Samsung LTN-170X2-L02 Datasheet
Approval
TO
DATE
SAMSUNG TFT-LCD
SAMSUNG TFT-LCD
MODEL NO. : LTN170X2-L02
MODEL NO. : LTN170X2-L02
NOTE : Extension code [ -G ]
www.jxlcd.com
: FSC
: Sep. 18, 2007.
www.jxlcd.com
→ LTN170X2-L02-G
Surface type [ Glare ]
Any Modification of Spec is not allowed without SEC’ permission
APPROVED BY :
PREPARED BY :
LCD Development G1. Mobile Division
Samsung Electronics Co., Ltd.
Samsung Secret
Doc.No. Rev.No
John Lee
04-A00-G-070918
Page
/ 31LTN170X2-L02
1
CONTENTS
Approval
Revision History
General Description
1. Absolute Maximum Ratings
1.1 Absolute Ratings of environment
1.2 Electrical Absolute Ratings
2. Optical Characteristics
3. Electrical Characteristics
3.1 TFT LCD Module
3.2 Backlight Unit
4. Block Diagram
4.1 TFT LCD Module
4.2 Backlight Unit
5. Input Terminal Pin Assignment
5.1 Input Signal & Power
5.2 LVDS Interface
5.3 Backlight Unit
5.4 Timing Diagrams of LVDS For Transmitting
www.jxlcd.com
www.jxlcd.com
5.5 Input Signals, Basic Display Colors and Gray Scale of Each Color.
5.6 Pixel format
-------------------( 3 )
-------------------( 4 )
-------------------( 5 )
-------------------( 7 )
-------------------( 10 )
-------------------( 13 )
-------------------( 14 )
6. Interface Timing
6.1 Timing Parameters
6.2 Timing Diagrams of interface Signal
6.3 Power ON/OFF Sequence
7. Outline Dimension
8. Packing
9. Markings & Others
10. General Precaution
11. EDID
Samsung Secret
-------------------( 20 )
-------------------( 22 )
------------------- ( 24 )
------------------- ( 25 )
------------------- ( 27 )
------------------- ( 29 )
Doc.No. Rev.No
04-A00-G-070918
Page
/ 31LTN170X2-L02
2
REVISION HISTORY
REVISION HISTORY
LTN170X2-L02 model SPEC was issued first.AllA00Sep. 18, 2006
Approval
SummaryPageRevision No.Date
www.jxlcd.com
www.jxlcd.com
Samsung Secret
Doc.No. Rev.No
04-A00-G-070918
Page
/ 31LTN170X2-L02
3
Approval
GENERAL DESCRIPTION
DESCRIPTION
LTN170X2-L02 is a color active matrix TFT (Thin Film Transistor) liquid crystal display
(LCD) that uses amorphous silicon TFT as switching devices. This model is composed of a
TFT LCD panel, a driver circuit and a backlight unit. The resolution of a 17.0" contains
1,440 x 900 pixels and can display up to 262,144 colors. 6 O'clock direction is the Optimum
viewing angle.
FEATURES
• High contrast ratio, high aperture structure
• Wide XGA+(1440 x 900 pixels) resolution
• Low power consumption
• Fast Response
• DE(Data enable) only mode
• 3.3V LVDS Interface
• Onboard EEDID chip
• Pb free product
APPLICATIONS
• Notebook PC
• If the usage of this product is not for PC application, but for others, please contact SEC
www.jxlcd.com
GENERAL INFORMATION
www.jxlcd.com
mm367.20(H) x 229.50(V) (17.0” diagonal )Display area
a-Si TFT active matrixDriver element
262,144Display colors
RGB vertical stripePixel arrangement
NoteUnitSpecificationItem
16 : 10pixel1440 x 900 (Wide XGA+)Number of pixel
99.6ppimm0.255(H) x 0.255(V) (TYP.)Pixel pitch
Normally whiteDisplay Mode
Haze 0 ( Glare ), Hardness 3HSurface treatment
Samsung Secret
Doc.No. Rev.No
04-A00-G-070918
Page
/ 31LTN170X2-L02
4
Mechanical Information
Approval
Module
size
Note (1) Measurement condition of outline dimension
. Equipment : Vernier Calipers
. Push Force : 500g ⋅f (minimum)
1. ABSOLUTE MAXIMUM RATINGS
1.1 ENVIRONMENTAL ABSOLUTE RATINGS
Operating temperate
(Temperature of glass surface)
Max.
