Sangean WFR-1 D Plus User manual

User Manual

WFR-1D

381RE0D-A

WiFi - Internet Radio/DAB+/FM RDS STEREO RECEIVER

WiFi – Radio Internet RECEPTEUR STEREO/

DAB+/FM RDS

WiFi-Internetradio/

DAB+/UKW-RDS-STEREOEMPFÄNGER

Operating instruction

Mode d’emploi

Bedienungsanleitung

GB F D

T able of Contents

Important Safety In structions

.............................................. 2-4

Getting Started ......................................................................... 5

Controls .............................................................................. 7-10

Getting connected to Internet (for Internet Ra dio) ............. 14

Listening to Internet Radio ................................................... 18

Digital Radio (DAB plus) ...................................................... 31

Clock Operation .................................................................... 38

Upgrade firmware ................................................................. 41

T rouble Shooting ................................................................. 43

Specification .......................................................................... 44

Important Safety In structions

1. Read and understand all safety and operating instructions bef ore the radio is operated.

2. Retain instruction: The safety and operating in struction s should be retained for future reference.

3. Heed warnings. All warnings on the appliance a nd operating instructions should be followed.

4. Follow all operations and use instructions.

5. Only use attachments/accessories specified by the ma nufacturer.

6. Use only a dry cloth for clea ning the exterior of the radio.

7. Ventilation: This radio should be situated so that its location or position does not interfere with its proper ventilation. For example, the radio should not be used on a bed, sofa, rug or other soft surfaces that may block the ventilation openings. It should not be placed in a built-in situation like a cabinet that may reduce airflow through the ventilation openings. Also keep 10cm space on the back of the radio.

8. Water a nd moisture: The appliance should not be used near water. Do not use near a bathtub, washbowl, laundry tub, kitchen sink, wet basement, swimming pool, etc. WARNING! Do not expose this product to rain or moisture.

9. Do not expose this product to splashing or dripping. Objects containing liquid, such as vases or drinking glasses, should not be placed on top of this product.

10. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

11. Do not place the radio on an unstable cart, stand, bracket or table. The radio may fall, causing serious personal injury and damage to the radio.

12. Do not atte mpt to service the receiver yoursel f. Removing the cover may expose you to dangerous voltage, a nd will void the warranty. Refer all servicing to authorized service personnel.

13. Unplug the ra dio from the AC power outlet before cleaning. Use only a dry cloth for cleaning the exterior of the radio.

14. Do not plug the AC lead into the AC outlet if the outlet is still wet. Make sure that the outlet is dry before and after use.

15. Power sources: The radio should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your radio dealer or power company.

16. Power cords: The power cord should be positioned so it is not walked on, pinched, or items placed on top of it. Pay particular attention to cords at plugs, convenience receptacles, and the point where they exit from the unit. Unplug the power cord by gripping the power plug, not the cord. Operate the radio using only the current type of power source indicated. If you are not sure of the type of power supply to your home, consult your dealer or local power company.

17. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blade s with one wider than the other. A grounding type plug has two bla des and a third grounding prong. The wide blade or the third prongs are provided for your safety. If the provided plug does not fit into your outlet, consult an ele ctrician for replacement of the obsolete outlet.

21. Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

When the power supply cord or plug is damaged.

If liquid has been spilled or objects have fallen into the product.

If the product has been exposed to water or rain.

If the product does not operate normally by following the

operating instructions. If the product has been dropped or damaged in any way.

When the product exhibits a distinctive change in performance.

22. If the LCD becomes cracked and damaged, do not touch the liquid.

23. The changes or modif ications not expre ssly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

18. Do not overload wall outlets or exten sion cords. This can result in a risk of fire or electrical shock. Never insert objects of any kind into the radio through opening.

19. The power plug should be close to the radio, and easy to be approached that in case of emergency, to disconnect the power from the radio, just unplug the power plug from the AC power slot.

20. Object and Liquid Entry – Never push objects of any kind into this radio through openings as they may touch dangerous voltage points or short – out parts that could result in a fire or electric shock. Never spill liquid of a ny kind on the product.

24. To comply with the FCC RF exposure complia nce require ments, no change to the antenna or the device is permitted. Any cha nge to the antenna or the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate the device.

25. FCC INFORMATION The Federal Communication Commission Radio Frequency Interference Statement includes the following paragraph: The equipment has been tested and found to comply with the li mits for a Cla ss B Digital Device, pursua nt to part 15 of the FCC Rule s. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no grantee that interference will not occur in a particular installation. If this equipment dose cause harmful interference to radio or television reception, which can be determined by turning the equipment of f and on, the user is encouraged to try to correct the interference by one or more of the following mea sure s:

- Reorient or relocate the receiving antenna .

