Samsung SC-88L0 User Manual
imagine the possibilities
Thank you for purchasing a Samsung product.
To receive a more complete service,
please register your product at
www.samsung.com/register
Vacuum Cleaner
user manual
✻ Before operating this unit, please read the instructions carefully.
✻ For indoor use only.
English
SC88** series
2_ safety information
safety information
SAFETY INFORMATION
•
Before operating the appliance, please read this manual thoroughly and retain it for
your reference.
•
Because these following operating instructions cover various models, the
characteristics of your vacuum cleaner may differ slightly from those described in this
manual.
CAUTION/WARNING SYMBOLS USED
WARNING
Indicates that a danger of death or serious injury exists.
CAUTION
Indicates that a risk of personal injury or material damage exists.
OTHER SYMBOLS USED
Represents something you must NOT do.
Represents something you must follow.
Indicates that you must disconnect the power plug from the socket.
This vacuum cleaner is designed for domestic household use only. Do not use this
vacuum cleaner to clean building waste or debris. Do not use this vacuum cleaner with
any of the filters removed as this could cause damage to the internal components and
void your warranty.
WARNING
WARNING
WARNING
safety information _3
IMPORTANT SAFEGUARDS
1. Read all instructions carefully. Before switching on, make sure that the voltage of your
electricity supply is the same as that indicated on the rating plate on the bottom of the
cleaner.
2. WARNING : Do not use the vacuum cleaner when rug or floor is wet.
Do not use to suck up water.
3. Close supervision is necessary when any appliance is used by or near children. Do
not allow the vacuum cleaner to be used as a toy. Do not allow the vacuum cleaner
to run unattended at any time. Use the vacuum cleaner only for its intended use as
described in these instructions.
4. Do not use the vacuum cleaner without a dust bin. Empty the dust bin before it is full
in order to maintain the best efficiency.
5. Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts.
Keep the vacuum cleaner away from stoves and other heat sources. Heat can deform
and discolour the plastic parts of the unit.
6. Avoid picking up hard, sharp objects with the vacuum cleaner as they may damage
the cleaner parts. Do not stand on the hose assembly. Do not put weight on the hose.
Do not block the suction or the exhaust port.
7. Switch the vacuum cleaner off on the body of the machine before unplugging from
the electrical outlet. Disconnect the plug from the electrical outlet before emptying the
dust bin. To avoid damage, please remove the plug by grasping the plug itself, not by
pulling on the cord.
8. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
9. Children should be supervised to ensure that they do not play with the appliance.
10. The plug must be removed from the socket outlet before cleaning or maintaining the
appliance.
11. The use of an extension cord is not recommended.
12. If your vacuum cleaner is not operating correctly, switch off the power supply and
consult an authorized service agent.
13. If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.
14. Don’t carry the vacuum cleaner by holding the hose.
Use the handle on the vacuum cleaner set.
15. Unplug the cleaner when not in use. Turn off the power switch before unplugging.
safety information
4_ contents
contents
ASSEMBLING THE CLEANER
05
05 Assembling the Cleaner
OPERATING THE CLEANER
06
06 Power cord
06 On/Off switch
06 Power control
MAINTAIN TOOLS AND FILTER
08
08 Using accessory
09 Maintain floor tools
10 Emptying the dust bin
11 Cleaning the dust pack
13 Cleaning the outlet filter
14 Change the battery (optional)
TROUBLESHOOTING
15
01 ASSEMBLING THE CLEANER
assembling the cleaner _5
assembling the cleaner
• Please do not push the button
of dust bin handle when carrying
machine.
• For storage, park the oor nozzle.
OPTION
6_ operating the cleaner
operating the cleaner
POWER CORD
ON/OFF SWITCH
• When removing the plug from the electrical outlet, grasp the
plug, not the cord.
CAUTION
Don’t cover the handle sender when you use a
handle control button.
POWER CONTROL
1. Vacuum cleaner ON/OFF( )
Press the ON/OFF button to operate the
vacuum cleaner. Press again to stop the
vacuum cleaner.
2. Vacuum cleaner (+, -)
Press the (+) button to operate the
vacuum to high suction power. Press the
(-) button to operate the vacuum to low
suction power.
REMOTE-CONTROL TYPE (INFRARED CONTROL) (OPTIONAL)
- HOSE
Handle Control
The cleaner is controlled by using
infrared signals.
sender
02 OPERATING THE CLEANER
operating the cleaner _7
BODY-CONTROL TYPE (OPTIONAL)
- HOSE
To reduce suction for leaning draperies, small rugs, and
other light fabrics, pull the tap air until the hole is open.
- BODY (VOLUME TYPE ONLY)
To control power level, just slide the power control
bottom right and left.
MIN = For delicate fabrics, e.g.net curtains.
MAX = For hard floors and heavily soiled carpets.
- BODY
Press the power ON/OFF button repeatedly to start
and to stop the vacuum cleaner.
(OFF → ON → OFF)
If the remote handle control is not working, the
cleaner can be operated using the ON/OFF
button on the body of the machine.
1
The ON/OFF button operates the vacuum cleanner or stops it.
2
The INFRARED light indicates the part that receives the infra-red
signal from the handle control.
3
The filter light is illuminated when the dust pack requires checking or
emptying. An audio signal will also sound.
