Sanus VISIONMOUNT UNIVERSAL CABLE TUNNEL-VMCT User Manual
Assembly Instructions for model: VMCT
Thank you for choosing a Sanus Systems VisionMount™ VMCT. This product is designed to work with other VisionMount™ product
to easily and safely contain and hide component cables, power cords and wires.
Safety Warning: If you do not understand these directions, or have any doubts about the safety of the installation, please call a quali-
ed contractor or contact Sanus at 800.359.5520 or www.sanus.com. Check carefully to make sure that there are no missing or defective
parts. Our customer service representatives can quickly assist you with installation questions and missing or damaged parts. Replacement parts for products purchased through authorized dealers will be shipped directly to you. Never use defective parts. Improper instal-
lation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specied by Sanus Systems.
Sanus Systems can not be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use. Please call
Sanus Systems before returning products to the point of purchase.
Required Tools: Phillips screw driver
Supplied Parts and Hardware: Some parts not shown as actual size*
(2) Wall Plate - a* (2) Cover - b*
(4) Lag Bolt - c (4) Anchor - d
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 7.12.05
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
Step 1: Attach Wall Plate
Make sure the Wall Plate is oriented so that the at side is against the wall as shown in Diagram 1. Use the Wall Plate as a template to
mark the two hole locations for the Lag Bolts (c) on the chosen stud. Drive each Lag Bolt through the Wall Plate and into the marked
holes with a Phillips screw driver until tight.
Diagram 1a
a
c
Step 2: Wire Management and Cover Installation
Make sure all wires and cables are in between the left and right edge of the Wall Plate (a) before installing the Cover (b). Press t the
Cover onto the Wall Plate so each tab on the Cover ts into each slot on the Wall Plate as shown in Diagram 2.
Diagram 2
slot
b
tab
a
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 7.12.05
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
Loading...