Schneider Electric TPFLS10LED, TPFLS20LED, TPFLS50LED, TPFLS100LED, TPFLS20SENLED Installation Manual

LED Floodlight

TPFLS Series

TPFLS10LED

TPFLS20LED

TPFLS50LED

TPFLS100LED

TPFLS20SENLED

Installation Instructions

REGISTERED DESIGN • REGISTERED PATENT

F2837/01

Product Range

TPFLS10LED 10 W LED Floodlight, 240 V a.c., 4000 K, IP65

TPFLS20LED 20 W LED Floodlight, 240 V a.c., 4000 K, IP65

TPFLS50LED 50 W LED Floodlight, 240 V a.c., 4000 K, IP65

TPFLS100LED 100 W LED Floodlight, 240 V a.c., 4000 K, IP65

TPFLS20SENLED 20 W LED Floodlight, 240 V a.c., 4000 K, IP44 – with PIR sensor

Installation Requirements

DANGER

RISK OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH

• This product must only be installed and serviced by appropriately qualied and/or licenced electrical personnel.

• Isolate the electrical supply before doing any work on this product.

• Ensure that the product has been correctly installed and tested for safe operation before reconnecting the electrical supply.

Failure to follow these instructions will result in death or serious injury.

CAUTION

RISK OF BURN INJURIES

During and after use, the product may be hot. Do not touch the product until it has completely cooled down.

Failure to follow these instructions can result in minor injuries or equipment damage.

• The product is Class 1.

• Check whether the product has been damaged during transport. Do not operate/install any product which appears damaged in any way.

Return the complete product to the place of purchase for inspection, repair or replacement.

• Take care not to pull any electrical wires during unpacking as this may damage the connections.

• Isolate the electrical supply before commencing any work on this equipment.

• Select a suitable location for installation.

Installation Instructions

1 Remove all packaging material from the product.

2 Use mounting bracket to mark hole centres for xing.

3 Secure mounting bracket using appropriate fasteners.

4 Safely terminate wiring, paying particular attention to all markings.

Mounting Options – TPFLS Series (no sensor)

Mounting Options – TPFLS20SENLED (with PIR Sensor)