1
3 2
8_ maintain tools and filter
maintain tools and filter
USING ACCESSORY
PIPE
• Adjust the length of the telescopic pipe by sliding
the length control button located in the center of the
telescopic pipe back and forth.
• To check for blockages, separate the telescopic pipe
and adjust to shorten. This allows for easier removal of
waste clogging the tube.
ACCESSORY (OPTIONAL)
• Push the accessory on to the end of
the hose handle.
• Pull out and turn the dusting brush
for cleaning delicate areas.
• To use the upholstery tool, push the
accessory on to the end of the hose
handle in the opposite direction.
03 MAINTAIN TOOLS AND FILTER
maintain tools and filter _9
maintain tools and filter _9
MAINTAIN FLOOR TOOLS
2-STEP BRUSH (OPTION)
• Adjust the inlet lever according to the floor surface.
• Remove waste matter completely if the inlet is blocked.
Carpet Cleaning Floor Cleaning
•
Vacuum dust in wide area at once.
•
Remove waste matter completely if
the inlet is blocked.
PARQUET MASTER BRUSH (OPTION)
POWER PET PLUS BRUSH (OPTION)
Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to
matters tangled around the drum. In this case, clean the drum with care.
1. Push the Open button of the transparent screen cover to separate the cover.
2. Remove the brushbar from the transparent screen.
3.
Remove waste matter such as dust and hair tangled around the brushbar using scissors.
4. Remove dust inside the brush housing using a dry duster or crevice tool.
5. Insert brushbar into rotating belt and assemble.
6. Click the transparent screen cover back into place to reassemble.
1 2 3
4 5 6
For improved
pickup of pet
hair and fibre on
carpets.
10_ maintain tools and filter
maintain tools and filter
EMPTYING THE DUST BIN
Once dust reaches the dust
full mark, empty the dust bin.
Take the dust bin out by
pushing the button.
Separate the dust bin cover.
Throw the dust away in the
bin.
Close the dust bin cover.
Before use, push the dust
bin into the main body of
the vacuum cleaner until
you hear the “click” sound.
4 5 6
1 2 3
You may rinse the dust bin
with cold water.
- Empty into a plastic bag.
(recommended for asthma/allergy sufferers)
03 MAINTAIN TOOLS AND FILTER
maintain tools and filter _11
When suction is noticeably reduced continuously, please cleaning the dust pack.
CLEANING THE DUST PACK
WHEN TO CLEAN THE DUST PACK
• The lamp will turn red
when suction is reduced.
If the light comes on,
please clean the dust
pack.
• If the filter check indicator turns red with the inlet
floating 10cm above flat floor, clean the dust pack.
• Turn the vacuum power to ‘MAX’.
ON(MAX) � OFF
Handle Control
Body Control
12_ maintain tools and filter
maintain tools and filter
Make sure the filter is completely dry
before putting it back into the vacuum
cleaner. Allow 12 hours for it to dry.
CLEANING THE DUST PACK
1
4
7
10
2
5
8
11 12
3
Remove the dust bin. Separate the dust bin cover.
Before reassembly, align the
dust pack cover and dust
pack correctly.
Close the dust bin cover.
Before use, push the dust
bin into the main body of
the vacuum cleaner until
you hear the “click” sound.
Remove the fixed frame of
the dust pack cover.
Separate the dust pack.
Let the sponge and filter dry
in the shade for more than
12 hours.
Put the sponge and lter into
the dust pack.
Remove the sponge and
filter from the dust pack.
Wash the sponge and the
filter of the dust pack with
water.
Put the assembled dust
pack into the cover.
6
9
03 MAINTAIN TOOLS AND FILTER
maintain tools and filter _13
CLEANING THE OUTLET FILTER
1 2
Press the xed frame part at the back of
the main body to remove.
Remove the dust bin and HEPA Filter as
shown.
Remove and replace the
blocked outlet filter.
Replacement filters are available at
your local Samsung distributor.
14_ maintain tools and filter
maintain tools and filter
CHANGE THE BATTERY (OPTIONAL)
1. When the vacuum cleaner dows not work, replace the batteries.
If the problem persists, please contact our authorized dealer.
2. Use 2 batteries of size AAA.
1. Never disassemble or recharge the batteries.
2. Never heat up the batteries or throw them into fire.
3. Do not reverse (+), (-) poles.
4. Dispose of the batteries property.
WARNING
BATTERY TYPE : AAA Size
04 TROUBLESHOOTING
troubleshooting _15
troubleshooting
PROBLEM SOLUTION
Motor does not start
• Check cable, pulg and socket.
• Leave to cool.
Suction force is gradually
decreasing
• Check for blockage and remove.
Cord does not rewind
fully
• Pull the cord out 2-3m and push down the cord rewind
button.
Vacuum cleaner does
not pick up dirt
• Check hose and replace if required.
Low or decreasing
suction
• Please check lter and, if required, clean as illustrated in the
instructions. if lters are out of condition change them to new
ones.
Body overheating
• Please check lters, If required clean as illustrated in the
instruction.
Static electicity discharge • Please decrease power suction.
This Vacuum cleaner is approved the following.
EMC Directive : 2004/108/EEC
Low Voltage Directive : 2006/95/EC
Loading...