382.7
245.0
7.0
735
NoteUnitTyp.Min.Item
mm382.2381.7Horizontal (H)
mm244.5224.0Vertical (V)
mm6.7-Depth (D)
g715-Weight
NoteUnitMax.Min.SymbolItem
(1),(5)°C60-20 TSTGStorage temperate
(1),(5)°C500TOPR
(2),(4)G240-SnopShock ( non-operating )
Note (1) Temperature and relative humidity range are shown in the figure below.
95 % RH Max. (40 °C ≥ Ta)
Maximum wet - bulb temperature at 39
www.jxlcd.com
www.jxlcd.com
100
-40 -20 0 20 40 60 80
Relative Humidity ( %RH)
90
80
60
40
20
Operating Range
Storage Range
5
0
Temperature (
(2) 2ms, half sine wave, one time for ±X, ±Y, ± Z.
(3) 5 - 500 Hz, random vibration, 30min for X, Y, Z.
(4) At testing Vibration and Shock, the fixture in holding the Module to be tested have to be
hard and rigid enough so that the Module would not be twisted or bent by the fixture.
(5) If product is used for extended time excessively or exposed to high temperatures for extended time,
there is a possibility of wide viewing angle film damage which could affect visual characteristics.
O
C or less. (Ta > 40 °C ) No condensation
( 40,90 )
( 50,50.4 )
( 60,27.7 )
O
C)
(3),(4)G2.41-VnopVibration (non-operating)
Samsung Secret
Doc.No. Rev.No
04-A00-G-070918
Page
/ 31LTN170X2-L02
5
1.2 ELECTRICAL ABSOLUTE RATINGS
(1) TFT LCD MODULE
Approval
VDD =3.3V, VSS = GND = 0V
NoteUnitMax.Min.SymbolItem
+ 0.3VDD-0.3VDDPower Supply Voltage
DD
Logic Input Voltage
Note (1) Within Ta (25 ± 2 °C)
(2) BACK-LIGHT UNIT
LLamp Current
LLamp frequency
Note 1) Permanent damage to the device may occur if maximum values are exceeded
Functional operation should be restricted to the conditions described under normal operating conditions.
www.jxlcd.com
www.jxlcd.com
IN
DD
+ 0.3VDD-0.3V
(1)VV
(1)VV
Ta = 25 ± 2 °C
NoteUnitMax.Min.SymbolItem
(1)mArms7.02.0I
(1)kHz8040F
Samsung Secret
Doc.No. Rev.No
04-A00-G-070918
Page
/ 31LTN170X2-L02
6
Approval
2. OPTICAL CHARACTERISTICS
The following items are measured under stable conditions. The optical characteristics
should be measured in a dark room or equivalent state with the methods shown in Note (5).
Measuring equipment : TOPCON BM-5A and PR-650
* Ta = 25 ± 2 °C, VDD=3.3V, fv= 60Hz, fDCLK = 48.15MHz, IL = 6.5 mA
Contrast Ratio
(5 Points)
Response Time at Ta
( Rising + Falling )
Average Luminance
of White (5 Points)
Red
Color
Chromaticity
( CIE )
Green
www.jxlcd.com
Blue
www.jxlcd.com
White
CR
RT
L,AVE
Y
Unit
-
msec
-200175Y
Normal
X
Y
Y
Y
Viewing
Angle
φ = 0
θ = 0
0.6380.6080.578R
0.3770.3470.317R
0.3390.3090.279GX
0.5770.5470.517G
0.1820.1520.122BX
0.1550.1250.095B
0.3430.3130.283WX
0.3590.3290.299W
cd/m
-
2
NoteMaxTyp.Min.ConditionSymbolItem
(1), (2), (5)-500300
(1), (3)2516-T
I
L=6.5mA
(1), (4)
(1), (5)
PR-650
θ
L
Hor.
