Samsung SC-8571 User Manual

Operating Instructions

VACUUM CLEANER

❈

Before operating this unit, please read the instructions carefully.

❈ Indoor use only.

IMPORTANT SAFEGUARDS

1. Read all instructions carefully. Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate on the bottom of the cleaner.

2. WARNING : Do not use the vacuum cleaner when rug or floor is wet.

Do not use to suck up water.

3. Close supervision is necessary when any appliance is used by or near children. Do not allow the vacuum cleaner to be used as a toy. Do not allow the vacuum cleaner to run unattended at any time. Use the vacuum cleaner only for its intended use as described in these instructions.

4. Do not use the vacuum cleaner without a dust bin. Empty the dust bin before it is full in order to maintain the best efficiency.

5. Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts. Keep the vacuum cleaner away from stoves and other heat sources. Heat can deform and discolour the plastic parts of the unit.

6. Avoid picking up hard, sharp objects with the vacuum cleaner as they may damage the cleaner parts. Do not stand on the hose assembly. Do not put weight on the hose. Do not block the suction or the exhaust port.

7. Switch the vacuum cleaner off on the body of the machine before unplugging from the electrical outlet. Disconnect the plug from the electrical outlet before changing the dust bag or dust container. To avoid damage, please remove the plug by grasping the plug itself, not by pulling on the cord.

8. This appliance is not intended for use by young persons or infirm persons without supervision unless they are adequately supervised by a responsible person to ensure that they can use the appliance safely. Young children should be supervised to ensure that they do not play with the appliance.

9. The plug must be removed from the socket outlet before cleaning or maintaining the appliance.

10. The use of an extension cord is not recommended.

11. If your vacuum cleaner is not operating correctly, switch off the power supply and consult

an authorized service agent.

12. If the supply cord is damaged, it must be replaced by the manufacturer or its service

agent or a similarly qualified person in order to avoid a hazard.

13. Don’t carry the vacuum cleaner by holding the hose.

Use the handle on the vacuum cleaner set.

EN-1

ASSEMBLING THE CLEANER

OPTION

Features may vary according to model.

▼

CAUTION :

Please do not use dust bin handle when carrying machine.

EN-2

For storage, park the floor nozzle.

OPERATING THE CLEANER

2-1 POWER CORD

Please make sure your cable is fully extended before use.

2-2 POWER CONTROL (INFRARED CONTROL)

1. Vacuum cleaner ON/OFF

- HOSE

SENDER

Press the ON/OFF button to operate the vacuum cleaner. Press again to stop the vacuum cleaner.

2. Vacuum cleaner MODE (+/-) Press the MODE button repeatedly to select the correct

mode.

(ON) MIN → MID → MAX

NOTE

When removing the plug from the electrical outlet, grasp the plug, not the cord.

HANDLE CONTROL

[The cleaner is controlled by using

infrared signals.]

- BODY

The filter light is illuminated when the dust pack requires checking or emptying. An audio signal will also sound.

The IR light indicates the part that receives the infra-red signal from the handle control.

3. Using Auto mode Press the Auto button to operate the vacuum cleaner automatically.

Press the power control button repeatedly to select the correct mode. (ON(MAX) → OFF)

NOTE : If the remote handle control is not

working, the cleaner can be operated using the control button on the body of the machine.

This shows the generation of negative ions when the vacuum cleaner is in operation.

This indicates that the automatic suction mode is selected. The level of suction is indicated by the LED display.

EN-3

2-3 HOW TO USE AND MAINTAIN THE ACCESSORIES

Features may vary according to model.

▼

PIPE

Adjust the length of the telescopic pipe by sliding the length control button located in the center of the telescopic pipe back and forth.

To check for blockages, separate the telescopic pipe and adjust to shorten. This allows for easier removal of waste clogging the tube.

ACCESSORY

ELBOW EXTENDING TUBE

1234 5

(OPTION)

1. Connect the elbow extending tube to connecting part for hose knob and telescopic pipe.

2. Fit the telescopic pipe to the lower part of the elbow extending tube.

3. Press the PUSH button.

4. With the PUSH button pressed, the elbow extending tube is folded.

5. Using the elbow extending tube allows hard to reach areas (e.g. under furniture)to be cleaned without having to kneel down.

