Sanyo CE22LD08-B Quick Start Guide

Quick Start Guide

50169344

CE22LD08-B

Insert the batteries into the handset

Insert two AAA/R3 or equivalent type batteries inside. Observe the correct polarity (+/-) when inserting batteries and replace the battery cover.

Connect the aerial straight to your TV

REAR OF THE TV

Set Top Box connection

To switch the TV on

1. Press the On/Off switch at the side of the TV. The TV switches itself to standby mode and the light will illuminate on the front of the TV.

2. Switch television on from stand-by, by pressing the standby button on the remote control,the standby button on the TV or one of the 0…9 buttons on the remote control. Press P/CH- or

P/CH+ button on the TV or press the P+ or P- button on the remote control.

Start Auto Setup procedure

1. When the TV is turned on for the fisrt time, the menu for the

language selection appears on the screen.the message “Welcome please select your language!”Is displayed in all language options sequentially in the OSD.By pessing the “ ” or “ ” buttons highlight the language you want to set and press OK button.

1111 2222 3333 4444 66665555

0000

99997777 8888

3. After Automatic search is complete, the following message asking for analogue channel search appears on screen.

4. Press OK/Select button to start installation.

5. Check Language and then press OK/Select.

Important note: After the APS has finished, the program table will appear on the screen. The stored local channels are automatically assigned a programme number. If you would like to change the programme order, please refer to the Program Menu section of the instruction book.

Connect the TV to the mains socket

UK plug

insert plug...

...and switch on

2. By pressing “ ” or “ ” buttons, set active antenna mode as on or

off.If an active antenna is connected to your TV, you can select this option as On. Antenna power should be “Off” when standard antenna is used instead of the active antenna. See Configuration Menu in the following sections for more information.