Sanyo CE24FWN5-B Instruction Manual

CE24FWN5-B

Please read this Instruction book before using your television.

We wish you many hours of pleasure from your new television.

Colour Television

INSTRUCTION MANUAL

Common specification

Power source AC 220~240V 50Hz Television system System I Colour system PAL/NTSC4.43

(PAL/NTSC4.43/NTSC3.58 in AV mode) Channel coverage UHF: 21-69. Aerial input impedance 75 ohm

AV terminal

AV1: CENELEC Standard Input: Composite video, RGB and audio-L/R

Output: TV-output with composite video and

audio-L/R

AV2: CENELECStandard Input: Composite video, RGB, S-VHS and

audio-L/R

Output: Monitor-output with composite video and

audio-L/R

Front AV terminal

AV3: RCAjacks Input: Composite video and audio-L/R

Headphone socket Mini Jack

CE24FWN5-B

Sound output (Continuous) 2 x 3W

Picture tubes (inches) 24

Dimensions (WxHxD mm)

612 x 476 x 482

Weight (kg) 25

TV Specifications

SAFETY

PRECAUTIONS

Do not allow anything to rest on the power cord. Do not locate

this television receiver where the cord will be damaged by people walking on it.

Do not overload wall outlets and extension cords as this can result in fire or electric shock.

Slots and openings in the cabinet and in the back or bottom are provided for ventilation to ensure reliable operation and to protect it from overheating. These openings

must not be blocked or

covered. The opening

should never be covered with a cloth or

other material, and the bottom openings

should not be blocked by placing the television receiver on a bed, sofa, rug, or other similar surface. This television receiver

should never be placed

near or over a radiator or heater. This television receiver

should not be placed in a built-in installation such as a bookcase unless proper ventilation is provided.

Do not place your television receiver on an unstable stand, shelf or table. Serious injury to an individual, and damage to the television may result if it should fall. Your sales person can recommend approved stands or shelf and wall mounting instructions.

If the television is built into a unit, or enclosed, the minimum distances for ventilation must be maintained. Heat build up can reduce the life of your television, and can be dangerous.

This television receiver should be operated only from the type of power source indicated on the television or as indicated in the Operating Instructions. If you are not sure of the type of power supply in your home, consult your sales person or your local power company.

Never add accessories that have not been specifically designed for this television.

Do not drop or push objects into the television cabinet slots or openings. Some internal parts carry hazardous voltages and contact may result in an electric shock hazard.

Never spill liquids of

any kind on the television receiver.

Do not place items such as

vases containing liquid on top of the TV set. Do not expose the television receiver to rain or use near water.

For example, near a bathtub, kitchen sink, in a wet basement, etc. Before cleaning, unplug the television receiver from the wall socket.

Never stand on, lean on or push the television or its stand.

Never allow children to play with the television or its stand. Serious injury may result if it should fall.

Do not apply liquid cleaners or aerosol cleaners directly onto the television receiver. Use a damp cloth for cleaning.

Do not place candles or hot objects upon the TV, next to it or behind it. Open flames must never be used near the TV set.

Installation

Use

CAUTION: Please read and retain for your safety. This unit has been engineered and manufactured to assure your personal safety.

But improper use can result in potential electric shock or fire hazards. In order not to defeat the safeguards incorporated in this receiver observe the following basic rules for its installation, use and servicing.

Your television is fully transistorised and does not contain any user serviceable components.

You must not remove the rear cover of the TV by yourself. The apparatus is working with high voltages and could damage objects or even endanger people. Leave all required repair and service jobs to an authorised service technician. He will exclusively use such spare parts that are complying with the same safety standards as applicable to the original parts. The use of original spare parts can prevent fire, shock and other hazards.

Unplug the television receiver from the wall outlet and refer servicing to qualified service personnel under the following conditions:

■ If the power cord or plug is damaged.

■ If liquid has been spilt into the television

receiver.

■ If television receiver has been exposed to rain or water.