OPTION

▲▲

▲ Carpet

Cleaning

Push the accessory on to the end of the hose handle.

Pull out and turn the dusting brush for cleaning delicate areas.

To use the upholstery tool, push the accessory on to the end of the hose handle in the opposite direction.

♣ Floor

Cleaning

Adjust the inlet lever according to the floor surface.

EN-4

Remove waste matter completely if the inlet is blocked.

OPTION

Vacuum dust in wide area at once

Remove waste matter completely if the inlet is blocked.

OPTION

For improved pick-

up of pet hair and

fibre on carpets

OPTION

Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to matters tangled around the drum. In this case, clean the drum with care.

1 2 3

Push the Open button of the transparent screen cover to separate the cover.

Remove dust inside the brush housing using a dry duster or crevice tool.

Clogs on turbine keeps brush from turning, and in this case, take care of it.

Remove the brushbar from the transparent screen.

Insert brushbar into rotating belt and assemble.

Remove waste matter such as dust and hair tangled around the brushbar using scissors.

Click the transparent screen cover back into place to reassemble.

Brush for blanket

For picking up pet hair and fibre on upholstery and bed linen.

Remove waste matter completely when inlet is blocked.

Warning : Use for bedclothes only. Be cautious not to damage brush during unclogging.

Turn the lock button to ‘UNLOCK’, and remove waste matter.

EN-5

To reassemble, align the cover to the front of the main body and close. After closing the cover, ensure that the lock button is turned to the ‘LOCK’ position.

CLICK

EMPTYING THE DUST BIN

1 2 3

Once dust reaches the dust full mark, or once the filter check light is on, empty the dust bin.

4 5

Throw away dust in the bin.

- Empty into a plastic bag (recommended for asthma/allergy sufferers)

Close the dust bin cover.

Take the dust bin out by pressing the button.

Separate the dust bin cover.

Before use, push the dust bin into the main body of the vacuum cleaner until you hear the "click" sound.

NOTE

You may rinse the dust bin with cold water

EN-6

CLEANING THE DUST PACK

4-1. WHEN TO CLEAN THE DUST PACK

- If suction is noticeably reduced during cleaning, please check the dust pack as indicated below.

Suction is significantly weakened during cleaning. Shaking sound of inlet stuck to the floor (soft mats, blankets, etc.) is heard.

Turn the vacuum power to 'MAX'

HANDLE CONTROL

If the filter check indicator turns red with the inlet floating 10 cm above flat floor, clean it.

EN-7

When the indicator light comes on, please empty the Dust Pack(4-2) as shown in the following illustrations.

4-2 CLEANING THE DUST PACK

Remove the dust bin and dust pack as shown.

Remove the fixed frame of the dust pack cover.

Wash the sponge and the filter of the dust pack with water.

Let the sponge and dust pack dry in the shade for more than 12 hours.

Remove the sponge pad from the dust pack.

Put the sponge into the dust pack.

7 8

Before reassembly, align the dust pack cover and dust pack correctly.

NOTE :

Make sure the filter is completely dry before putting it back into the vacuum cleaner. Allow 12 hours for it to dry.

Put the assembled dust pack into the main body.

EN-8

CLICKCLICK

CLICK

CLEANING THE MOTOR PROTECTION FILTER

Remove the motor protection filter from

Take out both the dust bin and the dust pack.

CLEANING THE OUTLET FILTER

the vacuum cleaner. Shake and tap the dust from it and put back in machine.

Lift the handle. Hold the handle of the

Dust off the outlet filter by gently tapping.

outlet filter and lift to remove.

Before reassembly, align the outlet filter cover and the outlet filter correctly, and push the outlet filter until you hear a click sound.

EN-9

Remove the fixed frame of the outlet filter cover.

Push the outlet filter into the main body until you hear a click sound.

CHANGE THE BATTERY(OPTIONAL)

BATTERY TYPE : AA Size

NOTE

1. When the vacuum cleaner does not work, replace the batteries. If the problem persists, please contact our authorized dealer.

2. Use 2 batteries of size AA.

WARNING

1. Never disassemble or recharge the batteries.

2. Never heat up the batteries or throw them into fire.

3. Do not reverse (+),(-) poles.

4. Dispose of the batteries properly.

- IF YOU HAVE A PROBLEM

PROBLEM CAUSE REMEDY 0

Motor does not start.

