Samsung SW-D7R1 User Manual [ja]
Washing Machine
Owner’s Instructions
SW-D7R1
Safety Precautions
Congratulations on your purchase of this Samsung washing machine. These Owner's
Instructions contain valuable information on the installation, use, and care of this appliance.
Please take the time to read these instructions so that you can take full advantage of the
washing machine's features and enjoy this appliance for many years to come.
Before using the appliance
• Packing materials can be dangerous to children; keep all packing material (plastic bags,
polystyrene, etc.) well out of the reach of children.
• The appliance is designed for home use only.
• Make sure that water and electrical connections are made by qualified technicians,
observing the manufacturer's instructions (see "Installing the Washing Machine" on
page 2) and local safety regulations.
• All packaging and shipping bolts must be removed before the appliance is used. Serious
damage may occur if they are not removed. See "Removing the shipping bolts" on page 3.
• Before washing clothes for the first time, you must run a complete cycle without clothes.
See "Washing for the first time" on page 9.
Safety instructions
• Before cleaning or carrying out maintenance, unplug the appliance from the electrical
outlet or set the (On/Off) button to Off.
• Make sure that the pockets of all clothing to be washed are empty.
Hard, sharp objects, such as coins, safety pins, nails, screws, or stones can cause
extensive damage to the appliance.
• Always unplug the appliance and turn off the water after use.
• Before you open the door of the appliance, check that the water has drained. Do not
open the door if you can still see water.
• Pets and small children may climb into the appliance. Check the appliance before each
use.
• The glass door becomes very hot during the washing cycle. Keep children away from
the appliance while it is in use.
• Do not attempt to repair the appliance yourself. Repairs made by inexperienced or
unqualified persons may cause injury and/or make more serious repairs to the
appliance necessary.
• If the plug (power supply cord) is damaged, it must be replaced by the manufacturer or
its service agent or a similar qualified person in order to avoid a hazard.
• This appliance should only be serviced by an authorized service center, and only
genuine spare parts should be used.
●
SAVE THESE INSTRUCTIONS
Table of Contents
Safety Precautions------------------------------------------- inside cover
lnstalling the Washing Machine
Unpacking the washing machine ----------------------------------------------------2
Overview of the washing machine --------------------------------------------------2
Selecting a location -------------------------------------------------------------------- 3
Adjusting the leveling feet ------------------------------------------------------------3
Removing the shipping bolts --------------------------------------------------------3
Connecting the water supply hose ------------------------------------------------- 4
Connecting the water supply hose(option) -------------------------------------- 5
Positioning the drain hose ----------------------------------------------------------- 5
------------------------------------------2
Washing a Load of Laundry ------------------------------------------------ 6
Washing for the first time ------------------------------------------------------------- 6
Putting detergent in the washing machine --------------------------------------- 6
Overview of the control panel ------------------------------------------------------ 7
Washing clothes using Fuzzy Logic ----------------------------------------------- 9
Washing clothes manually --------------------------------------------------------- 10
Using delay start --------------------------------------------------------------------- 10
Washing tips and hints ------------------------------------------------------------- 11
Maintaining the Washing Machine --------------------------------- 12
Draining the washing machine in an emergency ----------------------------- 12
Repairing a frozen washing machine -------------------------------------------- 12
Cleaning the exterior ---------------------------------------------------------------- 12
Cleaning the detergent drawer and recess ----------------------------------- 13
Cleaning the debris filter ------------------------------------------------------------ 13
Cleaning the water hose mesh filter --------------------------------------------- 14
Troubleshooting ----------------------------------------------------------------- 15
Problems and solutions ------------------------------------------------------------ 15
Understanding error messages --------------------------------------------------- 15
Appendix ------------------------------------------------------------------------------ 16
Fabric care chart --------------------------------------------------------------------- 16
Electrical warnings ------------------------------------------------------------------ 16
Protecting the environment -------------------------------------------------------- 17
Declaration of conformity ---------------------------------------------------------- 17
Specification --------------------------------------------------------------------------- 17
SAMSUNG
Washing Machine Owner’s Instructions 1
Installing the Washing Machine
Unpacking the Washing Machine
Unpack your washing machine and inspect it for shipping damage. Also make sure that
you have received all of the items shown below. If the washing machine was damaged
during shipping or you do not have all of the items, contact your Samsung dealer
immediately.
Overview of the washing machine
Worktop
Control panel
Base cover
Adjustable feet
Wrench
Hose guide
Drain Hose
Plug
Debris filter
Door release
Emergency drain
tube
Filter-cover
Cold Water
supply hose
Drain Hose
Bolt hole
covers
2
SAMSUNG
Washing Machine Owner’s Instructions
Installing the Washing Machine
Selecting a location
Before you install the washing machine, select a location with the following characteristics:
• A hard, level surface (if the surface is uneven, see "Adjusting the leveling feet," below)
• Away from direct sunlight.
