Sanyo CE20LC3-B Instruction Manual
Please read this Instruction book before using your television.
We wish you many hours of pleasure from your new television.
Colour Television
INSTRUCTION MANUAL
CE20LC3-B
2
Do not allow anything to rest on the power
cord.
Do not locate this television receiver
where the cord will be damaged by people
walking on it.
Do not overload wall outlets and extension
cords as this can result in fire or electric
shock.
Slots and openings in the cabinet and in the back or bottom are
provided for ventilation to ensure reliable operation and to protect
it from overheating. These openings
must not be blocked or
covered. The opening
should never be covered with a cloth or
other material, and the bottom openings
should not be blocked
by placing the television receiver on a bed, sofa, rug, or other
similar surface.
Do not place this television near any heat sources such as
radiators, heaters, stoves and other heat-generating products
(including amplifiers).
Do not place the television in direct sunlight.
Do not place your television receiver on an unstable stand, shelf
or table. Serious injury to an individual, and damage to the
television may result if it should fall. Your sales person can
recommend approved stands or shelf and wall mounting
instructions. Aspecial wall mounting kit is available for this model.
If the television is built into a unit, or enclosed, the minimum
distances for ventilation must be maintained. Heat build up can
reduce the life of your television, and can be dangerous.
This television receiver should be operated only from the type of
power source indicated on the television or as indicated in the
Operating Instructions. If you are not sure of the type of power
supply in your home, consult your sales person or your local
power company.
Never add accessories that have not been specifically designed
for this television.
Do not drop or push objects into the television cabinet slots or
openings. Some internal parts carry hazardous voltages and contact may result in an electric shock hazard.
Never spill liquids of
any kind on the television receiver.
Do not place items such as
vases containing liquid on top of the TV set.
Do not expose the television receiver to rain or use near water.
For example, near a bathtub, kitchen sink, in a wet basement, etc.
Do not use immediately after moving the television from a low
temperature to a high temperature environment, as this causes
condensation, which may result in fire, electric shock, or other
hazards. Before cleaning, unplug the television receiver from the
wall socket.
Never stand on, lean on or push the
television or its stand.
Never allow
children to play with the television or
its stand. Serious injury may result if
it should fall.
Do not apply liquid cleaners or
aerosol cleaners directly onto the
television receiver. Use a soft cloth
for cleaning.
Do not place candles or hot objects
upon the TV, next to it or behind it.
Open flames must never be used
near the TV set.
SAFETY
SAFETY
PRECAUTIONS / SERVICING
PRECAUTIONS / SERVICING
Installation
CAUTION: Please read and retain for your safety. This unit has been engineered and manufactured to assure your personal safety, but
improper use can result in potential electric shock or fire hazards. In order not to defeat the safeguards incorporated in this receiver observe
the following basic rules for its installation, use and servicing.
Use
MINIMUM DISTANCES
4cm
10cm
10cm
CAUTION ! :- ENSURE HANDS ARE CLEAR OF RECESS BETWEEN
THE STAND BASE AND THE BOTTOM OF THE SCREEN FRAME, WHEN
ADJUSTING THE SCREEN ANGLE.
10cm
POWERPOWER
POWERPOWER
POWERPOWER
3
● Cleaning your LCD screen.
Your LCD screen is coated in a non reflective film. Damage to this
film will result in possible discolouration. Any scratches will not be
repairable.
Clean your screen with a soft cloth, only rub lightly, do not use
detergents.
Do not stick anything to the screen, use solvent or alcohol based
cleaners, hit the screen with a hard object or rub the surface hard.
● Placement of your LCD TV.
Table top stand
This LCD TV is supplied with a table top stand fitted. It can be
tilted 5˚ forwards and 10˚ backwards.
To tilt your TV hold the base (taking care not to trap your fingers
between the bottom of the screen frame and the base)and gently
push the top of the TV.
