Sanyo PLC-XF71 User Manual
10,000 ANSI LUMENS z TRUE XGA z DIGITAL MULTIMEDIA PROJECTOR
y
PLC-XF71
XGA Digital Multimedia Projector
Powerful Images for Large Venue and Digital Signage,
Super Bright 2-Lamp Projector
Resolution XGA (1024 x 768)
Brightness (typical)
Contrast Ratio 3000 : 1
Panel System 1.8” TFT p-Si x 3
Number of Pixels 2,359,296 (786,432 x 3)
Aspect Ratio 4 : 3
Uniformity 90% (corner to center)
Scanning Frequency H Sync: 15-120kHz, V Sync: 48-120Hz
Dot Clock 230MHz
Computer Compatibility
HDTV Signals 1080i/50, 1080i/60, 1035i, 720p
Specifications
10,000 ANSI Lumens (2-lamp mode)
5,000 ANSI Lumens (1-lamp mode)
WUXGA*,UXGA, SXGA+, SXGA, WXGA, XGA,
SVGA, VGA,MAC ( Analog Signal Only)
Color System PAL/PAL-N/SECAM/NTSC4.43/PAL-M/NTSC
Lens sold separately
Industry's highest* brightness of 10,000 lumens
Two high-output 330-W lamps and a new optical engine have achieved the
industries highest* brightness of 10,000 lumens .The new light-combining system
was developed after extensively reexamining the conventional dual-lamp layout.
The new system uses three mirrors to achieve uniform light output from two
lamps, reducing color irregularities and delivering high image quality.
Super High Contrast design
This advanced optical system achieves high contrast* to project high-quality
images with rich black reproduction, maximizing the quality of the video signals.
* Contrast ratio (full on/full off) of 3,000:1
High Performance Optical Engine
We enhanced brightness by combining advanced optical components under
optimal conditions. We also maximized cooling technology to increase light
efficiency factors such as luminance and lamp output. Together, they achieve a
high brightness level and low power consumption.
High Reliability with Active Maintenance Filter System (AMF)
The AMF sensor detects the intake air volume. If the volume is less than the
prescribed level, the filter is automatically round and a clean filter surface is
set in position. The filter can also be replaced without having to use any
tools.
Administration Network Control
An optional PJ-Net Organizer network board allows for simple control and
management of projectors via a CAT5 network connection. The administrator
can use network management software called PJ Master (optional accessory),
and be able to centrally control all PJ-Net Organizer-mounted projectors within
the network.
Lens Option
Lens Option Throw Ratio
LNS-W03 0.8 : 1
LNS-W01Z 1.2 : 1
LNS-W02Z 1.4 - 1.8 : 1
LNS-W04 1.5 - 2.0 : 1
LNS-W06 1.2 - 1.5 : 1
LNS-S02Z 2.0 - 2.6 : 1
LNS-S03 2.6 - 3.5 : 1
LNS-M01Z 3.5 - 4.5 : 1
LNS-T02 4.4 - 6.2 : 1
LNS-T03 6.3 - 9.0 : 1
21605 Plummer Street
Chatsworth, CA 91311
Ph: 888-337-1215 (toll-free)
Fax 818.717.2719
Issued 01/09 © 2009 SANYO
www.san
oprojectors.com
Projection Lens Lens Sold Separately” ( STD Lens : LNS-S02Z)
Zoom / Focus Motor Driven
Image Size (diagonal) 40-600 inch (STD)
Throw Distance Dependent on Lens
Throw Ratio Dependent on Lens
Up/Down Ratio U/D 10 : 0 – 0:10, L/R 3:2 – 2:3
Digital Keystone V +/- 40°, H +/- 20°
Digital Zoom 7x - 1/2x
Projection Lamp(s) 330W NSHA
Voltage 100-120V/200-240V AC
Power Consumption 950W (Normal), 780W (Eco)
Fan Noise 45dB ( eco)
BTU Rating Normal 3242, Eco 2661
Speaker Output NA
Weight 60.8lbs (w/o lens).
Dimensions 20.9”x10.6”x29.8” (not including protrusion)
Input 1 PC or Video
Input 2 PC or Video
Computer 1 : D-Sub 15
DVI-D（HDCP）
Computer 2 : 5 – BNC
S-Video
Component/ Composite、BNC input/output
Input 3 Input Slot
Input 4 Input Slot
Communication
Terminals
Service Port : USB
Serial Port : D-Sub9 ( RS232C)
Wired Remote : mini- Jack
Wired/Wireless Remote Control • Two “AA” type
batteries
• Owner’s manual (CD-ROM & Quick Guide)
Included Accessories
• Computer Cable ( Dsub15 - Dsub15)AC power
cord • Lens Attachment x2, Lens Spacer, Lens
Block Sheet x 2, • Pin Code Label, Real Color
Manager Pro, CD-ROM
POA-MD23ADI – DVI-D & D-sub15 Board
POA-MD25VD3 – 5BNC Board & S-Video
POA-MD18DVI – DVI Module
POA-MD21WARP – WARP & Blending Board
Optional Accessories
POA-MD26HDWL – HD - Wireless
POA-MD17SDID – HD-SDI & SD-SDI Input Board
POA-MD16VD1 – 5 BNC Module,
POA-MD13NET2 -Network Module
610 341 9497 – Replacement Lamp,
645 098 0954 – Replacement Remote
Because its products are subject to continuous improvement, SANYO reserves the right to modify
product design and specifications without notice and without incurring any obligations.
Loading...