Samsung LTN160AT02-002 Datasheet

TO
DATE : : Oct. 06, 2008.

SAMSUNG TFT-LCD

SAMSUNG TFT-LCD

MODEL NO. : LTN160AT02

MODEL NO. : LTN160AT02

Approval

NOTE : Extension code [ -002 ]

www.jxlcd.com

www.jxlcd.com

Surface type [ Anti-Glare ]

Any Modification of Spec is not allowed without SEC’ permission

APPROVED BY :

PREPARED BY :

→ LTN160AT02-002

Application Engineering part.

Mobile Division

Samsung Secret

Doc.No. Rev.No

Samsung Electronics Co., Ltd.

04-A00-G-080804

Page

/ 30LTN160AT02

1

CONTENTS

Approval

Revision History
General Description

1. Absolute Maximum Ratings

1.1 Absolute Ratings of environment

1.2 Electrical Absolute Ratings

2. Optical Characteristics

3. Electrical Characteristics

3.1 TFT LCD Module

3.2 Backlight Unit

3.3 Inverter

4. Block Diagram

4.1 TFT LCD Module

4.2 Backlight Unit

4.3 Inverter Unit

5. Input Terminal Pin Assignment

5.1 Input Signal & Power

5.2 LVDS Interface

5.3 Backlight Unit

www.jxlcd.com

www.jxlcd.com

5.4 Timing Diagrams of LVDS For Transmitting

5.5 Input Signals, Basic Display Colors and Gray Scale of Each Color.

5.6 Pixel format

- - - - - - - - - - - - - - - - - - - ( 3 )

- - - - - - - - - - - - - - - - - - - ( 4 )

- - - - - - - - - - - - - - - - - - - ( 5 )

- - - - - - - - - - - - - - - - - - - ( 7 )

- - - - - - - - - - - - - - - - - - - ( 10 )

- - - - - - - - - - - - - - - - - - - ( 13 )

- - - - - - - - - - - - - - - - - - - ( 14 )

6. Interface Timing

6.1 Timing Parameters

6.2 Timing Diagrams of interface Signal

6.3 Power ON/OFF Sequence

7. Outline Dimension

8. Packing

9. Marking & Others

10. General Precaution

11. EDID

Samsung Secret

Doc.No. Rev.No

-- - - - - - - - - - - - - - - - - -- ( 19 )

-- - - - - - - - - - - - - - - - - - - ( 21 )

-- - - - - - - - - - - - - - - ---- -- ( 23 )

--- - - - - - - - - - - - - - - - -- - ( 24 )

--- - - - - - - - - - - - - - - - - - ( 26 )

--- - - - - - - - - - - - - - - - - - ( 28 )

04-A00-G-080804

Page

/ 30LTN160AT02

2

Approval

GENERAL DESCRIPTION

DESCRIPTION

LTN160AT02 is a color active matrix TFT (Thin Film Transistor) liquid crystal display
(LCD) that uses amorphous silicon TFT as switching devices. This model is composed
of a TFT LCD panel, a driver circuit and a backlight unit. The resolution of a 16.0" contains
1366 x 768 pixels and can display up to 262,144 colors. 6 O'clock direction is the
optimum viewing angle.

FEATURES

• High contrast ratio, high aperture structure

• 1366 x 768 pixels resolution (16:9)

• Color Gamut (Typical 45%)

• Low power consumption

• Fast Response Time

• Single CCFL

• DE(Data enable) only mode

• 3.3V LVDS Interface

• Onboard EEDID chip

• RoHS Compliance

APPLICATIONS

• Notebook PC

• If the usage of this product is not for PC application, but for others, please contact SEC

www.jxlcd.com

GENERAL INFORMATION

www.jxlcd.com

mm353.45 (H) x 198.72(V) ( 16.0” diagonal )Display area
a-Si TFT active matrixDriver element
262,144Display colors

RGB vertical stripePixel arrangement

mm0.25875 (H) x 0.25875 (V) (TYP.)Pixel pitch

NoteUnitSpecificationItem

16 : 9pixel1366 x 768Number of pixel

Normally whiteDisplay Mode
Haze 0, Hardness 3HSurface treatment

Samsung Secret

Doc.No. Rev.No

04-A00-G-080804

Page

/ 30LTN160AT02

3

Mechanical Information

Approval

Module

size

Note (1) Measurement condition of outline dimension

. Equipment : Vernier Calipers
. Push Force : 500g ⋅f (minimum)

1. ABSOLUTE MAXIMUM RATINGS

1.1 ENVIRONMENTAL ABSOLUTE RATINGS

Operating temperate

(Temperature of glass surface)

Max.

