Easy9 Compact Consumer Unit - Cable Kit
EZ9CCUCABLEKIT1, EZ9CCUCABLEKIT2
PLEASE NOTE
b This equipment must be installed and maintained by a qualified electrician in accordance with the
appropriate statutory regulations and codes of practice, e.g. Electricity at Work Regulations, BS7671 IET
Wiring regulations, etc.
All applicable local, regional and national regulations must be complied with during the installation, use,
b
maintenance and replacement of this device.
b
This device should not be installed if, when unpacking it, you observe that it is damaged.
Schneider Electric cannot be held responsible in the event of noncompliance with the instructions in this
b
document and in the documents to which it refers.
b
The service instruction must be observed throughout the life time of this device.
Installation Instruction
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH
b Turn off all power supplying this device before working on it.
b
Use a voltage tester with a suitable rated voltage in order to check that all active conductors aren’t energized.
b
Carefully inspect the work area to check that no tools or objects could have been left inside the equipment.
Failure to follow these instructions will result in death or serious injury.
Unboxing
Identification
Cable EZ9CCUCABLEKIT1 EZ9CCUCABLEKIT2
NNZ81913-01
11-2020 1/2
Number
P1
P3
N1
N2
N3
N5
x1
x3
x2
x1
x1
x1
x3
x2
x1
x1
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
b Check that the busbar is fully located in MCB's and incomer.
b
b Tighten all connections to recommended torque settings.
Failure to follow these instructions will result in death or serious injury.
N1 N1
N3
N2
N5
P3
P3
P3
Note:
N5 for EZ9E16MCCU
1.
2. N3 for EZ9E10MCCU, EZ9E12MCCU
Schneider Electric Limited
Stafford Park 5
Telford TF3 3BL
United Kingdom
www.se.com/uk
NNZ81913-01 1/2
© 2020 Schneider Electric - All rights reserved.
Loading...