Scotsman TC180 Installation Manual

Installation Guide for Scotsman TC180 Dispenser

Installation Guide for:

Scotsman TC180 Ice & Water Dispenser

Installation Guide for Scotsman TC180 Dispenser

Unpacking

 Remove the two banding strips securing equipment to pallet.
 Remove cardboard carton and packaging material.
 Inspect exterior of machine for any potential damage.

Remove from the front of the dispense area:

 1 x water inlet tube
 1 x drain tube complete with clip

Remove top panel and check position of failsafe ‘overflow’ bracket (magnet & sensor
should be aligned. Remove any ‘transit tapes’ present.

Check the ‘Ice dispense spout’ & ‘glass tray’ is correctly located.
Check ID on rear of machine for correct voltage, e.g. 230 volt 50 hz for UK use.
Remove protective film from outer panels.

Installation

Check that the following services are beneath & within 1 metre of machine location:

Counter top location for TC180
Dispenser to have services hole
cut at rear of unit to allow Water,
Waste and Electric services to be
fed down into connection points
underneath
(* See Next Page)