Sanyo CE19LD08DV-B Quick Start Guide

Quick Start Guide
50169231
50169231
CE19LD08DV-B
Insert the batteries into the handset
1
Insert two AAA/R3 or equivalent type batteries inside. Observe the correct polarity (+/-) when inserting batteries and replace the battery cover.
Connect the aerial straight to your TV
2
REAR OF THE TV
Set Top Box connection
To switch the TV on
4
1. Press the On/Off switch at the side of the TV. The TV switches itself to standby mode and the light will illuminate on the front of the TV.
2. Switch television on from stand-by, by pressing the standby button on the remote control,the standby button on the TV or one of the 0…9 buttons on the remote control. Press P/CH- or
P/CH+ button on the TV or press the P+ or P- button on the remote control.
Start Auto Setup procedure
5
1. When the TV is turned on for the fisrt time, the menu for the
language selection appears on the screen.the message “Welcome please select your language!”Is displayed in all language options sequentially in the OSD.By pessing the “ ” or “ ” buttons highlight the language you want to set and press OK button.
RETURN
MENU
3. After Automatic search is complete, the following message
asking for analogue channel search appears on screen.
4. Press OK/Select button to start installation.
5. Check Language and then press OK/Select.
Important note: After the APS has finished, the program table will appear on the screen. The stored local channels are automatically assigned a programme number. If you would like to change the programme order, please refer to the Program Menu section of the instruction book.
3
Connect the TV to the mains socket
UK plug
insert plug...
...and switch on
2. By pressing “ ” or “ ” buttons, set active antenna mode as on or
off.If an active antenna is connected to your TV, you can select this option as On. Antenna power should be “Off” when standard antenna is used instead of the active antenna. See Configuration Menu in the following sections for more information.
DVD Playback
6
When TV set is on, insert a disc into the loader at the side of the unit. (Disc label facing the front) the disc will be automatically loaded, a menu may appear on the TV screen after a few moments or the film may start immediately depending on the disc content. To start DVD playback press play button on remote control.
Loading...