Page 1
Page 2
SR-2
AM/FM/FM STEREO 2 BANDS
RECEIVER
AM/FM STEREO 2 BANDS RADIO
RADIO 2 GAMMES D'ONDES
AM/FM STEREO
AM-/FM-/FM-STEREO
-EMPF\NGER MIT 2
RADIO RECEPTOR AM/FM
STEREO
7
88
53
4
TUNINGTUNING
1
2
3
UMEVO
UME
L
L
VO
FF
FF
O
O
BDB
B
DB
ON
ON
R
R
OWE
OWE
P
P
HONES
HONES
P
P
FMSTFMST
AMAM
FMFM
6
1
2
0
8 1
9
4
9
120
0
9
.0
7
5
M
H
MHz
0
8
1
60
AM
z
0 KH
1
X
FM STEREOFM STEREO
DBB DEEP BASS BOOST SR-2
1
Page 3
LOCATION CONTROLS.
1.VOLUME KNOB
2.POWER OFF/POWER ON/DBB(DEEP Bass Boost)SWITCH
3.EARPHONE JACK
4.TUNING KNOB
5.AM/FM/FM/STEREO BAND SELECTOR
6.DIAL POINTER
7.BATTERY COMPARTMENT
POWER SUPPLY
The battery cover is located on the left side of the unit.
Open it by sliding it in the direction of the arrow.
Insert one AAA(UM-4) size battery in the battery compartment
7
EARPHONES
An earphone jack is located on the right side of the radio.
Plug the earphones supplied with the unit into this jack to hear the
program.
ANTENNA
The earphones also act as the FM antenna when plugged into the
earphones jack. There is a separate antenna built into the radio for
AM signals, position the radio for best reception.
3
POWER OFF/POWER ON/DBB
(Deep Bass) SWITCH
Turn on the radio by switching the power switch to the On position.
While using earphones you may also set the switch to DBB position to
have a stronger sound bass.
TUNING KNOB
2
2
Page 4
TUNING KNOB
Turn the tuning knob slowly to select the desired station.
4
VOLUME KNOB
Adjust the volume knob by rotating it clockwise for a
comfortable listening level.
DIAL POINTER
Whenever th AM or FM frequency is tune in, the dial pointer
6
will correspond to the dial scale on the front of the radio.
AM/FM/FM STEREO BAND SELECTOR
this switch selects the AM broadcast band or the FM
broadcast band as indicated. While receiving FM broadcasting,
set the switch to FM STEREO at normal time, if the signal
becomes weak and distorted, you may select MONO mode
by switching to FM position.
5
1
SPECIFICATIONS
Power Supply: : 1xAAA(UM-4)battery
Frequency : AM 530-1710kHz
FM 87.5-108.0MHz
Semiconductors : 3 Integrated Circuits 3 Diodes
Output Power : 0.5mW
Earphone jack : 3.5 32ohm (STEREO)
Design and specifications are subject to
change without prior notice.
3
Loading...