Samsung SPF-105P User Manual
|
T
Safety Symbols| Power
Safety Symbols
Make sure to follow the directions below to prevent accidents and damage to the product.
Failure to follow the accompanying directions may lead to serious injury or death.
Failure to follow the accompanying directions may lead to minor personal injury or property damage.
|
Installation| Using and Cleaning
|
|
Safety Symbols| Power
Power
he images here are for reference only, and are not applicable in all cases (or countries).
Insert the power plug correctly until it is firmly in place.
z
Failing to do so, may cause fire.
Do not use a damaged power plug, cord or outlet, as this may cause electric shock
or fire.
Do not touch the power plug with wet hands, as this may cause electric shock.
|
Installation| Using and Cleaning
|
Do not connect more than one appliance to a single outlet, as an overheated outlet
may cause fire.
Do not use force to pull the power cord. Don't place anything heavy on the power
cord, as this may cause electric shock or fire.
z Failing to do so, may cause electric shock or fire.
Make sure to turn the power off and disconnect the power plug from the outlet
before moving the product. Make sure to disconnect the connection cables from
other devices as well.
z Moving the product without disconnecting the power cord may damage it while
moving, and may cause electric shock or fire.
Hold and pull out the plug by its body when disconnecting it from the outlet, as
pulling the plug out by the cord may cause it to be damaged.
z
Failing to do so, may cause fire, or the product may not turn on normally.
Ensure that the power plug is disconnected before cleaning the product.
z Failing to do so, may cause electric shock or fire.
Keep the product away from places exposed to oil, smoke or moisture; do not
install inside a vehicle.
z This may cause a malfunction, electric shock or fire.
z In particular, avoid operating the monitor near water or outdoors where it could be
exposed to snow or rain.
Do not install the product near any heating appliance.
z There is a risk of fire.
Installation
|
Safety Symbols| Power
|
Installation| Using and Cleaning
When installing the product on a cabinet or shelf, do not let the front end of the
product project beyond its front edge.
z Failing to do so, may cause the product to fall, resulting in a product malfunction or
|
personal injury.
Do not place the power cord near a heater, as the power cord may melt, causing
electric shock or fire.
Do not install the product in a car or a location exposed to oil, smoke, moisture,
water, or rainwater.
z Any contact of these materials with the product may cause electric shock or fire.
Disconnect the power plug when there is thunder or lightning.
z Failing to do so, may cause electric shock or fire.
Place the product down gently when installing it.
z Failing to do so may cause product damage or personal injury.
Avoid dropping the product when moving, as this may cause product damage or
personal injury.
Do not install the product in a location easily reached by children.
z As the product may fall and cause personal injury.
Using and Cleaning
|
Safety Symbols| Power
|
Installation| Using and Cleaning
Do not insert any metal objects such as forks, wire, or gimlets, or flammable items
such as paper or matches into the ports at the back of the product, as this may
cause electric shock or fire.
|
z If water or any foreign substance enters the product, make sure to turn the product
off and disconnect the power plug from the outlet, and contact a service center.
Never disassemble, repair, or modify the product yourself.
z If you need to repair your product, contact a service center. An attempt at repairing
this product may cause electric shock or fire.
If you hear a strange sound, smell anything burning, or see smoke, disconnect the
power plug immediately and contact a service center.
z Failing to disconnect the power plug may cause electric shock or fire.
Always remove dust and water from the pins and connections of the power plug.
z Failing to do so may cause electric shock or fire.
When cleaning the product, first disconnect the power plug and clean it with a soft,
dry cloth.
z Do not use any chemicals such as benzene, alcohol, thinners, mosquito repellant,
aromatic, lubricant, detergent or wax.
When not using the product for a long time, make sure to disconnect the power plug.
z Heavy accumulated dust may cause electric shock or fire.
If the product needs to be installed in a location that doesn't satisfy general
conditions, make sure to contact one of our service engineers about the installation
as the product may encounter serious quality problems due to its environment.
z This refers to locations exposed to conditions such as heavy fine dust, chemicals, high or
low temperature, moisture, or when the product needs to be used continually without a
break over a long time.
If the product has been dropped or the product casing is damaged, turn it off and
disconnect the power plug.
z Using the product without verifying that it has not been damaged may cause electric
shock or fire. Please contact a service center.
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment) - Europe only
(Applicable in the European Union and other European countries with separate
collection systems)
This marking shown on the product or its literature, indicates that it should not be disposed
with other household waste at the end of its working life. To prevent possible harm to the
environment or damage to health from uncontrolled waste disposal, please separate this from
other types of waste and recycle it responsibly to promote the sustainable reuse of material
resources.
Household users should contact either the retailer where they purchased this product, or their
local government office, for details of where and how they can take this item for
environmentally safe recycling.
Business users should contact their supplier and check the terms and conditions of the
purchase contract. This product should not be mixed with other commercial wastes for
disposal.
|
Features| Components| Front| Back| Side/Bottom
Features
Expansion of built-in memory using memory cards. Instant view of stored images
Background music function.
Can be used for a specific period of time with the battery only without being connected to a power outlet
Provides the Mini-Monitor function.
Stylish design
Premium stylish appearance design product that can be used a decoration on a desk or table
Rotating stand allowing vertical/horizontal placement
|
|
Features| Components| Front| Back| Side/Bottom
Please check that all components are contained in the delivered package.
If anything is omitted, contact the local distributor where the product was purchased. For optional items, contact a service center.
Never use a power adapter other than the adapter provided with the product.
Components
Digital Photo Frame
(The product color and shape may vary depending on the model.)
Manual
|
Cables
Quick Start
Warranty
(Not available in all locations)
User Manual
Power cord USB cable (A-B type) Power Adapter
T
T
T
T
Y
|
Features| Components| Front| Back| Side/Bottom
Front
he product color and shape may vary depending on the model.
his product is a touch type product. If you lightly touch the button on the right of the product, the button light is
turned on. When the button light is turned on, you can then operate each button's menu.
[MENU] Menu Button Displays the menu window at the bottom left corner of the screen.
[] Up Button
[] Left Button
[ ] Right Button
Used for moving up.
Used for moving left.
Used for moving right.
|
[ ] Down Button
[ ] Enter Button
[ ] Back Button
[ ] SlideShow Button
Used for moving down.
Used for selection
Returns to the previous menu.
Starts a slideshow.
|
Features| Components| Front| Back| Side/Bottom
|
Back
he product color and shape may vary depending on the model.
Power terminal
[] Power Button
Stand
Sliding Prevention
Holder
Connect the power adapter to this jack.
Connect the power cord to the power terminal of the power adapter.
urns the product on or off.
ou can use the product in a vertical or horizontal direction by using the rotating stand.
Supports the product so that it stays firmly in place on slippery surfaces.
Loading...