Samsung WT75D3, WT75C3, WT65D2, SWT70D2P, SWT65D2P User Manual

...
FEATURES 1 PRECAUTIONS 1 DESCRIPTION AND CLEANING OF PART 2 CLEANING THE MACHINE 2 CONTROL PANEL 2 WASHING PROCEDURE 3
To Wash 3 To Spin Dry 3 To Rinsing 3 Overflow rinse 3 Additional rinse 4
INSTALLATION 4
Location 4 Connecting the drain hose 4
Mounting the legs 4
LAUNDRY GUIDE 5 MAINTENANCE 5 TROUBLE SHOOTING 5
WASHING MACHINE
Owner’s Instructions
SW-T65A1(P) / SW-T65B1(P) / SW -T65C1(P)
Before operating the washing machine, please read this manual
thoroughly, and retain it for future reference.
Remove the cap-hose from the drain hose.
In the case of pump drained washer, remove the cap-hose from the drain hole.
Don't use excessively hot water. (50˚C or more)
Plastic parts may be deformed or damaged. Also, clothing may be deformed or decolored.
Before washing,check all pockets.
If nails or pins remain in pockets,they may damage the washer or clothes.
Close the water tap a little if the water pressure is too high.
Never splash water on the control panel.
Be sure to cover with the inner
cover on laundry before spinning.
This prevents laundry from being tossed out and damaged.
To avoid water splashes, close the wash tub lid.
Be sure laythe drain hose down.
(in case no drain pump)
Be sure that the washer is grounded.
To avoid electrical shock,use a metal pipe for the ground connection. But, don't ground the washer with gas pipes or telephone lines to avoid to dangers of explosion or lightning strike.
Do not put your hands into the
spin dryer basket when it is spinning.
Your fingers can be caught by spinning laundry and damaged.
Never allow children to operate
or play with the washer.
Children playing with the washer may accidentally fall into the washing tub.
Disconnect the power cord from the
power supply when not in use.
Ventilation opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor.
If the supply cord of this appliance is damaged, it must only be replaced by a repair shopappointed by the manufacturer, because special purpose tools are required.
Warning to avoid overfilling and damages this appliance must be filled with the operator present using a moderate water supply pressure only.
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any other appliance.
To avoid overfilling and damages this appliance
must be filled with the operator present using a moderate water supply pressure only.
1.
WASH TIMMER
This is used to set the wash time, 1-15 minutes.
2.CYCLE SELECTOR
This is used to set the Washing/Rinsing or Draining.
3.
SPIN DRY TIMER
This is used to set the spin time, 1-5 minutes.
4.WATER
SELECTOR(FOR SW-50B1)
During washing, WATER SELECTOR KNOB should be selected. During spin rinsing, WATER SELECTOR KNOB should be selected.
5
.WASH
SELECTOR
This is used to select wash action. You can wash laundry effectively by various methods.

CONTROL PANEL

Wash/Rinse
Drain Rinse
CYCLE SELECTOR
Wash
Drain
CYCLE SELECTOR
0
3
1
4
2
5
SPIN DRY TIMER
Soft
Normal
WASH SELECTOR
0
9
3
12
6
15
WASH TIMER
WATER SELECTOR
Wash
Spin

BEFORE USING THE WASHING MACHINE

CAUTIONS

PRECAUTIONS WHEN OPERA TING

1
HOW TO CLEAN THE FILTER
(In case drain pump)
1. Place a rag under the washer filter not to wet the floor.
2. Rotate the filter counterclockwise and pull out the filter.
3. Remove dirts and rotate the filter clockwise until it locks in position.
When you open this lid while the spin basket is spinning,the spinning will be stopped by the brake system.
POWER CORD
EARTH WIRE
WATER DRAIN HOSE
(without pump)
SPIN DRYER BASKET
PULSATOR
The plug’s shape may not be similar to that shown in this drawing.
SPIN DRYER LID
(with pump)
WASH TUB LID
Be sure to keep
the lid closed
during washing
and spinning.
WASH TUB
DRAIN FILTER
DRAIN HOSE
OVERFLOW
FILTER
LINT FILTER
INNER LID

DESCRIPTION AND /CLEANING OF PARTS

.
This is used for
gathering the
dregs made during
washing.
CLEANING THE FILTER
Pull the overflow filter out and take up the filter by removing 3 screws as shown in figure. Wash the filter and washing tub.
CLEANING THE FILTER
Push the strainer(filter) out and take up the filter as shown in figure.
Wash the filter and washing tub.
DRAIN FILTER
In case of incomplete drain, disassemble the drain filter with screw driver(+), and remove lints from the filter as shown in the filter as shown in the figure.
CLEANING THE WASH TUB
First, fill water in the wash tub to ‘L’ level(
, then drain water from the wash tub simultaneously with
operating wash cycle for 1~2 minutes. Close the wash tub lid.
2
OVERFLOW FILTER
Pull the upper side of the overflow filter with your fingers into the holes in the direction of arrow as shown
in the figure.
CLEANING THE LINT FILTER
If the dregs are piled up in the lint filter after finishing the wash, push down and pull it out as shown in the figure.
Wash the filter net in water.
OVERFLOW FILTER
Pull the upper side of the overflow filter with two fingers inserted into hole ‘A’ in the direction of arrow as shown in the figure.
A
Loading...
+ 4 hidden pages