few minutes per hour and may
require resetting.

Battery insertion

1. Remove the battery cover on the bottom of the unit, by pressing the top edge.

2. Insert a 9V “6F22” battery (an alkaline battery is recommended) into the battery compartment,
following the correct polarities marked inside the battery compartment.

3. Replace the battery cover.

Note: For optimum performance, the battery should be replaced every 6 months.

Precautions when using batteries

1. Use only the size and type of battery specied.

2. Ensure you follow the correct polarities when installing the battery, as indicated in the battery
compartment. A reversed battery may damage the unit.

3. An exhausted battery must be removed to prevent possible battery leakage.

4. Dispose of batteries properly according to environmental regulations.

Notes on clock back up battery

Please note that this unit will not operate fully by battery power alone. The battery provides a back up
system only in the event of an interruption of the AC power supply.

GB-1

CR38 SCOTT CX82 GB IM.indd 1 7/13/2009 5:34:59 PM

PRECAUTIONS

Follow the advice below for safe and appropriate operations.

INSTALLATION

• Do not use the unit in places which are extremely hot, cold, dusty, or humid.

• Place the unit on a at and even surface.

• Do not restrict the airow of the unit by placing it in a place with poor airow, by covering it with a

cloth, or by placing it on a carpet.

SAFETY

• When connecting and disconnecting the AC power cord from the AC mains outlet, pull the plug
and not the cord itself. Pulling the cord may damage it and may be dangerous.

• The mains plug must remain readily operable.

• When you are not going to use the unit for a long period of time, disconnect the AC power cord
from the AC mains outlet.

AC VOLTAGE

• Before use, check that the rated voltage of your unit matches your local voltage.

CONDENSATION

• When there is condensation inside the unit, the unit may not function normally.

• Let it stand for 1 to 2 hours before turning the power on, or gradually heat the room up and dry the
unit before use.

• Ensure a minimum distance of 5 cm around the apparatus for sufcient ventilation.

• Ensure that the ventilation is not impeded by covering the ventilation openings with items such as
newspapers, tablecloths, curtains, etc.

• Do not place naked ame sources such as lighted candles on the apparatus.

• Pay attention to the environmental aspects of battery disposal.

• Use the apparatus only in moderate climates (not in tropical climates).

• Do not expose the apparatus to dripping or splashing.

• Do not place objects lled with liquids, such as vases, on the apparatus.

• Mains plug is used as the disconnect device. It shall remain readily operable and should not be
obstructed during intended use. To be completely disconnected the apparatus from supply mains,
the mains plug of the apparatus shall be disconnected from the mains socket outlet completely.

ATTENTION: To reduce the risk of electric
shock, do not remove the cover. There are no
user serviceable parts inside the unit. Refer all

servicing to qualied personnel.

The exclamation mark within
a triangle is a warning sign
alerting the user to the pres­ence of important instructions
accompanying the product.

The lightning ash with an

arrowhead symbol within
a triangle is a warning sign
al er ti ng the user to th e
presence of "dang erous
voltage" inside the unit.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

GB-2

In case of malfunction due to electrostatic discharge, the apparatus has to be reset by disconnecting it from
mains supply.

The marking plate is located on the bottom enclosure.

CR38 SCOTT CX82 GB IM.indd 2 7/13/2009 5:34:59 PM