- Increa se the separation between the equipment a nd re ceiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV te chnici an for help. The user should not modify or change this equipment without written approval f orm SANGEAN ELECTRONICS INC. Modification could void authority to use this equipment.

26. Excessive sound pressure on ear - and he a dphones could i mpair the hearing ability. Higher setting that idle on the equalizer leads to higher signal voltages on the output for ear - a nd he adphones.

Getting Started

Congratulations on your purchase of the Sa ngean WFR-1D+. Check the package and ensure all the items are present:

Product and Accessories:

Power Cable: used to power the radio.

Remote Control: used for remote operation of the radio.

Power Cable

Remote Control

WFR-1D+ Wi-Fi Radio

Power on the radio

1. Connect the power cable with the radio and plug it in to a live outlet as shown.

2. Press the ST ANDBY button to turn on the radio.

Note: Use only the ada pter supplied with the radio. Connecting an incompatible power supply will cause permanent damage to the radio.

Controls

(Front)

Item

LCD display

Tuning Knob

STANDBY button

BAND button

INFO button

TIMER button

EQ button

BACK button

PRESET STOP button

FORWARD button

VOLUME DOW N button

VOLUME UP button

Description Screen that display texts. Rotate to enter menu selections/navigate through selections. Turn on/off the radio. Press to switch between modes. Press to display information on the LCD. Press to set sleep time and alarms. Press to enter Equalizer setup. Press to backward one page in menu selections. In Music player mode, press to skip to the previous track. In setup screens, press to go to the previous field. Press to enter the Preset menu. In Music player mode press to stop the track. Press to move to the right when entering user na me or password. In Music player mode, press to skip to the next. Press to turn the volume down. Press to turn the volume up.

Press the knob to confirm selections.

Controls

(Rear)

Item Antenna for FM a nd Digital Radio (DAB plus)

WiFi antenna

Headphone jack

LINE OUT jack

AUX IN

LAN socket

USB socket

Power cord socket

Description Connect for FM and Digital Radio (DAB plus). Connect for wireless Internet Radio. Connect to a headphone. Connect to an external speaker. Connect to external Aux devices. Connect to Ethernet for wired Internet Radio. Connect to a USB device for software upgrade. Connect to the power cable.

Controls

(Remote Control)

Power button

Volume buttons

Radio Preset buttons

Preset 7,8,9,0,+10 / previous track, pause, next track, add 10

Stop button

TUNE + button

TUNE - button

FORWARD button

Back button

Enter button

INFO button

TIMER button

Music Player button

FM button

Internet Radio button

AUX IN button

DAB button

EQ button

Mute button

Item

Power button

Volume buttons

Radio Preset buttons

Preset 7,8,9,0,+10 / previous track, pause, next track, add 10

Stop button

TUNE + button

TUNE - button

FORWARD button

Back button

Enter button

INFO button

TIMER button

Music Player button

FM button

Internet Radio button

AUX IN button

DAB button

EQ button

Mute button

Description Turn on/off the radio. Press to turn the volume up/down. Press to listen to preset stations. Press to listen to preset stations 7, 8, 9, 0, 10 Also for previous track, pause, next track, 10.

Press to stop current action. In Music Player mode press to stop the track. Navigation button used to go up. Navigation button used to go down. Press to move to the right when entering user na me or password. In Music player mode, press to skip to the next. Press to backward one page in menu selections. In Music player mode, press to skip to the previous track. In setup screens, press to go to the previous field. Press to confirm selection. Press to display information. Press to set sleep time and alarms. Press to enter Music player mode. Press to enter FM radio mode. Press to enter Internet radio mode. Press to enter auxiliary input mode. Press to enter Digital Radio (DAB plus) mode. Press to enter Equalizer setup. Press to mute the radio.

Navigate Menu Selections

There are two ways to navigate through the menu selections.

1. Navigate through the selection s by rotating the Turning knob on the radio clockwise or counter clockwise to move the > symbol and press the Turning knob to confirm the selection. Use FORWARD/BACK to enter/go to previous menu.

2. Use the navigation buttons (TUNE +, TUNE-, BACK, FW D) on the remote control to move the > symbol and press enter to confirm the selection. Use FORWARD/BACK to enter/go to previous menu.

* If necessary, press the BACK button until you can find “Main menu”. Then highlight and press is with the Turning knob. And you can start to operate the radio.

Menu navigation:

Entering Texts

To start using the radio, text entering may be required. For example, entering user name, password, search station, etc.

To enter texts:

Rotate the Turning knob to highlight the text/number/symbol.

Press the Turning knob to confirm.

Use BKSP to delete.

Use OK to enter when you are done.

Use CANCEL to cancel and exit.

Language Setup

Choose the language to display on the screen.

Go to > System settings > Language and select the language.

* If necessary, press the BACK button to find the “Main menu”

+ 33 hidden pages