• Adequate ventilation
• Room temperature that will not fall below 0 ˚C
• Away from sources of heat such as coal or gas
Make sure that the washing machine does not stand on its power cord.
Ventilation openings must not be obstructed by carpeting when the washing machine is
installed on a carpeted floor.
Adjusting the leveling feet
If the floor is uneven, adjust the feet
(do not insert pieces of wood or any other
objects under the feet):
1. Loosen the leg bolt by turning it with
your hand until it is at the desired height.
2. Tighten the locking nut by turning it
with the supplied wrench.
If the washer is placed on an uneven or weak
surface, noise or vibration occurs.
(Only l degree angle is allowed.)
Removing the shipping bolts
Before using the washing machine, you
must remove the five shipping bolts from the
back of the unit. To remove the bolts:
1. Loosen all bolts with the supplied
wrench before removing them.
2. Take each bolt head and pull it through
the wide part of the hole.
Repeat for each bolt.
3. Fill the holes with the supplied plastic
covers.
4. Keep the shipping bolts for future use.
SAMSUNG
Washing Machine Owner’s Instructions 3
Installing the Washing Machine
Connecting the water supply hose
The water supply hose must be connected to the washing machine at one end and to the water
faucet at the other. Do not stretch the water supply hose. If the hose is too short replace the
hose with a longer, high pressure hose.
To connect the water supply hose:
1. Take the L-shaped arm fitting for the cold water supply hose and connect to the cold water
supply intake on the back of the machine. Tighten by hand.
2. Connect the other end of the cold water supply hose to your sink's cold water faucet and
tighten it by hand. If necessary, you can reposition the water supply hose at the washing
machine end by loosening the fitting,rotating the hose, and retightening the fitting.
Hot water
supply value
Option:
1. Take the red L-shaped arm fitting for the hot water supply hose and connect to the red
hot water supply intake on the back of the machine. Tighten by hand.
2. Connect the other end of the hot water supply hose to your sink's hot water faucet and
tighten it by hand.
3. Use a Y-piece if you only want to use cold water.
4
SAMSUNG
Washing Machine Owner’s Instructions
Installing the Washing Machine
a
b
Connecting the water supply hose(Option)
1. Remove the adaptor from the water
supply hose.
c
2. First, using a “+” type screw driver,
loosen the four screws on the
adaptor. Next, take the adaptor
and turn part(b) following the
arrow until there is a 5mm gap.
3. Connect adaptor to the water tap by
tightening the screws firmly.
Then, turn part (b) following the
arrow and put(a) and (b) together.
NOTICE After completing connection, if water leaks from the hose, then repeat the same steps. Use
the most conventional type of faucet for water supply. In case the faucet is square or too big,
remove the spacing ring before inserting the faucet into the adaptor.
4. Connect the water supply hose to
the adaptor. Pull down part (c) of the
water supply hose. When you
release part (c) the hose automatically connects to the adaptor
making a ’click’ sound.
5. Connect the other end of the water
supply hose to the inlet water valve
at the rear of the washer. Screw the
hose clockwise all the way in.
Positioning the drain hose
The end of the drain hose may be positioned in three ways:
Over the edge of a wash basin.
The drain hose must be placed at a height
of between 60 and 90 cm. To keep the
drain hose spout bent, use the supplied
plastic hose guide. Secure the guide to the
wall with a hook or to the faucet with a
piece of string to prevent the drain hose
from moving.
ln a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the hose is at least
60 cm above the ground.
ln a drain pipe
Samsung recommends that you use a 65 cm high vertical pipe; it must be no shorter than
60 cm and no longer than 90 cm.
SAMSUNG
Washing Machine Owner’s Instructions 5
Washing a Load of Laundry
Washing for the first time
Before washing clothes for the first time, you must run a complete cycle without clothes. To do
this:
1. Press the (On/Off) button.
2. Pour a little detergent into compartment in the
detergent drawer.
3. Turn on the water supply to the washing machine.
4. Press the Temperature button repeatedly until
40 ˚C is displayed.
5. Press the Start/Pause button.
This will remove any water from the manufacturer’s
•
test run remaining in the machine.
Dispender :Detergent for prewash or starch.
Dispenser : Detergent for main wash, water softener,pre-soaking agent, bleach and stain removal product.
Dispenser : Additives,e.g.fabric softener or former (fill no higher than lower edge of insert “ A”
Putting detergent in the washing machine
1. Pull out the detergent drawer.
2. Add laundry detergent into compartment .
3. Add softener into compartment (if you desire).
4. Add prewash detergent into compartment (if you desire).
Caution :
Concentrated or thick fabric softener and
conditioner must be diluted with a little water
before being poured into the dispenser (prevents
the overflow from becoming blocked.)
6
SAMSUNG
Washing Machine Owner’s Instructions
Loading...