365.5

214.5

6.0

575

NoteUnitTyp.Min.Item

mm365.0364.5Horizontal (H)
mm214.0213.5Vertical (V)

(1)mm5.7-Depth (D)

g560-Weight

NoteUnitMax.Min.SymbolItem

(1),(5)°C60-20 TSTGStorage temperate

(1),(5)°C500TOPR

(2),(4)G240-SnopShock ( non-operating )

Note (1) Temperature and relative humidity range are shown in the figure below.

95 % RH Max. (40 °C ≥ Ta)
Maximum wet - bulb temperature at 39 OC or less. (Ta > 40 °C ) No condensation

www.jxlcd.com

www.jxlcd.com

100

-40 -20 0 20 40 60 80

Relative Humidity ( %RH)

90

80

60

40

20

Operating Range

Storage Range

5

0

( 40,90 )

( 50,50.4 )

( 60,27.7 )

Temperature (OC)

(2) 2ms, half sine wave, one time for ±X, ±Y, ± Z.
(3) 5 - 500 Hz, random vibration, 30min for X, Y, Z.
(4) At testing Vibration and Shock, the fixture in holding the Module to be tested have to be

hard and rigid enough so that the Module would not be twisted or bent by the fixture.

(5) If product is used for extended time excessively or exposed to high temperatures for extended time,

there is a possibility of wide viewing angle film damage which could affect visual characteristics.

(3),(4)G2.41-VnopVibration (non-operating)

Samsung Secret

Doc.No. Rev.No

04-A00-G-080804

Page

/ 30LTN160AT02

4

1.2 ELECTRICAL ABSOLUTE RATINGS

Approval

(1) TFT LCD MODULE

Power Supply Voltage

Logic Input Voltage

Note (1) Within Ta (25 ± 2 °C )

(2) BACK-LIGHT UNIT

Lamp Current

Lamp frequency

Note 1) Permanent damage to the device may occur if maximum values are exceeded

Functional operation should be restricted to the conditions described under normal operating conditions.

L

L

DD

IN

DD

DD

VDD=3.3V, V

+ 0.3VDD- 0.3V

+ 0.3VDD- 0.3V

SS

= GND = 0V

NoteUnitMax.Min.SymbolItem

(1)VV
(1)VV

Ta = 25 ± 2 °C

NoteUnitMax.Min.SymbolItem

(1)mArms7.03.0I
(1)kHz8050F

www.jxlcd.com

www.jxlcd.com

Samsung Secret

Doc.No. Rev.No

04-A00-G-080804

Page

/ 30LTN160AT02

5

Approval

2. OPTICAL CHARACTERISTICS

The following items are measured under stable conditions. The optical characteristics
should be measured in a dark room or equivalent state with the methods shown in Note (5).
Measuring equipment : TOPCON BM-5A and PR-650

Contrast Ratio

(5 Points)

Response Time at Ta

( Rising + Falling )

Average Luminance
of White (5 Points)

Red

Color

Chromaticity

( CIE )

Green

Blue

www.jxlcd.com

www.jxlcd.com

* Ta = 25 ± 2 °C, VDD=3.3V, fv= 60Hz, f

CR

RT

AVE

Normal

X

Y

X

Y

X

Y

Viewing

Angle

φ = 0
θ = 0

DCLK

= (72.33)MHz, IL= 6.0 mA

Unit

-

msec

2

-200175YL,

0.6200.5900.560R

0.3700.3400.310R

0.3600.3300.300G

0.5600.5300.500G

0.1850.1550.125B

0.1600.1300.100B

cd/m

-

NoteMaxTyp.Min.ConditionSymbolItem

(1), (2), (5)-400300

(1), (3)2516-T

IL=6.0mA

(1), (4)

(1), (5)

PR-650

Viewing

Angle

13 Points

White Variation

White

Hor.