Wall mounting bracket
Optional wall brackets (VESA 100 x 100mm fixing) are available
for your LCD TV. Before you consider wall mounting this TV,
check that you have an appropriate wall made from solid materials such as concrete or bricks. You will have to remove the table
top stand to use this.
SAFETY
SAFETY
PRECAUTIONS
PRECAUTIONS
Important:
This equipment is fitted with an approved non rewireable UK mains plug. To change a fuse in this type of plug proceed as follows:
1. Remove the fuse cover and fuse.
2. Fit a new fuse which should be a BS1362 5Amp A.S.T.A. or BSI approved type.
3. Ensure that the fuse cover is correctly refitted.
If the fuse cover is lost or damaged the plug must NOT be used but replaced with a serviceable plug.
If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a
fuse, this should have a rating of 5 Amp, ensure the fuse cover is correctly fitted. If a plug without a fuse is used, the fuse at the distribution board
should not be greater than 5 Amp.
Note: The severed plug must be destroyed to avoid a possible shock hazard should it be inserted into a 13Amp socket elsewhere.
The wires in this mains lead are coloured in accordance with the following code:
Blue -------> Neutral
Brown ----> Live
1. The Blue wire must be connected to the terminal whichis marked with the letter “N” or coloured BLACK.
2. The Brown wire must be connected to the terminal with the letter “L” or coloured RED.
3. Do not connect either wire to the earth terminal in the symbol or coloured GREEN or GREEN and YELLOW.
Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the wires.
THIS UNIT IS NOT DISCONNECTED FROM THE MAINS UNLESS THE MAINS LEAD IS UNPLUGGED.
Care of your product
Your television is fully transistorised and does not contain any
user serviceable components.
You must not remove the rear cover of the TV by yourself. The
apparatus is working with high voltages and could damage
objects or even endanger people. Leave all required repair and
service jobs to an authorised service technician. He will exclusively use such spare parts that are complying with the same
safety standards as applicable to the original parts. The use of
original spare parts can prevent fire, shock and other hazards.
Unplug the television receiver from the wall outlet and refer
servicing to qualified service personnel under the following
conditions:
■ If the power cord or plug is damaged.
■ If liquid has been spilt into the television
receiver.
■ If television receiver has been exposed to rain or water.
■ If the television receiver has been dropped or the cabinet has
been damaged.
■ If the television receiver exhibits a distinct change in performance.
■ If the television receiver does not operate normally by following
the operating instructions.
Adjust only those controls that are covered in the operating instructions as improper adjustment of other controls may result in damage.
This will often require extensive work by a qualified technician to
restore the television receiver to normal operation.
Servicing
!
4
1. Connect your aerial cable socket to the back of the TV set. Fit the
aerial cable as shown or as shown below when AV equipment is
connected.
● Connecting DVD / VCR player/ Satellite receiver or
Set top box.
We recommend that you connect all other equipment before Plug and
Play. The following examples are our recommended standard connection. For further information please consult your local dealer.
2. Connect the DC power supply adaptor to the LCD TV set. (supplied
with the set).
3. Connect the power cord of the LCD TV to a wall outlet.
✐ The TV set is prepared for a mains voltage AC220~240V, 50Hz. To
disconnect completely from the mains or, when the TV set is not to
be used for an extended period of time, it is advisable to disconnect the power cord from the power outlet.
✐ For all aerial problems please consult your local dealer.
Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on the
batteries match the "+" and "-" marks inside the unit into the remote
control handset.
INST
INST
ALLA
ALLA
TION
TION
Step : 1 Connections ( Essential)
WARNING! High voltages are used in the operation of
this set. Refer service to qualified service personnel.
Step : 2 Remote control battery installation
DC 19V
LCD TV
R/D
L/S
AC Mains Outlet
DC 19V
DISH
IN
OUT
IN
OUT
IN
VCR
Set top box
or
Satellite
VCR
TV
For satellite
only
DVD
DC 19V
Loading...