Schlage FE695 Installation Instructions Manual
*P516-866*
P516-866
Keyless Touchscreen Lever
Model FE695
Alternate Faceplate
Installation Instructions
Prepare for Installation
Tools Needed
• Phillips screwdriver, #1 and
#2 bits
• Tape Measure
• Pencil
Optional
• Flathead Screwdriver
• Wood Block
• Hammer
IMPORTANT NOTES
DO NOT use a power drill for installation!
• Install and test lock with door open to avoid being locked out.
A Check door dimensions.
See consumer.schlage.com/Service-Support for door preparation
instructions if dimensions are different.
2³⁄₄” (70 mm)
OR
2³⁄₈” (60 mm)
1” (25 mm)
Door Edge
2¹⁄₈” (53 mm)
Hole
B Change faceplate, if necessary.
Choose the drawing that matches your door edge. If the hole has no
mortise, change to the circular faceplate.
Door Edge
No change necessary.
OR
Door Edge
Install Lock
4 Install the touchscreen on the outside of door.
1 Install latch.
Make sure latch angle faces door jamb.
Angle
OR
Actual Size
2 Press levers onto lever posts.
Bar should slide smoothly through hole in latch. If not, check door
dimensions.
Jamb
Angle
IMPORTANT!
Route wire over the latch.
5 Install the interior lever assembly.
5a Route wire through indicated hole below.
Wood Block
(Not Included)
Tip points
down
3 Remove battery cover from the interior thumbturn
assembly.
Unscrew the cover and li down and out to remove.
5b Secure interior assembly with screws.
6 Connect wire and battery.
7 Place battery in holder and tuck wires.
10 If needed, switch levers.
Tuck battery and wires behind the tabs.
Tab s
8 Install battery cover.
Angle the cover up to install, then screw the cover in.
Correct
Incorrect
If your lever looks like this,
then no change is necessary.
If your lever does not look like
this, switch the levers by
following the steps below.
OR
a
Insert the pin wrench
into the hole in the
lever. Push in and hold.
9 Install strike onto door jamb.
b
Pull the lever off. Repeat steps a and b to remove the
c
lever from the other side of the door.
Switch the levers.
d
Actual Size
Push each lever back
into place.
Loading...