Samsung WEP185, GH68-12459A User Manual

Before using your headset

Check the accessoriesCheck the accessories

Charge your headsetCharge your headset

Quick Start Guide

Samsung
Bluetooth

WEP180

Get connected in 4 quick steps

Charge your headset
Put your headset in pairing mode
Turn on Bluetooth on your phone and
pair with headset
Test and use

Guide No.: GH68-12459A
09/2006. Rev. 1.0

®

Headset

Start here

Headquarters:

1301 East Lookout Drive Suite 150
Richardson, TX 75082

Internet Address:

http://www.samsungmobileusa.com/
accessories

Customer Care Center:

1-888-987-4357

Thank you for purchasing the Samsung Bluetooth
Mono Headset WEP180, we hope you will be
delighted with its operation.
Take a moment before you get started to
familiarize yourself with your new headset.

Multi-Function

button

Earpiece

Volume control

buttons

Adapter jack

Indicator light

Microphone

Put your headset in
pairing mode

Before you can use your headset, you must pair it
with your phone.

1

Ensure that the headset is off (see Turn

headset on/off on the reverse side of this guide).

2

Press and hold the Multi-Function button until
the indicator light turns on in blue
(approximately 8 seconds).

Make sure you have the following items with your

Make sure you have the following items with your

headset:

headset:

Travel adapter, User’s Guide, 1 ear hookTravel adapter, User’s Guide, 1 ear hook

NOTE:
The items supplied with your headset and the accessories
at your Samsung dealer may vary, depending on you
country or service provider.

• Bluetooth version: 2.0 (compatible with devices of
Bluetooth version 1.1 or higher)

• Supported Bluetooth profiles:

- Headset profile

- Hands-free profile

Turn on Bluetooth on your
phone and pair with headset

1

Set your Bluetooth phone to discover the

headset by following your phone's guide.

Typically, the steps involve going to the Settings,
Connection, or Bluetooth menu on your
phone and then selecting the option to discover
Bluetooth devices.

Your phone will find the Samsung WEP180
headset. your headset will be displayed as
Samsung WEP 180/185.

2

Select your headset.

3

When the phone asks if you want to pair with it,

confirm by selecting Yes or OK.

4

Enter the headset passkey or PIN, 0000.

Charge the headset's battery fully before using
the headset for the first time.

1

Plug the travel adapter into the jack on the

headset.

2

Plug the travel adapter into the electrical

outlet.

• Charge the headset until the red light on the
headset turns to blue.

• The headset will be fully charged in
approximately 2 hours 30 minutes.

Test and use

Your phone and headset are now paired and
ready to make and receive calls. To confirm
they are operating properly, make a call:

1

Place the headset over your ear.
See Wearing the headset on the reverse
side of this guide.

2

On your phone, make a call to the number
you want.

3

If your phone and headset are successfully
paired, you will hear ringing on the headset.

After you have successfully paired your phone
and headset, you do not need to repeat these
initial setup steps each time you use the
headset.

3

Remove the travel adapter from the headset.

NOTES:

• The headset cannot be used while charging.

• Use only a Samsung-approved charger or adapter.

Using your WEP180

See Features and Functions Guide
on the reverse side of this guide
for information on using your
WEP180.