Suction force is gradually decreasing.

Cord does not rewind fully. Check that the cord is not

Vacuum cleaner does not pick up dirt.

Low or decreasing suction

This Vacuum cleaner is approved the following. EMC Directive : 89/336/EEC, 92/31/EEC and 93/68/EEC Low Voltage Safety Directive : 73/23/EEC and 93/68/EEC

No power supply. Thermal cut-out.

Nozzle, suction hose or tube is blocked.

twisted or wound unevenly.

Crack or hole in hose.

Filter is full of dust.

Check cable, plug and socket. Leave to cool.

Check for blockage and remove it.

Pull the cord out 2-3m and push the cord rewind button.

Check hose and replace if required.

Please check filter and, if necessary, clean as illustrated in the instructions.

EN-10

Bedienungsanleitung

STAUBSAUGER

❈

Bitte lesen Sie diese Anweisungen vor Benutzung des Geräts sorgfältig durch.

❈ Nur für Benutzung in Innenräumen.

Produkt registrieren und gewinnen unter www.samsung.com/global/register

WICHTIGE SICHERHEITSHINWEISE

1. Lesen Sie die Bedienungsanweisungen sorgfältig durch. Vergewissern Sie sich vor dem Einschalten, dass Ihre Netzspannung der auf dem Typenschild auf der Unterseite des Staubsaugers angeführten Netzspannung entspricht.

2. ACHTUNG: Benutzen Sie den Staubsauger nicht, wenn der Teppich oder Boden nass ist.

Benutzen Sie den Staubsauger nicht zum Aufsaugen von Wasser.

3. Die Benutzung des Geräts durch oder in der Nähe von Kindern darf nur unter strenger Aufsicht erfolgen. Der Staubsauger ist kein Spielzeug. Lassen Sie den Staubsauger niemals unbeaufsichtigt laufen. Benutzen Sie den Staubsauger nur für die in diesen Anweisungen beschriebenen Zwecke.

4. Den Staubsauger nicht ohne staubbehälter benutzen. Den staubbehälter reinigen bevor dieser ganz voll ist. Auf diese Weise verrichtet der Staubsauger immer zuverlässig seinen Dienst.

5. Benutzen Sie den Staubsauger nicht zum Aufsaugen von Streichhölzern, heißer Asche oder Zigarettenkippen. Halten Sie den Staubsauger von Öfen oder anderen Wärmequellen fern. Wärme kann die Kunststoffteile des Geräts verformen und verfärben.

6. Vermeiden Sie das Aufsaugen harter, scharfkantiger Gegenstände mit dem Staubsauger, das sie die Innenteile des Staubsaugers beschädigen können. Stellen Sie sich nicht auf den Saugschlauch. Legen Sie kein Gewicht auf den Saugschlauch. Blockieren Sie nicht den Ansaug- oder Austrittsteil.

7. Den Staubsauger ausschalten, bevor der Netzstecker gezogen wird. Den Stecker ziehen, bevor Sie den Staubbeutel wechseln. Den Stecker immer am Stecker selbst aus der Steckdose ziehen. Nicht am Kabel ziehen.

9. Vor der Reinigung oder Wartung des Gerätes muss dieses vom Stromanschluss entfernt werden.

10. Von der Verwendung eines Verlängerungskabels wird abgeraten.

11. Arbeitet Ihr Staubsauger nicht korrekt, schalten Sie ihn aus, trennen sie ihn vom Netz

und wenden Sie sich an einen autorisierten Kundendienst.

12. Wenn das Stromkabel beschädigt ist, so muss es vom Hersteller, dessen

Servicepersonal oder einer ähnlich qualifizierten Person zur Vermeidung von Gefahren ausgetauscht werden.

13. Den Staubsauger nicht durch Ziehen am Schlauch oder Rohr verlagern. Verwenden Sie

dazu den Griff am Staubsauger.

DE-1

MONTAGE DES STAUBSAUGERS

OPTION

Funktionen können je nach Modell variieren.

▼

VORSICHT :

Staubsauger nicht am Griff des hochheben, dazu ausschließlich den Tragegriff benutzen!

staubbehälters

DE-2

Stellen Sie zur Lagerung die

Bodendüse entsprechend fest.

+ 30 hidden pages