■ If the television receiver has been dropped or the cabinet has

been damaged.

■ If the television receiver exhibits a distinct change in performance.

■ If the television receiver does not operate normally by following

the operating instructions.

Adjust only those controls that are covered in the operating instructions as improper adjustment of other controls may result in damage. This will often require extensive work by a qualified technician to restore the television receiver to normal operation.

Servicing

Important:

This equipment is fitted with an approved non rewireable UK mains plug. To change a fuse in this type of plug proceed as follows:

1. Remove the fuse cover and fuse.

2. Fit a new fuse which should be a BS1362 5Amp A.S.T.A. or BSI

approved type.

3. Ensure that the fuse cover is correctly refitted. If the fuse cover is lost or damaged the plug must

NOT be used but replaced with a serviceable plug. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a rating of 5 Amp, ensure the fuse cover is correctly fitted. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp.

Note: The severed plug must be destroyed to avoid a possible

shock hazard should it be inserted into a 13Amp socket elsewhere. The wires in this mains lead are coloured in accordance with the

following code:

Blue -------> Neutral Brown ----> Live

The Blue wire must be connected to the terminal which is marked with the letter “N” or coloured BLACK.

The Brown wire must be connected to the terminal with the letter “L” or coloured RED.

Do not connect either wire to the earth terminal in the symbol

or coloured GREEN or GREEN and YELLOW.

Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the wires.

MINIMUM DISTANCES

10cm

20cm

10cm

5cm

Connect your aerial cable socket to the back of the TV set.

Connect the power cord of the TV set to a wall outlet.

✐ The TV set is prepared for a mains voltage AC220~240V, 50Hz

and is fitted with a single pole mains ON/OFF switch. To completely switch off from the mains, or when the TV set is not to be used for an extended period of time it is advisable to disconnect the power cord from the power outlet.

✐ For all aerial problems please consult your local dealer.

● Connecting DVD / VCR player/ Satellite receiver

or Set top box.

We recommend that you connect all other equipment before Plug and Play. The following examples are our recommended standard connection. For further information please consult your local dealer.

Please refer to individual Instruction Manuals for each piece of equipment for their connection suggestions.

Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on the batteries match the "+" and "-" marks inside the unit into the remote control handset.

Press the

Mains on off switch on the front of the TV set.

This TV set provides a self- automatic tuning function called Plug and Play which automatically searches and stores all of the available TV stations in your reception area.

A welcome message will appear, once this has finished the following screen appears.

To remove the completed message press the

MENU button.

Now the installation is complete!

After Plug & Play the TV set will automatically sequence the following major stations in the UK starting from programme position 1.

BBC1 BBC2 ITV CH4 CH5 SKY, BBC-World, or BBC-Prime.

✐

ny other channels found will be stored sequentially as they are

found after the major stations.

✐

If you move to another city or cable is installed, please follow the description “

TUNING”. (on page 6).

✐

This procedure only appears the first time you switch on.

Press the 5 and 6 buttons to increase or decrease the programme position.

Press the 1 or 2 buttons to increase or decrease the sound volume.

■ Front terminals

✐

To select the AV3 mode press the v button repeatedly.

✐

When the headphones are inserted the sound from the TV speakers is muted.

INST

ALLA

TION

Step : 1 Connections ( Essential)

Step : 2 Remote control battery installation

AC Mains Outlet

WARNING! High voltages are used in the operation of this set. Refer service to qualified service personnel.

Step : 3 Switching on / Plug & Play

TV front controls / Terminals

AV2

AV1

ANT.75Ω

Thank you for purchasing your SANYO TV. Now I am searching and storing all the programmes. Please wait.

Auto set-up completed. Happy viewing!

AV1

DISH IN

ANT.75Ω

OUT

VCR

Set top box or Satellite

AV2

Option if no DVD

VCR

For Satellite only

DVD

Headphone Jack

AV3 Video/ Audio-input Jacks

From Camcorder or video game equipment

Camcorder

Game equipment

+ 5 hidden pages