Schlage BE469 Installation Manual

*24156804*

24156804

Thick Door Kit Installation Instructions

TOUCHSCREEN DEADBOLT WITH ALARM | MODEL BE469 CONNECTED TOUCHSCREEN | MODEL BE468

This kit is used to t the Touchscreen Deadbolt with Alarm and the Connected Touchscreen to doors that are between 1M\,” and 2Z\v” thick.

L If you are uncomfortable performing these steps, call a locksmith for assistance.

Determine the thickness of your door.

1

Choose Screws and Tailpiece Length

2

2a Select the screws using the chart below.

Door

Thickness

2Z\,” - 2Z\v”

1M\,” - 2”

Screw Length

(Actual Size)

3b Remove the cylinder from the Touchscreen.

Door Thickness

1M\,” to 2Z\v”

3c Remove the cylinder cap, washer and tailpiece.

Use a paperclip or similar to press and hold down the
pin. Then unscrew the cap. The washer and tailpiece
can then easily be removed. Leave the pin in place.

Washer

Tailpiece

Cap

Pin

2b Select the tailpiece length, using the chart below.

Door

Thickness

2Z\,” - 2Z\v”

1M\,” - 2”

Replace the Tailpiece

3

3a Remove the cylinder screw from the Touchscreen.

Tailpiece Length

(Actual Size)

3d Install the new tailpiece, washer and cylinder cap.

Using the original washer and
cylinder cap, reinstall all pieces and
screw the cap into place. Do not
overtighten the cap!

Break off and discard

3e Install the cylinder back into the Touchscreen.

3f Replace the cylinder screw.

Replace the cable and the spacer.

4

4a Remove the spacer screw from the Touchscreen.

4e Press the cable into the groove.

4f Replace the spacer as shown and rotate back into place.

4g Replace the spacer screw.

4b Rotate the spacer so the notch is aligned with the tab, then remove the

spacer from the Touchscreen.

4c Remove the existing cable from the Touchscreen and replace it with the

longer cable.

NOTE: If you are installing the lock on a door with a 1Z\x” (38
mm) hole, stop here; do not reinstall the spacer. Do replace the
spacer screw.

You will know the
spacer is in the right
place when the hole
in the spacer lines up
with the hole in the
Touchscreen.

Install the lock.

5

Install the lock as detailed in the Installation Guide, using the longer screws you
selected in step 2a.

NEED HELP?

Please call customer support before returning the product to the store.

U.S.A.: [phone]

Toll-Free Calling From:

Visit our web site for videos, FAQs and more: answers.schlage.com

Canada: [phone]
Mexico: 018005067866

4d Feed the cable through the spacer, as shown.