Viewing
Angle
13 Points
White Variation
Samsung Secret
Ver.
H
CR ≥ 10
L
L
Doc.No. Rev.No
4540
4540θ
2015φH
2520φ
04-A00-G-070918
Degrees
-
Page
(1), (5)
BM-5A
(6)1.7--δ
7
/ 31LTN170X2-L02
Note 1) Definition of Viewing Angle : Viewing angle range(10
Normal Line
o
φ = 0
,
θ = 0
θ L
φ L
L
=90
o
x
θ
φ H
≤ C/R)
o
θ R
Approval
12 O’clock
direction
y
φ
H
= 90
o
6 O’clock
direction
φ
Note 2) Definition of Contrast Ratio (CR) : Ratio of gray max (Gmax) ,gray min (Gmin)
at 5 points(4, 5, 7, 9, 10)
Points : , , , , at the figure of Note (6).
Note 3) Definition of Response time :
Display data
Optical
Response
o
= 90
L
CR(4) + CR(5) + CR(7) + CR(9) + CR(10)
CR =
4 9
www.jxlcd.com
www.jxlcd.com
100%
90%
10%
0%
5
White(TFT OFF) White(TFT OFF)
7
5
10
Black(TFT ON)
TR
x'y'
=90
θ
R
TF
o
Note 4) Definition of Average Luminance of White : measure the luminance of white at 5 points.
(360) ( 720) (1080)
5
L,AVE )
10
7
5
04-A00-G-070918
9
4
: test point
Average Luminance of White ( Y
Y
L4 + YL5 + YL7 + YL9 + YL10
YL,AVE =
Samsung Secret
Doc.No. Rev.No
Time
VIEW AREA
(225)
(450)
(675)
(lines)
Page
/ 31LTN170X2-L02
8
Approval
Note 5) After stabilizing and leaving the panel alone at a given te mperature for 30 min , the measurement
should be executed. Measurement should be executed in a stable, windless,and dark room.
30 min after lighting the backlight. This should be measured in the center of screen.
Lamp current : 6.5mA ( Inverter : SIC-130T )
Environment condition : Ta = 25 ± 2 °C
Photo-detector
( TOPCON BM-5A
PR-650 )
Field
= 2°
50 cm
TFT-LCD module
Center of the screen
[ Optical characteristics measurement setup ]
www.jxlcd.com
www.jxlcd.com
Note 6) Definition of 13 points white variation (δ L ), CR variation( CVER ) [ ~ ]
Maximum luminance of 13 points
δ L =
10mm
Minimum luminance of 13 points
10mm
360 720
13 12
10
1080
9
LCD panel
113
10mm
11
225
8
5
3
10mm
Samsung Secret
Doc.No. Rev.No
7
4
2
04-A00-G-070918
6
450
675
(lines)
1
: test point
Page
/ 31LTN170X2-L02
9
3. ELECTRICAL CHARACTERISTICS
3.1 TFT LCD MODULE
Approval
Ta= 25 ± 2°C
NoteUnitMax.Typ.Min.SymbolItem
DDVoltage of Power Supply
Differential Input
Voltage for LVDS
Receiver Threshold
White
Current of Power
Supply
Note (1) Display data pins and timing signal pins should be connected.( GND = 0V )
V = 60Hz, fDCLK = 48.15MHZ, VDD = 3.3V , DC Current.
(2) f
(3) Power dissipation pattern
www.jxlcd.com
www.jxlcd.com
*a) White Pattern *b) Mosaic Pattern
ILLow
HHsync Frequency
DCLKMain Frequency
RUSHRush Current
I
DD
V3.63.33.0V
V
CM = +1.2VmV+100--VIHHigh
mV---100V
Hz-60-fvVsync Frequency
KHz-54.72-f
MHz49.1548.1547.15f
(4)A1.5--I
(2),(3)*amA-710(2),(3)*bmA-720-Mosaic
(2),(3)*cmA900830-V. stripe
VIEW AREA
Samsung Secret
Doc.No. Rev.No
Display Brightest Gray Level
Display Darkest Gray Level
04-A00-G-070918
Page
10
/ 31LTN170X2-L02
Loading...