Samsung LT20M22C, LT17M24C, LT15M23C, LT-P2045U, LT-P2045 User Manual

...
English-1
YOUR NEW TV
Rear Panel Jacks
Use the rear panel jacks to connect an A/V component that will be connected continuously, such as a VCR or a DVD player.
POWER INPUT
PC AUDIO IN (STEREO)
Connect to the video output port on your PC.
VIDEO INPUT
Connect a video signal from a camcorder or VCR.
AUDIO INPUT
Connect an audio signal(L/R) from a camcorder or VCR.
S-VIDEO INPUT
Connect an S-Video signal from a camcorder or VCR.
TV ANTENNA
Connect to an antenna or to a cable TV system.
COMPONENT
Connect a component video/audio.
KENSINGTON LOCK
< LT-P1745 > < LT-P1545 / LT-P2045 / LT-P2045U >
BN68-00633A-06Eng 1.qxd.q 5/12/04 6:31 PM Page 3
English-2
I NSTALLATION
3
Connect a coaxial cable between the ANTENNA OUT terminal on the VCR and the antenna terminal on the TV.
4
Connect a set of audio cables between the AUDIO OUT jacks on the VCR and the AUDIO jacks on the TV.
5
Connect a video cable between the VIDEO OUT jack on the VCR and the VIDEO jack on the TV.
Follow the instructions in “Viewing a VCR or Camcorder Tape” to view your VCR tape.
* Each external input source device has a different back panel configuration.
A coaxial cable is usually included with a VCR. (If not, check your local electronics store).
If you have a “mono” (non-stereo) VCR, use the Y-connector (not supplied) to hook up to the left and right audio input jacks of the TV. If your VCR is stereo, you must connect two cables.
Connecting a VCR
These instructions assume that you have already connected your TV to an antenna or a cable TVsystem . Skip step 1 if you have not yet connected to an antenna or a cable system.
1
Unplug the cable or antenna from the back of the TV.
2
Connect the cable or antenna to the ANTENNA IN terminal on the back of the VCR.
BN68-00633A-06Eng 1.qxd.q 5/12/04 6:31 PM Page 10
English-3
I NSTALLATION
3
Connect an S-video cable between the S-VIDEO OUT jack on the VCR and the S-VIDEO INPUT jack on the TV.
An S-video cable is usually included with an S-VHS VCR.
(If not, check your local electronics store.)
* Each external input source device has a different back panel configuration.
1
To begin, follow steps 1–3 in the previous section to connect the antenna or cable to your VCR and your TV.
Connecting an S-VHS VCR
Your Samsung TV can be connected to an S-Video signal from an S-VHS VCR. (This connection delivers a better picture as compared to a standard VHS VCR.)
2
Connect a set of audio cables between the AUDIO OUT jacks on the VCR and the AUDIO INPUT jacks on the TV.
BN68-00633A-06Eng 1.qxd.q 5/12/04 6:31 PM Page 11
Loading...
+ 5 hidden pages