Ver.

X

Y

θ

L

H

CR ≥ 10

H

L

L

0.3430.3130.283W

0.3590.3290.299W

-4540

-4540θ
Degrees

-2015φ

-4540φ

-

(1), (5)
BM-5A

(6)1.61.4-δ

Samsung Secret

Doc.No. Rev.No

04-A00-G-080804

Page

/ 30LTN160AT02

6

Note 1) Definition of Viewing Angle : Viewing angle range(10

Normal Line

o

φ = 0

,

θ = 0

θ

L

φ

H

θL =90

φ

o

x

L

≤≤≤≤

o

C/R)

θ

R

Approval

12 O’clock

y

direction

φH= 90

o

6 O’clock
direction

φL= 90

Note 2) Definition of Contrast Ratio (CR) : Ratio of gray max (Gmax) ,gray min (Gmin)

at 5 points(4, 5, 7, 9, 10)

Points : , , , , at the figure of Note (6).

Note 3) Definition of Response time :

Display data

Optical
Response

o

CR(4) + CR(5) + CR(7) + CR(9) + CR(10)

CR =

4 9

www.jxlcd.com

www.jxlcd.com

100%

90%

10%

0%

5

White(TFT OFF) White(TFT OFF)

7

5

10

Black(TFT ON)

T

R

x'y'

θR=90

T

F

o

Note 4) Definition of Average Luminance of White : measure the luminance of white at 5 points.

(342) ( 683) (1024)

Average Luminance of White ( Y

YL4+ YL5+ YL7+ YL9+ Y

Y

L,AVE

=

Samsung Secret

Doc.No. Rev.No

5

L,AVE

)

L10

10

9

7

5

4

: test point

04-A00-G-080804

Time

VIEW AREA

(192)

(384)

(576)

(lines)

Page

/ 30LTN160AT02

7

Approval

Note 5) After stabilizing and leaving the panel alone at a given temperature for 30 min , the measurement

should be executed. Measurement should be executed in a stable, windless,and dark room.
30 min after lighting the backlight. This should be measured in the center of screen.
Lamp current : 6.0mA ( Inverter : SIC-130T )
Environment condition : Ta = 25 ± 2 °C

Photo-detector

( TOPCON SR3 )

Field

= 2°

50 cm

TFT-LCD module

Center of the screen

[ Optical characteristics measurement setup ]

www.jxlcd.com

www.jxlcd.com

Note 6) Definition of 13 points white variation (

Maximum luminance of 13 points

δL=

Minimum luminance of 13 points

10mm

10mm

13 12

342 683

10

δ

L

), CR variation( C

1024

LCD panel

VER

) [ ~ ]

1 13

10mm

11

9

192

8

5

3

10mm

Samsung Secret

Doc.No. Rev.No

7

4

2

04-A00-G-080804

6

384

576

(lines)

1

: test point

Page

/ 30LTN160AT02

8

3. ELECTRICAL CHARACTERISTICS

3.1 TFT LCD MODULE

Approval

Ta= 25 ± 2°C

NoteUnitMax.Typ.Min.SymbolItem

Voltage of Power Supply

Differential Input

Voltage for LVDS

Receiver Threshold

Hsync Frequency

Main Frequency

Rush Current

Current of Power

Supply

Note (1) Display data pins and timing signal pins should be connected.( GND = 0V )

(2) fV= 60Hz, f
(3) Power dissipation pattern

www.jxlcd.com

www.jxlcd.com

*a) White Pattern *b) Mosaic Pattern

High

Low

White

DCLK

= 72.33 MHZ, VDD= 3.3V , DC Current.

DD

IH

IL

H

DCLK

RUSH

I

DD

V3.63.33.0V

V

CM

= +1.2VmV+100--V

mV---100V

Hz6560-fvVsync Frequency

KHz-47.4-f

MHz-72.33-f

(4)A1.5--I
(2),(3)*amA-450­(2),(3)*bmA-550-Mosaic

(2),(3)*cmA700600-V. stripe

VIEW AREA

Samsung Secret

Doc.No. Rev.No

Display Brightest Gray Level

Display Darkest Gray Level

04-A00-G-080804

Page

/ 30LTN160AT02

9